Question about Ford F-350

Open Question

Change oil filter on ford courier 2003

How do you reach oil filter

Posted by Anonymous on


5 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Mr BrokRench
  • 1623 Answers

SOURCE: fuel filter

Can you hear the fuel pump run when you turn the key on?
Turn the ignition switch on/off five times to pressurize system.
The pump should humm a few seconds then cut off. Check the fuel pressure regulator? Remove or loosen the fuel line and see if you are getting fuel to and through the new filter. If your vehicle was running before you replaced the filter you shouldnt have to bleed any air out of it.
Good luck...i hope this helps..please rate me a fixya.

Posted on Jul 28, 2009

  • 11 Answers

SOURCE: i have a 2003 ford f350 turbo diesel recently it

Is this a 6.0L or a 7.3 L?

Posted on Nov 16, 2009

  • 5687 Answers

SOURCE: 2003 ford f-250 7.3L Diesel. 157,000mileage. Just

Have someone retime the engine. In a diesel it means to time the injection pump. You may have wear in the timing chain or gears. But the fuel ratio can be made rich or lean by when the fuel hits the cylinder.

Try that first as it is cheaper. You can have worn injectors and adding a cleaner will make the fuel run through faster. Possibly spray a little better, but it will not make the fuel nozzles any tighter.

Posted on Apr 20, 2010

Testimonial: "that was very helpful. I will try it. quick response.... thank you..."

  • 4044 Answers

SOURCE: Where is the oil filter located on a 1998 Ford

You will find that jacking the vehicle up or putting it up on the drive up stands will help greatly when you change your oil. Makes it a lot easier to remove the drain plug and filter. As far as the location of the oil Filter, while you are laying under the vehicle feet to the front of the vehicle and head to the back I believe it is on the right side. In most cases the filter will be one of several colors. Blue, Orange or White, depending on Manufacturer. Of course there are exceptions. the Fram Tough Guard series have black on the end which is roughed so you can grip it and some are silver. When you go to get the new filter take some time to look a few different types on the shelves that are similar in size to the one recommended for your vehicle. Chances are it will be MotorCraft, STP, or Fram. These are the most popular. Now in the off chance there is an off brand type installed it maybe black. The reason you want to look at these though is so you get an idea of what they look like so when you are under the vehicle you will recognize it.

Posted on Jun 27, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What oil do i put in a 1996 ford courier 2.6 petrol

you did not post in what country and what climate,

if you are in oz, then any oil sae10-40, it is suitable year round,

if you live somewhere where water freeze in winter then winter oil should be sae 5-30, or sae5-40, summer should be sae 10-40,

if you live in tropics where temperature constantly exceed 35c (95f), then oil used should be sae15-60 or even sae20-60.

any brand will do, my preference is semi-synthetics in cars made after 1985, if car is working hard - towing, driving daily short distances - i do change oil and oil filter every 5000km (3000miles), if it is driven regularly and in light conditions you can double these distances.

if you find this answer helpful - why do not vote for it?

Jan 14, 2015 | Ford Cars & Trucks


Change Oil on 2003 Ford Focus

Here's how you change the oil and oil filter on a 2003 Ford Focus 2.0L SPI.

on Jul 13, 2015 | 2003 Ford Focus

1 Answer

My 2003 ford explorer sport making a sound like it needs more oil

NEXIQ 125032 USB Link Software Diesel Truck Diagnose Interface

Use professional quality oil filters. While purchasing economy oil filters may save a few dollars, you will be greeted on cold starts by a rattling noise that continues until the engine reaches operating temperature. All oil filters are not made the same. If you were to dissect quality oil filters, such as a MotorCraft, Wix or the Napa Gold Line model, you would see an anti-flowback valve installed within the filter. The purpose of this valve is to keep the oil in the engine's top end after the engine is shut down. By doing so, the valve train is lubricated instantly at start up, instead of seconds later after the oil pump has circulated the oil from the oil pan to the top of the engine. Dissect a cheap oil filter and essentially what you will find is a filter medium akin to a coffee filter, wadded inside a tin can. If you notice the ticking sound on start up, make sure to change your oil as soon as possible and use a good-quality oil filter.
Protect the engine with the factory-recommended-weight oil to keep valve ticking noises at bay. Your 5.4-liter left the factory with 5W-20 or 5W-30 semi-synthetic oil in the engine. Use of thicker oils, such as 10W-30 or 20W-50, no matter the climate, can overwork the engine's top end as it attempts to work with the thicker oil coursing through it. Once you have installed the thicker oil, you will most likely experience a ticking noise that does not dissipate when the engine reaches operating temperature. The longer the engine is operated with the wrong oil, the louder the noise will get. The synchronizer, which controls the timing for the top end, will ultimately become damaged and need to be replaced. As soon as you discover this ticking noise and know you have used the thicker oils, have the oil replaced immediately with the recommended weight.

Aug 06, 2014 | 2003 Ford Explorer Sport

1 Answer

My 2003 cadillac cts automatic transmission will not change gears pulls off slowly but will reach high speed

please do not have your transmission flushed , have someone take the oil pan off and replace the filter as well and what ever trans oil you take out replace it as well . no automotive repair shop will warrenty your trans if it should suddenly stop working , but just for your satisfaction ask the transmission repair shop who flushs trans if they guarantee it and have them put it in writing . ive never understood why flush dirty oil and leave the dirty filter in the trans , it collected all dirt and metal wear which is what is causing it to plug up causing it to restrict the oil flow

Mar 21, 2014 | 2003 Cadillac CTS

1 Answer

Were is the fuel filter located on a 79 ford courier

should be inline under the hood near the carb.

Dec 17, 2013 | Cars & Trucks

1 Answer

If there is a tiny oil spot on the concrete by the oil filter what could cause this

possible residue from filter change,or the filter may be lose,if you can reach it try tightening it,it should only need to be hand tight. either that or when oil was added they may have spilt a drop.but more likely to be residue from filter change as when filter is changed i normally smear some oil around the new oil filter seal.

Mar 27, 2013 | 2005 Ford Mustang

1 Answer

What brand oil should I use in 2003 Ford Focus se

the cheapest you can buy ,natural or synthetic ,any viscosity like 10/40or 20/50 and change the oil every 6000miles with a oil filter every third oil change and you wont go wrong the engine will last forever

Oct 31, 2010 | 2003 Ford Focus

1 Answer

How often should the oil be changed on a 2003 Ford Explorer Sport Track?

3000 miles on any car is reccomended, even synthetic only oil i woould only go 4000 becasue the oil picks up dirt and then clogs the oil filter

Oct 14, 2009 | 2003 Ford Explorer Sport Trac

1 Answer

Need to change oil and filter on 2003 Highlander Luger SUV

filter is in between radiator and exhaust manifold near front of engine , under hood. hard to see , but can reach around exhaust pipes and find it with hand.

Mar 28, 2009 | 2003 Toyota Highlander

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5685 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides