Question about Cars & Trucks

1 Answer

When the car runs it try to die or stop at a stop sigh and I change the sparks plug and mass air sensor on a 92 cutlass cirea with a 3300 engie

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 21,873 Answers

The O2 sensors are in the exhaust pipes.
The problem could be a vac leak, or a dirty idle air control valve.

Posted on Jan 10, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 422 Answers

SOURCE: I have a 1999 oldsmobile

fuel pressure regulator on the fuel rail is probably it or the egr valve is stuck open allowing burnt fuel to flood the intake, im leaning towards the fuel pressure regulator because the o2sensor is probably reading rich or if its reading lean then i would choose the egr valve . good luck

Posted on Aug 26, 2008

  • 32 Answers

SOURCE: My Subaru?

I would say that the sensor may be bad the only other thing that i can think of is that the PCM lost its idle settings. then it is trying to relearn the idle setting and adjusting for the air sensor and/or the O2 sensor.

Posted on Oct 11, 2008

  • 6982 Answers

SOURCE: Mass Air Flow Sensor - 92 Buick Century

Remove it and clean with some carb cleaner and a Q tip. Be careful with it so you don't do any damage. 9 of 10 times this will get you running again! Since signal from there is variable low voltage, you cant really bypass it!

Posted on Feb 16, 2009

  • 10 Answers

SOURCE: i have 1991 Oldsmobile cutlass Ciera had oil

Bad connection at spark plug and wires or coil pack. Possible a plug got cracked on the install. Possibly the wires were installed incorrectly.

Posted on Aug 05, 2009

roniecon
  • 6826 Answers

SOURCE: Car started hesitating then died

replace the fuel filter,if this does not help,replace the fuel pump.

Posted on Mar 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 92 bonnevile it cut off 15 minutes of driving I change the coil pack throttle position sensor upstream o2 sensor tune up camshaft sensor mass air flow sensor math sensor it is still cuts off


Are you loosing spark to the plugs or fuel to the injectors when the engine stops ? You have to know which system to troubleshoot the problem.

May 09, 2013 | Cars & Trucks

1 Answer

1991 Cutlass ceirra 3300 ,runs fine for short time. starts running rough,then dies/will not start again.changed fuel filter, then tested fuel pump.fuel pressure is good.what next ?


Check for spark when it won't start. If you have spark, might be your fuel pump relay, maybe the map sensor. If no spark, check another or all plug wires. If ignition isn't working, it could be Crankshaft Position sensor, Camshaft position sensor (or pick-up coil), ignition control module, coils, pcm, or the wiring associated with them. PCM determines spark timing after inputs from crank and can sensors, and sends ground signal to ignition module, cutting primary voltage to coils, initiating spark or high voltage from coil to sparkplug. All these parts have to be working right for ignition. All can be tested too. You'd need a digital volt ohm meter (DVOM) and a repair manual for your car with the test procedures. That Mitchell alldata-diy site has a special on subscriptions, pretty reasonable for a 1 month subscription, and excellent info and troubleshooting flow charts, wiring diagrams, etc.

Dec 26, 2012 | 1990 Oldsmobile Cutlass Ciera

1 Answer

Missing when you first crank it. 92 Ford Ranger 2.3


do a compression test on all cylinders, check all 4 spark plugs.

Oct 01, 2012 | Cars & Trucks

3 Answers

My 1990 toyota camry has been running poor. It seems to be missing and jumps and jerks. Off the line it just crawls until it hits 3,000 RPM then it runs fine. I have to downshift on any hill because it...


The mass air flow often goes bad on them. Did you have the vehicle scanned. Try unplugging the mass air flow and driving it. It is built into the air intake hose. If that does not change things, check the fuel pressure, and the throttle position sensor.

Hope this helped

Nov 21, 2009 | 1990 Toyota Camry

2 Answers

1988 3.8 olds cutlass Ciera stalls, no spark until it cools down


Check the prrimary and secondary resistance on your coil. Also check the resistance of the plug wires and plug gap.

Aug 12, 2009 | 1988 Oldsmobile Cutlass Ciera

1 Answer

Car wont start


Check Your Mass Airflow Sensor.

May 24, 2008 | 1996 Oldsmobile Cutlass Ciera

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...