Question about 2008 Hyundai Sonata

Open Question

When should I change my coolant for my 2008 hyundai sonata

What mileage or how often do I need to change the coolant?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 90 Answers

SOURCE: LOCATION OF IAT SENSOR

hi
it was internal sensor in the MAF sensor
the MAF is MASS AIRFLOW SENSOR
locate in the engine intake hose near the air filter .

with my best wishes

Posted on Jul 31, 2008

  • 393 Answers

SOURCE: replacing rear wheel bearings on 1999 hyundai sonata

  1. for drum brakes with sealed hub(all one piece) remove lug nuts and wheel.
  2. spray penetrating oil around studs if there is a big phillips head screw visible remove it with impact driver/if not use big ballpeen hammer ,tap on flat of drum near studs(becareful not to hit them) until drum loosens(your creating a shockwave to loosen rust)
  3. once drum is off there are 4-bolts coming in from behind backing plate, remove them then hub should be able to be removed w/a little persuation from hammer.
with out sealed hub ,
  1. remove wheel
  2. remove dust cap,cotterpin,star washer(if equipped) do not re use cotter pin
  3. remove nut then washer, wiggle brake drum and front bearing will come out.
  4. put nut on shaft tighten 2-3 turns grab drum by sides and pull towards you this should remove drum leaving inner bearing/seal on shaft
  5. to replace reverse procedure making sure to pack new bearings w/grease(take drum and use long punch to remove bearing races, use race/seal installer to install new races
with disk brakes

  1. remove wheel
  2. remove caliper/bracket
  3. remove rotor
  4. remove 4-bolts from behind,tap old hub out
  5. reverse procedure



Posted on Nov 15, 2008

defadad
  • 351 Answers

SOURCE: '05 Hyundai Sonata Coolant Change

remove the cap on the radiator or the header tank, use a plastic container that will hold about 4 ltrs of coolant, there should be a drain tap at the bottom of the radiator, if not you have to remove the hose clamp on the bottom hose and let the coolant drain out.
Replace the hose and clamp, top up the radiator and run the motor while checking the coolant level, if the level goes down a bit just top it back up and check over the next day.
hope this helps

Posted on May 19, 2009

SOURCE: Instructions for changing front brake pads - 2008

LIFT FRONT OF VEHICLE,REMOVE FRONT WHEELS,OPEN BONNET,SEE MASTER CYLINDER.REMOVE CAP,PUT RAG AROUND TO CATCH SPILLAGE,LOOSEN BOTTOM BOLT OF CALIPER PULL PUL TOWARDS YOU,USE TOOL TO PUSH PISTON BACK,FIT NEW PADS AND RE-ASSEMBLE

Posted on Jul 17, 2009

Jim1969pa3
  • 152 Answers

SOURCE: TPMS light on 08 hyundai sonata

You might check to see that the tire pressure is correct on all of your tires. Advance auto parts has a scanner they will loan you to clear this code yourself.

Posted on Dec 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Changed coolant fan still not working


Quit throwing money away at good parts. It's not the sensor. Have the codes read. Auto parts stores will read them for free. Check fuses..

Mar 05, 2016 | 2008 Hyundai Sonata

1 Answer

What kind of wrench do u need to Get the two bolts out that holds the switch in for a 2008 hyundai sonata


You need a 2008 Hyundai Sonata switch Wrench.

But seriously, all joking aside...
If you would like somebody here on this forum to assist you, please provide more specific details. Like - what switch are you talking about?

Apr 01, 2015 | 2008 Hyundai Sonata

1 Answer

Would it be okay if I mixed green anti-freeze with red anti-freeze in a 2008 Hyundai Sonata


You have two options. A ..drain coolant, flush your system, add pr oper coolant or b...buy universal coolant and add it. Its preferred that if you don't buy premixed coolant, use distilled wate r to mix with it.

Aug 11, 2014 | 2008 Hyundai Sonata

1 Answer

When should trans fluid be changed in 2008 hyundai sonata?


Hyundai recomend the auto trabsmition fluid be changed at 60000 miles or 72 months wichever is soonest

Jun 10, 2010 | 2009 Hyundai Sonata

1 Answer

At what mileage do spark plugs in 2006 hyundai sonata need to be changed?


Typically at 100k miles. If the car is used for mostly city driving and in severe climate area's it may be necessary to change them as early as 60k. Make sure to use OEM plugs. Also dont forget to change the spark plug wires, they wear out too!

Mar 16, 2010 | 2006 Hyundai Sonata

1 Answer

Instructions for changing front brake pads - 2008 Hyundai Sonata


LIFT FRONT OF VEHICLE,REMOVE FRONT WHEELS,OPEN BONNET,SEE MASTER CYLINDER.REMOVE CAP,PUT RAG AROUND TO CATCH SPILLAGE,LOOSEN BOTTOM BOLT OF CALIPER PULL PUL TOWARDS YOU,USE TOOL TO PUSH PISTON BACK,FIT NEW PADS AND RE-ASSEMBLE

Jul 05, 2009 | 2008 Hyundai Sonata

1 Answer

Changing the coolant in '05 Hyundai Sonata


On newer cars you need to have the coolant exchanged with a machine. Make sure to use a rep. shop like Sears or your dealer. Putting the right ammount of coolant and the right type is very important!! The days of taking the lower hose off are all but gone.

May 19, 2009 | 2005 Hyundai Sonata

1 Answer

'05 Hyundai Sonata Coolant Change


remove the cap on the radiator or the header tank, use a plastic container that will hold about 4 ltrs of coolant, there should be a drain tap at the bottom of the radiator, if not you have to remove the hose clamp on the bottom hose and let the coolant drain out.
Replace the hose and clamp, top up the radiator and run the motor while checking the coolant level, if the level goes down a bit just top it back up and check over the next day.
hope this helps

May 19, 2009 | 1999 Hyundai Accent

1 Answer

Towing wires


Here is a Utube video for you for the wire hookups! http://www.wonderhowto.com/how-to/video/how-to-install-a-trailer-wiring-harness-on-a-hyundai-sonata-164439/

May 10, 2009 | 2008 Hyundai Sonata

1 Answer

Where is the engine number of the 2008 hyundai sonata located?


did you check the front passenger door. the no. on my Hyundai Matrix is located inside the f ron passenger door right on the top right corner. its worth a try

Jan 02, 2009 | 2008 Hyundai Sonata

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...