Question about 2005 Nissan Altima

Open Question

How to remove center console in 2006 nissan altima

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

fcsr
  • 43 Answers

SOURCE: remove driver's side door panel on 2002 nissan altima

Removal instructions are available with images and step by step directions, www.carstereohelp.com/strnissan.htm

Posted on Nov 13, 2008

  • 1 Answer

SOURCE: 2003 Nissan altima alternator

how do yow remuve alternaotor on a 2003 nissan altima

Posted on Jan 05, 2009

Mustgo
  • 2359 Answers

SOURCE: where is the speed sensor Su6494 on a 2006 nissan

The name of the sensor is call Vehicle Speed Sensor (VSS).

It's on the body of the transmission and connected via wire INTO the firewall.


Please rate my answer if it's helpful to you.

Cheers,


MUSTGO





Posted on Dec 14, 2009

ZJLimited
  • 17970 Answers

SOURCE: How do you remove a 1999 Nissan Altima starter?

Nissan Car Altima & Sentra 1999-06 StarterRemoval & Installation

  1. Remove or disconnect the following:
    Negative battery cable Air duct Harness protector from the harness Starter wiring at the starter Starter-to-engine bolts Starter from the vehicle


  2. b53bb6c.jpg
    Fig. Starter location and mounting detail-3.0L Maxima with a manual transaxle


    b2eb267.jpg
    Fig. Starter location and mounting detail-3.5L Maxima

To install:
  1. Install or connect the following:
    Starter and torque the long bolt to 57-72 ft. lbs. (77-98 Nm) on Altima and Maxima and 41 ft. lbs. (55 Nm) on 350 Z. torque the short bolt to 22-30 ft. lbs. (30-41 Nm) Starter wiring Harness protector Air duct Negative battery cable
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter

To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

1.6L & 2.0L Engines
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negaative battery cable

1.6L, 1.8L & 2.0L Engines
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negative battery cable

1.8L & 2.0L Engines
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negative battery cable

2.4L & 2.5L Engines
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

2.4L Engine
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

2.5L Engine
  1. Remove or disconnect the following:
    Negative battery cable Air cleaner cover and duct Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

3.5L Engines
  1. Remove or disconnect the following:
    Negative battery cable Air cleaner case (upper) and air cleaner to electric throttle control actuator tube. Harness protector from the harness Starter wiring at the starter Starter-to-engine bolts Starter from the vehicle

    42c548c.jpg
    Fig. Starter location and mounting detail-3.5L engine

continue...

Posted on Apr 05, 2010

  • 228 Answers

SOURCE: HOW TO REMOVE CENTER CONSOLE

slid both seats fowrad as far as they will go and there are 2 srews on the bottom of the rear of the center consule and then slide the seats all the way back and ther should be a small piece of platsic that looks like it can be removed from underneath the hand brake and then 2 more sres holding the front of the center consule in underneath the plastic piece that goes aROUND THE SHIFTER. if you can send me a pic of the front of the consule if not it should be very easy to figure out uif not what I said in the front of it just discribe it to me.

Posted on Jul 11, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to check why my car alarm in 2006 nissan altima is not working


If it aftermarket(bunch of wires and modules under the dash on the drivers side) remove it. If it is still factory it takes a scanner.

Dec 03, 2015 | Nissan Cars & Trucks

1 Answer

Remove alternator


Remove radiator and fan assemblies for easier access. Disconnect battery, disconnect wiring from alternator, remove belt and two bolts ,upper and lower that hold alternator. Wiggle and pry alternator free. Be careful not to bump into a/c condenser.

Jan 01, 2014 | 2006 Nissan Altima

1 Answer

Problem with 2006 Nissan Altima 2006 nissan


Coil packs are located on top of spark plugs, one for each cylinder.

Aug 25, 2013 | 2006 Nissan Altima

1 Answer

I cant find the oil pump on a 2006 Nissan Altima


On both the four cylinder and six cylinder engines the oil pump runs off the crank shaft. The front cover and timing chain needs to removed in order to replace or repair the oil pump. It is not a very common repair. Is there a reason you are looking for it?

Apr 09, 2013 | 2006 Nissan Altima

1 Answer

How do u change center console shifter light bulb on a 2000 nissan altima


it's not a light bulb the indicator in the gear console is lit up by a LED that has to be corrected by a dealership mechanic

May 10, 2012 | 2000 Nissan Altima

2 Answers

My 2006 Nissan Altima gear shift wont move when I turn my car on I spoke to Nissan and I had to pop off a button - stick a screwdriver in the slot so my gear shift would move- they say it is a break...


THE BRAKE SENSOR IS BEHIND THE BRAKE PADEL LOOK UNDER THE DASH WHERE YOUR BRAKE PADEL IS AT AND TRY TO PRESS IT WIT UR HAND AND YOU WILL SEE IT AND THATS IT YES YOU CAN REPLACE IT IF EMAIL AT TONYGLENN45@YAHOO OR CALL ME AT 786-261-3552

Mar 08, 2011 | 2007 Nissan Altima 3.5 Sedan

1 Answer

Emergeny brake light stays on. Hoe do I remove the consolr to replace emergency brake switch


actually barry before i pulled out the console i think i would take a long look at the pedal or lever which you push or pull to put the brake on. I'll bet you find a button switch attached to it somewhere, which completes a circuit and supplies 12 volts to a light in the console. However I could be wrong and a look through a manual could set you straight before you turn a wrench


http://cgi.ebay.com/ebaymotors/Haynes-Repair-Manual-Nissan-Altima-1993-2006-/230556747466?pt=Motors_Manuals_Literature&hash=item35ae40c6ca

Dec 02, 2010 | 1993 Nissan Altima

1 Answer

Need to change out back brake light on 2006 nissan


take interior cover behind tail light inside trunk off.the bulb the bulb twist locks in hole(twist counter clockwise to remove)repeat procedure to replace.

Mar 23, 2010 | 2006 Nissan Altima

1 Answer

Turn signal light flasher unit location - 2001 Nissan Altima 4-Dr Sedan


Remove the dash cover that has the fuse cover dorr on it (2 screws). Then remove the metal bracket ubder this panel (4 screws). Look up on the side next to center console.Next to a blue box is the flasher. Know if someone can figure out how to remove flasher let me know.

Jul 31, 2008 | 1996 Nissan Altima

Not finding what you are looking for?
2005 Nissan Altima Logo

Related Topics:

766 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...