Question about 1998 Plymouth Voyager

2 Answers

Where is the voltage regulator located on a 1998 plymouth voyager?

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 429 Answers

In the alternator

Posted on Jan 10, 2013

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Plymouth Master
  • 21,873 Answers

The computer controls voltage.

Posted on Jan 10, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: WHERE IS THE WATER PUMP LOCATED ON A 1998 PLYMOUTH GRAND VOYAGER

Here are the steps required to change the water pump on the 3.0L engine.

  1. Disconnect the negative battery cable.
  2. Drain the cooling system.
  3. Remove the drive belts. Remove the timing belt covers and the timing belt.
  4. Remove the water pump mounting bolts.
  5. Separate the water pump from the water inlet pipe and remove the water pump.
  6. Inspect the water pump and replace as necessary.
To install:
  1. Clean all gasket and O-ring surfaces on the water pump and water pipe inlet tube.
  2. Wet a new O-ring with water and install it on the water inlet pipe.
  3. Install a new gasket on the water pump.
  1. Install the pump inlet opening over the water pipe and press until the pipe is completely inserted into the pump housing.
  2. Install the water pump-to-block mounting bolts and tighten to 20 ft. lbs. (27 Nm).
  3. Install the timing belt and timing belt covers. Install and adjust the drive belts.
  4. Reconnect the negative battery cable. Fill the cooling system to the proper level with a 50/50 mixture of clean, ethylene glycol antifreeze and water.
  5. Run the engine and check for leaks. Top off the coolant level, if necessary.
34bef4a.jpg

Posted on Jan 20, 2009

motor1258
  • 6674 Answers

SOURCE: 1998 plymouth grand voyager cruise control relay/fuse location?

Check under hood in box marked fuses & relay, on drivers side and look under cover of it for I.D.

Posted on Apr 11, 2009

seans46
  • 161 Answers

SOURCE: i have a 1998 plymouth voyager and the insturment panel and gauges and wipers and locks stopped working how could this be fixed

you have to replace the " body control module " located under dash drivers side. and most of time they have to be reprogrammend unless you buy it new from dealer and they do it before you get it. the body control mod controls all those items and go bad alot.

Posted on May 25, 2009

motor1258
  • 6674 Answers

SOURCE: where's the crankshaft position sensor located in 98 plymouth voy

Guessing it's a 6 cyl, 3.0L, but should be located on transaxle housing above vehicle speed sensor.c937fe4.jpg

Posted on Sep 08, 2009

wracefans24
  • 1985 Answers

SOURCE: replace blower motor 1998 plymouth voyager

it is located behind and below the glove box,you might want to remove the glove box assembly to see it easier,
there are four screws holding a blower motor cover you to take off first,now remove the screws holding the blower motor up,disconnect the motor wires.
if your changing this because you think its bad,you should test the blower motor wires with a test light with the key on and blower switch turned on.if you have power in the wires,then it is bad.
but if you have no power in wires it could be blower motor resister,or switch.

Posted on Dec 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Low voltage check gages


88 Plymouth Voyager had a voltage regulator built into the power control module... PCM... these go bad and to rectify this issue you have two choices... buy a new PCM or take your vehicle to a specialty alternator/starter shop (a GOOD one) and have the voltage regulator built back into the system... there is a kit for this... can you do it. maybe

Nov 02, 2014 | 1988 Plymouth Grand Voyager

1 Answer

Ignition system wiring, voltage, regulator how to repair


Hello, again, again Bridget. First I sent you explanation of the ignition system and I gave you my best guess---ignition module on your 1994 Plymouth with V6 3.4 L engine.

As far as voltage regulation goes there isn't any external devise to do this. This voltage voltage regulation take place inside the alternator after the three phase AC voltage is turn into none regulated DC voltage. Now this DC voltage goes thru a voltage regulator that built into the alternator where the output DC voltage is 13.8 to 14.1 DC Volts. Now, the alternator is regulated for current by the it wire windings in the alternator. Larger the copper wire the more current the alternator will produce. GB.....stewbison

Oct 17, 2011 | 1994 Plymouth Voyager

1 Answer

Where is the regulator located in the 1987 plymouth voyager?


The voltage regulator for the alternator,will be on the fire wall,or the fender well,if it is not built into the alternator.

Jul 12, 2010 | 1987 Plymouth Voyager

1 Answer

Location of voltage regulator 1990


The voltage regulator is internal in the engine computer.

Apr 11, 2010 | 1990 Plymouth Grand Voyager

1 Answer

Drains batterie


Have you checked your voltage regulator? That could be the problem. How did you check your alternator?

Apr 08, 2010 | 1998 Plymouth Voyager

2 Answers

Overcharging alternator is killing my battery. is the voltage regulator in the computer? 1992 plymouth grand voyager 3.3 v6


This year it is not supposed to be in the computer,look on the firewall in the middle,I believe it is flat,and has a three wire connector,but only two wires in the plug,see if you can find it.

Feb 26, 2010 | 1992 Plymouth Grand Voyager

1 Answer

Where is the starter located on a 1998 plymouth voyager?


The Starter is located on the front of the engine, just right of center (looking from the front) between the oil filter and the transmission bell housing.

Dec 30, 2009 | 1998 Plymouth Voyager

2 Answers

Where's the crankshaft position sensor located in 98 plymouth voy


Guessing it's a 6 cyl, 3.0L, but should be located on transaxle housing above vehicle speed sensor.c937fe4.jpg

Aug 31, 2009 | 1998 Plymouth Voyager

1 Answer

1998 plymouth grand voyager cruise control relay/fuse location?


Check under hood in box marked fuses & relay, on drivers side and look under cover of it for I.D.

Apr 10, 2009 | 1998 Plymouth Grand Voyager

Not finding what you are looking for?
1998 Plymouth Voyager Logo

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...