Question about 1998 Chevrolet Astro Van

1 Answer

I need to remove my alarm on my chevy astro

I lost my keys i have a spare but i need to remove the alarm

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Best solution is to unlock the car , open the hood and disconnect the battery
After a couple minutes put it back on

Posted on Jan 09, 2013

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

weekspena
  • 375 Answers

SOURCE: i just lost the main

The first thing you need to do is find out if it is factorty or after market you do this but looking at the lights while the alarm is going off if the headlights are flashing, the alarm system is factory installed. Inserting the key into the driver door lock and turning to the left then back to the right is supposed to disarm it. If the parking lights are blinking,, the alarm is an aftermarket add on, and there should be a disarm button under the dash on the driver side. If it' an aftermarket alarm, you should be able to have it removed. There is a way to bypass the factory alarm. There is a wiring harness in the driver's door. You will have to remove the door panel to find it. The wire is dark green and purple. Splice into that wire and ground it to the chassis and the alarm should no longer work.

Posted on Jan 24, 2011

  • 122 Answers

SOURCE: help please...trying to remove ignition

try moving te shift lever up and down sometimes it will work other than that you have to pull the column apart to get the lock cylinder out

Posted on Jan 01, 2009

MNfisherman
  • 11896 Answers

SOURCE: How do you remove an ignition switch key cylinder

There are one or two little pins in the igniton switch that you need to have pushed in while switch is turned and pulled out.

Posted on Sep 09, 2009

  • 11172 Answers

SOURCE: Lost set of keys, alarm was on car locked. Found

the spare u have is for entrance only does not have chip in it for ignition try [sometimes memory goes if other key not used ] turning key to acc not start but to where dash lights up before starting vehicle and leave it in that position for about 15 minutes [usually need a key that starts vehicle to do this first but sometimes it works ] turn off than try start truck if no go than u will possibly will need to have the dealer cut a key using the vin number of vehicle pricey [can look but not many locksmiths are electronic key capable] good luck

Posted on May 14, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to disable internal alarm on 99 Passat


You need to get your new key programmed

Jun 06, 2015 | 1999 Volkswagen Passat

1 Answer

How do I replace the key switch on a 2003 chevy astro van-I lost the key?


It has to be drilled out, until you can turn it to the run position to push the button to release it.

Oct 04, 2014 | 2003 Chevrolet Astro

1 Answer

How to start a proton savvy with no chip in key housing


If not the battery (replacement) then check to make sure the transponder is not missing from the remote. Should be a small plastic to slot in the key. If still not working then you may need to reprogram it. It can only work if you have 2 set of keys to put in the ignition:

[1] Take the key that needs programming put it in the ignition and turn to the on position and then press and hold in the alarm reset button..

[2] While still holding in the reset button turn the ignition off and remove the key..

[3] Re-insert the key and turn the Ignition to the ON position.

[4] Release the alarm reset button and then press it in once..

[5] Now with the ignition still switched on take hold of your SPARE key and press the lock button on your spare key..the alarm should "BEEP" once..

[6] Now press the Lock button on the key that has lost its programming..alarm should "BEEP" again..

[7] Switch ignition off.

Try that it should work

Feb 21, 2013 | Cars & Trucks

1 Answer

I have a 2010 Honda pilot! I lost my keys at work and can't find the spare My question is how long will it take before the alarm system deactivates so I can check if the spare is in my car?


You dont have to wait. Pop the locks. Use wedges to flex the door at the top and a rod to hit the unlock button. When the alarm goes off pop the hood and pull the pos battery cable. Now you can look for your keys without some one thinking you are stealing the car.

Jan 26, 2013 | 2010 Honda Pilot

1 Answer

Lost my fob for 2005 chevy cavalier but have keys will alarm go off


most alarms will turn off when the ignition key is turned

Jan 15, 2013 | 2005 Chevrolet Cavalier

1 Answer

How to disable satria neo campro 1.6 alarm system?


Will do you no good. Even if you turn it off, you cannot start the car without an original key. You need to get hold of your spare key or get one made to start it. These keys has RFID immobilizer chip that has to programmed on the car to make the on board immobilizer recognize it.

Jul 27, 2012 | 2007 Proton Satria Neo

2 Answers

Lost set of keys, alarm was on car locked. Found spare key only, it will open door, alarm goes off, but the key won't start engine. It will turn in ignition, but dead! It's a Chevy HHR 2006! HELP


Close the doors. Lock the doors using the buttons on the key fob. Use the fob to again unlock the doors. The key should then work the ignition. If this will not work, you will have to tow your vehicle to the dealer and buy a new key and/or fob and have it programmed to the vehicle.

May 13, 2012 | 2006 Chevrolet HHR

1 Answer

I have lost my keys to my 1995 chevy Astro van. Do you know if it's possible to get replacement's from Chevrolet by providing chassis no's etc - or do i need to replace all the locks?


call your local dealer thay will give you one for very chep you just need you vin number. i have a 1998 and got me one for 28.00

Apr 11, 2010 | 1995 Chevrolet Astro

2 Answers

Wiring diagram for 92 chevy blazer


My 1992 Chevy blazer s-10 starts and then the door locks automatically starts locking and unlocking...It wont stay running either...

Jun 11, 2009 | 1992 Chevrolet S-10 Blazer

1 Answer

Need to program spare keys for 2003 s-10 and 1997 astro


dealership job.you need a special scanner to reprogram it.

May 02, 2009 | BMW 750 Cars & Trucks

Not finding what you are looking for?
1998 Chevrolet Astro Van Logo

221 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...