Question about 2000 Ford Windstar

Open Question

Idling problems with a 2000 ford windstar

Replaced the idle air control valve and it still runs rough and tries to surge forward when the brake is fully applied. I put the van in neutral and the idle fluctuates rapidly. it does not stall out anymore though :)

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 6 Answers

SOURCE: Idles bad

Sounds like you may have an upper intake manifold leak. Typically the gasket between the Plenum and the lower intake dries up and gets sucked into the intake a little causing a leak and a high idle issue. The repair requires the removal of the plenum and replacement of the gasket. NOTE: there is a torx bolt hidden between the center plenum runners and can only be seen by looking straight down at the top of the plenum and it may be covered in dirt. If you have to use a bar to pry off the plenum you probably have missed a bolt. Typically it is the one noted above. Best of luck.

Posted on Mar 22, 2009

Ad
  • 35 Answers

SOURCE: Rough Idle 2000 ford Taurus OHV

This could be a bad a/c compressor or compressor pulley bearing.Try removing the serpentine belt and turning the compressor by itself.The bearing should turn very easily,and the compressor itself should turn.If it is vety hard to turn,it is bad.

Posted on Sep 25, 2008

  • 5 Answers

SOURCE: surging while idling in gear...2001 Ford Windstar

check the swiches at the brake pedal their should be two. one for brake lights and one for transmission dump valve it prevents the engine from loading up at lower rpm. ie stoping at lights while in drive

Posted on Apr 03, 2009

seanpwright
  • 2030 Answers

SOURCE: 1997 Ford Contour with a rough idle while stopped

This is a common complaint on these cars. I own a 96 myself.
Assuming that you engine is fine and runs smoothly under normal operation, and just is rough "feeling" at idle while stopped; then I would suggest changing the motor mounts...the mounts may not be broken, but the rubber isolators get worn and soft, and transffer normal engine vibration into the chasis of the vehicle. Mine was doing the same after changing the mounts good as new again.
Please note...don't use cheap mounts, by the better grade/quality mounts.

Posted on Aug 27, 2009

dncholas
  • 222 Answers

SOURCE: 1990 Ford Probe 2.2 automatic stalls in forward, reverse OK

Sounds like a bad IAC (idle air control valve/sensor) that controls your idle when going from throttle to idle. If bad your idle will act crazy and can cause stalls easily. Pretty sure that's it.

Posted on Aug 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car idols rough no power


Mar 03, 2012 | 1999 Suzuki Esteem

2 Answers

I have 1999Chevy suburban with 6.5 turbo diesel motor.it idles up and down and when driving the gas pedal is real touchy Wat is the problem and were do i locate the problem


Check the help links related to this problem.Click the link below to go through its troubleshooting procedure :-----Idles rough and quits when gas pedal is pressed less? http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html---------
Car won't start without hitting the gas pedal? http://schematicsdiagram.blogspot.com/2011/12/car-wont-start-without-hitting-gas.html
-------Complete loss of brake pedal then all gets normal? http://repairhelpcenter.blogspot.com/2012/01/complete-loss-of-brake-pedal-then-all.html
------Car dies when gas pedal is pressed? http://schematicsdiagram.blogspot.com/2011/12/car-dies-when-gas-pedal-is-pressed.html
--------Pushing on the gas pedal, but the car slows down? Gas pedal to the floor and the car slows down?

http://technoanswers.blogspot.in/2012/02/pushing-on-gas-pedal-but-car-slows-down.html

---------

After replacing brake rotors and pads, brake pedal remains on floor? http://technoanswers.blogspot.in/2012/02/after-replacing-brake-rotors-and-pads.html

---------

accelerator pedal sensor? http://technoanswers.blogspot.in/2012/02/2009-chevy-impala-accelerator-pedal.html

-------

For rough idle issues and problem troubleshooting,go through the help links provided below :----- van idles rough?

http://howtobyme.blogspot.in/2012/01/2004-ford-freestar-van-idles-rough.html

---------
will not idle when cold?

http://technoanswers.blogspot.in/2012/02/ford-explorer-40-will-not-idle-when.html

----------
runs lean and idles rough?

http://technoanswers.blogspot.in/2012/02/ford-runs-lean-and-idles-rough.html

-----------
Engine stumbles coming off idle when warm?

http://repairhelpcenter.blogspot.com/2012/01/engine-stumbles-coming-off-idle-when.html

------------
Erratic idle on car?

http://schematicsdiagram.blogspot.com/2011/12/erratic-idle-on-car.html

----------
Low idle when cold out side?

http://repairhelpcenter.blogspot.com/2011/12/low-idle-when-cold-out-side.html

---------
Idle Air Control (IAC) Valve Replacing?

http://schematicsdiagram.blogspot.com/2011/12/gmc-idle-air-control-iac-valve.html

----------
Engine quits at idle?

http://repairhelpcenter.blogspot.com/2011/10/engine-quits-at-idle.html

------------
Car overheats and Air blows hot at idle?

http://howtobyme.blogspot.com/2011/11/car-overheats-and-air-blows-hot-at-idle.html

------
While stop engine idles like cylinder missing?

http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html

---------

This will help.

Thanks.

Mar 01, 2012 | 1999 GMC Suburban

1 Answer

High idle on cold start on a 86 dodge d50 2.0 liter


Feb 27, 2012 | 1986 Dodge Pickup 4WD

1 Answer

98 dodge ram 1500 5.2 the truck will start but it will not idle.


Feb 21, 2012 | 1998 Dodge Ram 1500 4WD

1 Answer

2000 focus rough/surging idle tried sensors vaccuum leak ?


(Idle Air Control) IAC Motor is bad or dirty. Clean or replace should fix your problem

Mar 15, 2011 | 2000 Ford Focus

1 Answer

My 2000 taurus surges acts like a vacuum leak i was told it might be the idle air control


I would check your vacuum hoses also.To check for vacuum leaks on hoses, etc:, while the motor is running, spray "non-flammable" brake cleaner on hoses, if rough engine idle perks up, you have found your culprit.

Mar 17, 2010 | 2000 Ford Taurus

3 Answers

FORD WINDSTAR 3.8 V6 ENGINE IDLE ROUGH UP AND DOWN WHEN STANDING


Usually the fuel pressure regulator vac. hose pops off? If not listen for a slight whistling noise (vac leak).

Apr 23, 2009 | 1995 Ford Windstar

1 Answer

Surging while idling in gear...2001 Ford Windstar


check the swiches at the brake pedal their should be two. one for brake lights and one for transmission dump valve it prevents the engine from loading up at lower rpm. ie stoping at lights while in drive

Apr 03, 2009 | 2001 Ford Windstar

1 Answer

1990 Ford Probe 2.2 automatic stalls in forward, reverse OK


Sounds like a bad IAC (idle air control valve/sensor) that controls your idle when going from throttle to idle. If bad your idle will act crazy and can cause stalls easily. Pretty sure that's it.

Dec 20, 2008 | 1993 Ford Probe

Not finding what you are looking for?
2000 Ford Windstar Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...