Question about Toyota Corolla

1 Answer

Is there a reset button for check engine light

Check light won't go off. car rides with no problem.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

You must use a code reader to turn off the check engine light. Just because you are not having drive ability issues doesnt mean there is nothing wrong. Chances are that check engine light is on for a reason.

Posted on Jan 09, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 236 Answers

SOURCE: My 2001 Lexus LS430 was misfiring, riding rough,VSC light is on

go to auto zone, advanced autoparts, or a certified mechanic and ask if they can reset the codes, it should be free

Posted on Jun 17, 2009

  • 1071 Answers

SOURCE: car won,t start sometimes & check engine light

before changing any more parts there are grounds on the engine that need cleaned one on the back of intake manifold then you have to remove battery tray clean up the ground there then clean where the tray bolts up as this aids in chassis grounding remove ground cable from bellhousing before you reassemble install star washers btween cable ends and where they bolt up this will dig into ground surface and cables making a better ground then remove turn signals in front there are two on right side and one on left side cleanup and star washer then there is the ground spots for the ecm inside removr kick panel on right side clean up and star washer if the starter doesnt work after this starter is probably bad but the other codes will probably clear out

Posted on Jul 29, 2009

  • 1 Answer

SOURCE: trac off and check engine light for lexus es 300

A week ago, on my Lexus ES 300 (2001), "Check Engine" and "Trac Off" lights came on. This coincided with me filling the gas tank to the brim to round the dollar to be paid. I cleaned the gas tank cap and the tank opening. However, both lights persisted. On the same day, when I turned on the car again, there was a hesitance, a stuttering to come on. Both "Check Engine" and "Trac Off" lights were still on.

The next day, the car wouldn't come on at all. It sounded as the battery was dead. I couldn't even jump start the car. So, I got a new battery from Costco ($59) and put it in. It took 15-20 seconds of cranking to get the car started. Once it was started, the engine sounded fine and the RPM normal. The "Check Engine" light was off. However, the "Trac Off" was still on. I cleaned the gas tank cap one more time.

The next morning, when I turned the car on, there was no problems. It came on instantly as it used to be, didn't have any warning lights, and drove smoothly.

Posted on Sep 01, 2009

czaa
  • 4536 Answers

SOURCE: 2007 Ford expedition won't start

ur oil pump may be failin-there r sensors everywhere on new cars-keepin u from starting as safety measure-computer systems r complex n things dont always show on 1 scan-they kinda hav the mindset of a pc

Posted on Sep 15, 2009

Testimonial: "Thank you. I have spoken with 2 other mechanics who said the same thing regarding the oil pump. It's being looked at. So I'll post more once I know"

jgwhomeequip
  • 1902 Answers

SOURCE: the car won't start; lights,

Check the starter and the starter relay or fuse. A client of mines car was doing the same thing, it ended up being two issues, the starter not working anymore, and a relay that was bad. If I am not mistaken everything should be labeled in the fuse box under the hood and will tell you where the fuse/ relay is for your vehicle

Posted on Jun 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Check engine light on & won't shift out of 2nd gear


Have the cat checked to see if the insides have come apart. A restricted cat will cause no power (ie will not accelerate)

Feb 15, 2013 | 2006 Jeep Liberty

1 Answer

WONT WHRIL OVER TO CRANK UP AND SMELLS GAS


[ Start over ]

The engine won't turn over at all ?

Or it just won't start ?

You have to know what the main issue is
& how to diagnose,we can only guess
up to a point.

Also-- what about how it has been starting &
running for the last several months?

What about preventative maintenance--spark
plugs,O2 Sensors,fuel filter,fuel pressure,stored
codes,fuel trim when it did run.

Those are things a professional checks,hopefully
on a road test with a scan tool & a helper along for
the ride.

Nov 13, 2012 | 2003 Ford Explorer

1 Answer

Reset computer 2004 impala


Clear Codes & Remove the dash check light ?

Codes Reader or Professional Scan Tool

If you disconnect the battery you may loose
things you need & really cause problems

I suggest you get the car repaired & then the light
will go away or be cleared at the repair shop when they
no longer need the stored data

You clear it, they can not diagnose the issues

If fault isn't repaired the light comes on until it is
& you won't be allowed to go thru inspection either

Oct 06, 2012 | 2004 Chevrolet Impala

1 Answer

Escalade 03 courticy lights won't come on when door is opened


Next to the head light switch you should have a roll dial switch and a round over-ride button push this once and overhead courtesy light goes on/off push twice and it over-rides headlights sensor to turn on/off

Sep 19, 2012 | 2004 Chevrolet Tahoe

1 Answer

Car won't start when the outside temp is below 20F


the crank sensor can fail at different temps some fail hot some fail cold i would start there

Jul 17, 2012 | 2000 Acura TL

2 Answers

How do you reset air ride suspension in lincoln mark 7


Putting on a car lift without turning off air ride won't affect the system, to reset the air ride system requires a code scanner and plug into port, try calling some auto stores to see if they can do this or have a cheap unit to reset, or take back to garage and fight with them to reset, or go to different garage.

Jun 09, 2012 | Lincoln Cars & Trucks

2 Answers

My epc and engine light came on and won't star in a 2006 2.0t passat any ideas


First of all you need to access the Engine Control Module (ECM) using suitable diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC's memored. DTC = Diagnostic Trouble Code. Then you will bu full informed about the root cause of the problem, and you will be able to repair & replace bad pieces and reset the ECM. Then the EPC (Electronic Pedal Control) yellow light will turn OFF.

The check engine light:
tdisline_743.jpg

The check engine light & EPC light:
tdisline_744.jpg

Oct 11, 2011 | 2001 Volkswagen Passat

1 Answer

2004 Hyundai Elantra won't start, emergency flashers keep blinking, can't shut off, lights dim, can't jump start, clicking from under dash from relays. What could it be?


The 'Keyless Entry & Burglar Alarm System" is activated. You must 'Disarm' the system using the Keyless Entry Remove (Key Fob) to "Reset" the system. The reason the engine won't start is due to the burglar alarm - it has a "Starter Kill" circuit which is activated when the alarm is activated. The alarm must be DEactivated to DEactivate the 'Starter Kill' circuit.
Another way to start the engine is to get in the car, put the key in the ignition and turn it to 'ON" and wait 3 to 5 minutes until the emergency flashers stop/turn off. Afterward, you should be able to start the engine. NOTE: This does NOT reset the burglar alarm. It will go off again when you enter the vehicle without using the remote/key fob.

Sep 06, 2011 | Hyundai Elantra Cars & Trucks

2 Answers

How to reset check engine light?


Go to your local O'Rielly's or Autozone. They will tell you the code and reset it for free. Otherwise take the negative battery cable loose for about 10 min. This will clear the ECM, but you won't know what tripped the light! Best Wishes, TJ

Aug 06, 2011 | 2007 Hyundai Azera Limited Sedan

1 Answer

I changed the a/c filter and have been trying to reset the light which says a/c filter change required but it won't reset. Can't understand why because I press reset as soon as it comes up...


All those lights etc on the right side of your dash
are not tied to anything

You don't have to change anything
or do anything. Oil,Cabin Filter etc

THEY ARE JUST GADGETS

Status does cycle
You press Reset & hold

When it says to hold, you
quickly press & hold Reset again

You can just forget all that

Doesn't do anything

You don't sit in your car &
call it up with the status button
& watch it anyway.


Brake Fluid-every 2 years --Flush/All Vehicles
Spark Plugs -- every 3 years,not over 60,000 miles
Fuel Filter --every 3 years
Air Filter --every 3 years
Cabin Filter --every 3 years
Trans & Power Steering--3 years
not over 30,000 miles--EVER on any vehicle

May 28, 2011 | 2004 Lincoln LS

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8737 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...