Question about Cars & Trucks

Open Question

Where to find blower motor resistor 2006 kenworth t800

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 479 Answers

SOURCE: blower motor resistor replacement

the relays are behind the glove box. you have to take the glove box out to have access to the relay for the heating system 

Posted on Dec 10, 2008

Ad
  • 1 Answer

SOURCE: locating heater blower motor resistor

the resistor is behind your glove box. open the box and push in the sides to release it and let it hang down...the resistor is right there. I didn't try to replace it, a friend did it, but the part was under $20.

Posted on Feb 01, 2009

jturcotte
  • 8269 Answers

SOURCE: I have a 2006 Dodge Ram diesel. Can you tell me

It's right next to the blower, above the passenger's feet. See pic below.


jturcotte_37.jpg

  1. Disconnect and isolate the negative battery cable.
  2. Reach under the instrument panel near the blower motor and disconnect the wire harness connector from the blower motor resistor.
  3. Remove the two screws that secure the blower motor resistor to the HVAC housing.
  4. Remove the blower motor resistor from the HVAC housing.

Posted on Nov 30, 2010

pittmanc
  • 194 Answers

SOURCE: where is the heater blower motor resistor located

if you locate the blower motor the rester is the wire that atachec to blower motor fallow wire till you find a circuit bord this is ur resistor

Posted on Dec 06, 2008

chuck943
  • 783 Answers

SOURCE: 2006 Ford Explorer XLT the Blower Fan only works on 4 and 3 Sp

Look under the dash on passenger side and just to the left of the blower motor housing you will see the 4WD control module.Remove the 2 screws holding the module and let it hang down and your resistors are behind this.Remove the 2 screws holding the resistors and remove.
Now I am assuming you have manual climate control and not electonic.

Posted on Feb 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of heater blower motor resistor on a 2007 Kenworth t300


Check the heater box it should be held in behind a flat plate held in by 2 screws.

Jan 26, 2017 | Cars & Trucks

1 Answer

Location of blower motor in 1987 t600 kw


Search Results Blower Motor (HVAC) on HeavyTruckParts.Net

https://www.heavytruckparts.net/search.php?qsearch...KENWORTH
$350.00 1993 KENWORTH T600 Blower Motor (HVAC) .... Plastic; Blower Wheel, OEM# 589540 Peterbilt, 2000 1987, All w/Bergstrom A/C 4-1/2? Dia. (CCW) ...

Search Results Kenworth T600 Blower Motor (HVAC) on ...

https://www.heavytruckparts.net/search.php?...Kenworth...T600...
Search Results for Kenworth T600 Blower Motor (HVAC) on HeavyTruckParts.Net. Easily find what you need from thousands of parts available. HTP.net has ...

Viewing a thread - Kenworth cab fan - AgTalk Home

talk.newagtalk.com/forums/thread-view.asp?tid=447803...flat...1

Jan 21, 2014 - 9 posts - ‎9 authors

Feb 03, 2016 | Cars & Trucks

1 Answer

How do I reset my check engine light on my 1997 T600 Kenworth


2010 KW T800 How to reset engine check light ' TruckersReport.com ...

www.thetruckersreport.com > ... > Kenworth Forum
Nov 8, 2011 - Is there a way to reset Engine Check Light without going to dealer? ... Inmy case it was 3725. If I run with ... 2013 Kenworth Dash panel removal.Missing: 1997 ‎t600

DIY: Reset Check Engine Light without OBDII reader ...

? 3:31
https://www.youtube.com/watch?v=TvBcdjLkBhU
Jul 1, 2014 - Uploaded by Christian Macias
Learn how to reset your Check Engine Light (CEL) without using an OBD II 2 scanner / reader tool. ... Year ...

Nov 19, 2015 | Cars & Trucks

1 Answer

Where do I find the blower motor resistor on a 2006 kia sportage?


Hi Kathy,here's a link to where your blower motor is,in the pic,the dark part is your blower motor resistor,just remove electrical connector and 2 screws holding it on,very easy. Repair Guides Blower Motor Removal Installation AutoZone com Here's a pic of your resistor. Blower Motor Resistor at AutoZone com Best Blower Motor Resistor Parts for... Don't disconnect your negative battery terminal,will cause problems.

Jul 25, 2015 | 2006 Kia Sportage

2 Answers

A t600 kenworth 2000 model the blower motor only blows on high is it the resister


Yes - you diagnosed the problem yourself. The classic symptom of a heater that only blows on the "High" setting is a burned out/damaged or otherwise inoperative blower resistor.
Replacing the resistor should return the two missing blower fan speeds.

Dec 05, 2011 | Cars & Trucks

1 Answer

I have a 2006 Dodge Ram diesel. Can you tell me where the resistor for the blower motor is located ?


It's right next to the blower, above the passenger's feet. See pic below.


jturcotte_37.jpg
  1. Disconnect and isolate the negative battery cable.
  2. Reach under the instrument panel near the blower motor and disconnect the wire harness connector from the blower motor resistor.
  3. Remove the two screws that secure the blower motor resistor to the HVAC housing.
  4. Remove the blower motor resistor from the HVAC housing.

Nov 30, 2010 | 2006 Dodge Ram 2500

1 Answer

2006 chevrolet silverado all fan switch works but 5th which is high?


Check blower motor resistor sit next to blower blower housing, will have a seven wire plug going into it, and two wire's coming out red & black that go to blower motor, remove resistor and check voltage at little resistor on back of blower resistor, if no voltage going across while you have it on high, bad resistor. Hope this helped.

Nov 25, 2009 | 2006 Chevrolet Silverado 1500 2WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

2,964 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...