Question about 1998 Ford Mustang

Open Question

2002 mustang orifice tube location please - 1998 Ford Mustang

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: AC 2002 Ford Taurus SE

I believe the orifice tube on this model requires the a/c pipe to be cut to install a new tube. You need to discharge the system, replace the tube, then evacuate miosture with a vacuum pump, then recharge with R134A refirgerant. Not a job for a non technical person.

The oriifce is in the line just before the evaporator that is in your car a/c heater case. It is where the liquid refrigerant turns into a vapor as it comes out of the orifice and then it absorbs heat from the air going into you car, thus blowing cold air. Moisutre in the warm air condenses and as he iar gets cold and it drains out of your evaporator and out the drain & onto the ground

Posted on Jul 01, 2008

Ad
  • 23 Answers

SOURCE: location of orifice tube in 2004 ford taurus

orfice should be located on the accumulator, where the large line connects.

Posted on Oct 03, 2008

  • 93 Answers

SOURCE: Where, exactly, is the orifice tube located on my truck?

the orfice tube is locate in the line between condenser and evaporator. near the spring lock coupling. you must unbolt the cruise servo and overflow bottle, reposition them out of way and you will see the line connection..the orfice is inside line near that uniion. the ac system must be evacuated prior to removal, and recharged afterwards..

Posted on Jun 04, 2009

harley9701ha
  • 424 Answers

SOURCE: 2002 Ford Expedition Eddie Bauer 5.4l Dual A/C

There is one orifice tube for the font air. It is located in the a/c line coming from the condenser to the evap. core. the rear a/c has and expansion valve attached to the rear evap. core. Hope this helps.

Posted on Oct 08, 2009

emissionwiz
  • 76691 Answers

SOURCE: How do I change the orifice tube on a 1998 Ford

THE SMALLER LINE GOES TO THE EVAPORATOR, i HAVE CHECKED WITH MY FRIEND AT FORD ON THIS PROBLEM AND HE SAID U HAVE TO REPLACE THE SMALLER AC LINE (HI PRESSURE LINE, THE ORIFICE TUBE IS PART OF THE HIGH PRESSURE LINE, HERE IS THE PART NUMBER FROM A SITE CALLED ROCKAUTO.COM
MOTORCRAFT Part # YF2227 {#F6ZH19N651AD, F6ZZ19835A}
factory installed AC High pressure refridgerant line.


17ad533.jpg

Posted on Jun 04, 2010

Testimonial: "Great help!!!!!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Orifice tube location on 2002 silhouette


The orifice tube is always located on the inlet to the high pressure side of the evaporator coil

Sep 09, 2017 | Cars & Trucks

1 Answer

Can the orifice tube on a 2002 mustang be repaired with kit


You do not cut & splice into any A/C System

You replace with the oe type parts only when
they fail/leak

The orifice is a screen inside the hose connection
& can be cleaned,not necessary to always replace

Jan 09, 2013 | Cars & Trucks

1 Answer

Where is the orifice tube located on a 2002 chevy cavalier?


The orifice tube is located inside the tubing leading to the evaporator -- this picture will probably help.
2_11_2012_1_39_44_am.png

Feb 10, 2012 | 2002 Chevrolet Cavalier Coupe

1 Answer

We are trying to either get a diagram for an 2002 chevy impalas ac system,or the location of the orifice tube.please help.


It is located inside the condensor tube running to the evaporator.

Here are the removal/installation instructions as per alldata:

TOOLS REQUIRED

J 39400-A Halogen Leak Detector
J 26549-E Orifice Tube Remover

REMOVAL PROCEDURE
-Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
-Remove the air cleaner assembly.
-Remove the vacuum brake booster.
-Remove the condenser tube.
-Use J 26549-E in order to remove the expansion orifice tube. IMPORTANT: DO NOT use any solvents or chemicals to clean the porous plastic inlet filter of the expansion orifice tube.
-Inspect the expansion orifice tube for the following conditions and clean or replace with a new tube as indicated:
-Broken plastic frame (1); replace the tube.
Inlet filter (3) damaged or plugged with fine gritty material; replace the tube.
Inlet filter (3) coated with metal chips, flakes, or slivers; remove the coating with low pressure shop air ONLY and reuse if the filter is cleaned satisfactorily. Do NOT reuse the O-ring seals (2).

INSTALLATION PROCEDURE

IMPORTANT: Lubricate the new O-ring seals (2) with mineral base 525 viscosity refrigerant oil.
If you reuse the orifice tube, install new O-ring seals (2).
Carefully grasp the edge of the expansion orifice tube (1) without touching the inlet filter (3) and insert the expansion tube into the condenser tube until fully seated.
-Install the condenser tube.
-Install the vacuum brake booster.
-Install the air cleaner assembly.
-Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
-Leak test the fittings of the component using J 39400-A.

Aug 20, 2010 | 2002 Chevrolet Impala

2 Answers

2002 ford mustang ac will not come on. Problem is intermittent. I have checked the low and high pressure switches and fuses. what else is there to check?


When the ac acts up,test voltage at the ac clutch,if there is voltage(12 volts to 14)then the clutch is the problem,also,try and wiggle the low pressure switch ,to see if it tries to come back on,,,have some one put some ac gauges on the ac system and let the ac run,and watch to see if the low side falls down to 25 psi or lower,if it does,then the orifice tube is stopping up.If this was at all helpful,please rate,thank you.

Jul 19, 2010 | 2002 Ford Mustang

2 Answers

Orifice tube 1998 mustang


did you find the location? Let me know one way or another so if I can help anymore ,I will

Jun 04, 2010 | 1998 Ford Mustang

2 Answers

How do I change the orifice tube on a 1998 Ford Mustang base model?


THE SMALLER LINE GOES TO THE EVAPORATOR, i HAVE CHECKED WITH MY FRIEND AT FORD ON THIS PROBLEM AND HE SAID U HAVE TO REPLACE THE SMALLER AC LINE (HI PRESSURE LINE, THE ORIFICE TUBE IS PART OF THE HIGH PRESSURE LINE, HERE IS THE PART NUMBER FROM A SITE CALLED ROCKAUTO.COM
MOTORCRAFT Part # YF2227 {#F6ZH19N651AD, F6ZZ19835A}
factory installed AC High pressure refridgerant line.


17ad533.jpg

Jun 04, 2010 | 1998 Ford Mustang

2 Answers

Location of orifice tube,2002 ford taurus sel


location of orifice tube/2002 taurus

May 14, 2010 | 2002 Ford Taurus

1 Answer

2002 Ford Expedition Eddie Bauer 5.4l Dual A/C Are there 2 orifice tubes in the split unit? Where are they located? Is there a diagram available showing the tubes in the system?


There is one orifice tube for the font air. It is located in the a/c line coming from the condenser to the evap. core. the rear a/c has and expansion valve attached to the rear evap. core. Hope this helps.

Oct 07, 2009 | 2002 Ford Expedition

2 Answers

Where is the orifice tube in a 1994 mustang


The A/C evaporator core orifice is located in the condenser to evaporator tube

Oct 07, 2009 | 1994 Ford Mustang

Not finding what you are looking for?
1998 Ford Mustang Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...