Question about 1995 Mercury Grand Marquis

1 Answer

Loud clunking when accelerating - 1995 Mercury Grand Marquis

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Mercury Master
  • 42,713 Answers

Do the obvious checks. Look for something loose in the trunk. next check things like loose diff pinion. see if you can push it up in the diff housing. check for rear engine mount rubber broken. Try to lift up the tranny. Next check for a broken engine mount on the left side of the engine.

Posted on Jan 10, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 rav 4 has a loud clunk when you back off in top gear


possibly the U joints are going out of the drive shaft .

Jul 07, 2015 | 1999 Toyota RAV4

1 Answer

Struts noise?


I would tend to believe it's more likely a worn sway bar bushing or link if it's a rattle or a small clunk, if it's a loud clunk probably a strut, try bouncing he back of the car when parked, if you get the clunk probably a strut if only when driving,turning,braking probably just a bushing on the sway bar

Jan 18, 2014 | Toyota Camry Cars & Trucks

1 Answer

Clunking/ticking noise during acceleration in 3rd and 4th gears


This sounds on the base of it to be pre ignition, if so the moment you take the foot off the gas it goes? The cure is to retard the ignition timing slightly, have you recently changed your octane of fuel? this will also cause this?
The noise is caused by the expansion of the compressed gases expanding before the piston reaches top dead centre causing the piston to \'rattle\' left unchecked will cause permanent damage and engine failure

Jan 16, 2013 | 2008 Volkswagen Rabbit

1 Answer

Loud clunking noise from yoyager when on full lock


Loud clunking noise WHERE in the Voyager when WHAT is "on full lock"? It might help to be a little more descriptive.

Knowing Chrysler minivans the way I do, I would assume that you are chasing noises in the front steering and suspension. Those are notorious for all kinds of noise in the front suspension. You need to check the stabilizer links, the stabilizer frame bushings and the upper strut bearings - these are the most common "noise-makers".

If it is making the noise when you have the wheels turned hard to one side and accelerating, then it is most likely a bad CV joint.

May 20, 2012 | 2000 Chrysler Grand Voyager

1 Answer

I have a 97 Ford Explorer that makes a loud clunking noise during acceleration...if I baby it it doesn't happen and it goes away after I've reached 50 or 60...only happens during acceleration


could be a rod bearing going bad.or could be bad gas causing it to spark knock realy bad. try to put some 93 octane in and see if it goes away.

Jan 03, 2011 | 1997 Ford Explorer AWD

1 Answer

Squeking sound and loud clunking sound when i accelerate the gas pedal. sounds like it's coming from the front driver side wheel.


not enough info for diagnosis, Try putting bar soap and check tension of fanbelts for squeaking noise of the belts as a cause. The clunk maybe worn or damaged suspension components, cv joints or even worn or broken motor mounts. Start with these items...

Oct 01, 2010 | 1991 Toyota Celica

3 Answers

Rear end


clunking or grinding noises, wont accelerate to full potential,

May 07, 2009 | 2001 Ford Ranger Regular Cab

1 Answer

Acura Integra '92 loud clunking when accelerating


you can check the wheels make sure there on tight and make sure you tie rods and wheel bearings are good

Dec 30, 2008 | 1992 Acura Integra Hatchback

Not finding what you are looking for?
1995 Mercury Grand Marquis Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

fordexpert

Level 3 Expert

5520 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...