SOURCE: 2000 pontiac montana wipers stuck
This has happened a couple of times on my 1999 Pontiac Montana. Here's what I did to fix. Open the hood. Remove the shield over the the wiper cam mechanism on the passengers side. This is easy to access. Road salts and other dust and dirt gets in there and causes the sticking problem. Spray WD-40 in between the parts. Get in there with that little red spray straw and saturate it good, flush junk out. Get in the car and try the wipers. If I remember, you might have to manually place that little knob or lever on top of the cam in the opposite position to get it to resync, but try it first. Be sure the wipers are off when you're spraying the WD-40 so you don't injur your hands. I've had to do this twice and it worked both times.
SOURCE: 2003 Pontiac Montana Front Wheel Bearings
Remove the wheel, remove the hub nut, remove the brake caliper and rotor, put your socket and extension through the hub flange onto the bearing retainer bolts, undo them, release the abs sensor connector if it has it, remove the bearing and hub flange as an assembly, put the new one on and go backwards from here. Torque the hub nut to 180 ft/lbs, your done.
SOURCE: Changing the starter solenoid on a 2000 Pontiac Montana
On your van the solenoid is attached to the starter. If you can get a solenoid separate (i don't know if you can) then you will need to take the starter off and remove the solenoid (2 screws holding it on) and the wires (on red and one black i believe) pay attention to which wire goes where because you don't want to reverse it on the new solenoid.
SOURCE: changing sparks plugs in a 2000 pontiac montana
remove the ignition coil pack ( 2 10mm bolts on front of it and 2 13 mm nuts on the back side) u will need a long extension and deep socket for the back ones , and unplug all electrical connectors and remove it from the vehicle and you should be able to reach the back plugs without a problem.
SOURCE: Timing off on Pontiac Montana wipers
On top of the window motor there is a timing cam -- there is a little tab on the bottom that is most likely broken or bent. You need to replace the cam.
62 views
Usually answered in minutes!
×