Question about Cars & Trucks

Open Question

Central locking alarm set itself off

Central alarm system went off by itself. Could not find out why. It would be alright for a few mins. then would start again, and again, and again. I had washed the car and thought that maybe some water got it - has anyone had this problem and if so, how do I find out where the water got in (am concerned in case it rains now). Oh, and this morning the system was OK and has behaved itself all day so far.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 87 Answers

SOURCE: Camry central door locking not working after alarm going off.

there is a sensor on the door lock in the door if it goes bad or falls off it will do that take the door panel off window up and look at the back side of the lock a small snap ring holds it on some even come unplugged

Posted on Jun 12, 2008

Ad
  • 1861 Answers

SOURCE: Alarm and central door locking.

Replace the alarm control box, it is usually under the driver seat, or in the extreme left corner of the dash. If the box under the driver seat got wet for any reason, expect bizaare things to happen; in any case, replace the box.

Posted on Sep 09, 2008

  • 45 Answers

SOURCE: Car alarm not activating central locking

It means that the remote is not passing the signal to the car . The alarm has triggered because the system has detected an illegal entry. Replace the remote batteries

Posted on Jan 07, 2009

alicantecoli
  • 22219 Answers

SOURCE: E36 BMW 318I CENTRAL LOCKING

try locking and unlocking the car with the key 3 times slowly ,other than that i have no idea ?? another trick is to disconnect battery and join the cables together for a few minutes to discharge any capacitors that may be holding a charge in the computer..Only other thing i can think of is the main dealers who have the right connectors and software to re set it all .sorry i havent been of any help

Posted on Aug 05, 2009

  • 4044 Answers

SOURCE: The central locking on my 2001 Renault Scenic is not working.

Your not going to like this but it sounds like you have a problem with your ECM, Electronic Control Module. This is not something you will be able to repair unless you have a detailed work station to remove the Sealing compound that surrounds the modules control board.

Posted on Aug 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Peugeot 508 RXH: I cannot lock the car with the remote. The doors lock, but unlock again. The car detects open doors correctly. I can lock the doors with the dashboard button.


If you have 2 remotes does it do the same thing with both of them?
I/We have a Honda FRV and if you set the alarm from outside the car ....which locks the doors ...and the doors are opened from the inside, (yes I have set the alarm whilst still in the car,) this unlocks the doors as the drivers door has the master central locking switch on it. If I close the door withing a few seconds the alarm reactivates itself and the doors relock automatically
Presumably when your doors unlock the alarm is disarmed? Maybe your issue is linked to the receiver in the security system?

There is a difference, presumably, between you locking the doors from the dash as opposed to doing it from the remote control, the security system is not armed in the former, only the doors are locked +



GOOD LUCK

Jul 19, 2015 | Peugeot Cars & Trucks

1 Answer

Alarm went off, now the central locking doesn't work


use the car key itself from outside the vehicle with everything closed: use key in drivers door outside door lock and manually lock and unlock the door. check if fixed, may have to do a few times. i do believe the vehicle is in theft mode.

Aug 18, 2012 | 1994 Volkswagen Golf

3 Answers

Toyota corolla verso 2007 . the central locking has stopped working


Toyota Corolla Verso - Central locking has just stopped responding


So you don't waste your time, here are some assumptions: -

1. When I press the key fob there is no sound of doors trying to lock/unlock and I know the key fob is fine.


Solution:


In this situation reset the alarm/locking system

Below is the procedure I followed to get the central locking working again: -

Open the passenger door, and look at the side of the dash board. There should be a triangular panel. Pull the panel off to reveal a small set of fuses(see the back of the panel for the fuse map). To power down the central locking you need to remove the Dome Light fuse, this is located top left. Second one down 7.5 amps. (if in doubt remove the top two 7.5 amp fuses I did)

When you remove the fuse(s) you will notice the interior light go out indicating you have powered down the system.

Now leave them out for at least 30 mins so any capacitors can discharge properly. (Be aware while the fuse is removed all central locking is disabled, so the other doors are open. I left the fuse(s) out over night with all the doors open but I don't recommend it, 30 mins should be fine)

After 30 mins replace the fuse(s) close all doors, and then try your key fob, hopefully you should here that satisfying locking sound.


2. When I press the key fob I hear the locking system trying to engage.

This could be a faulty door switch on any door including the boot, or there could be a dent in the inner door panel of any of the doors, usualy the rear doors due to the seat belt not retracting properly.

Solution:

Check all door switches for damage, and check inner panel for dents, just a small dent where the switch connects can be enough to not engage the switch. This will stop the central locking.

Use some kitchen roll wrapped in tape (as a makeshift pad) and tape to the inner door as a temp measure to engage the door switch. At least you can then lock the car.


Jan 04, 2011 | 2007 Toyota Corolla

2 Answers

Remote central locking not working on Honda CRV 1999. central locking works with Key and the alarm and imobliser work form the remote.


Hi I wonder if you can advise me ,my central locking and alarm is very unreliable it keeps making a beep before the ignition goes on and clicking,it sometimes sets the alarm off,Ive had the AA round and theyve told me the car battery is dead,which I appreciate,but think the key hub central locking or alarm is running the battery low does the hand held button need a new battery,or can I take the fuse out for the central locking,dont want to pay 66 quid for a new battery if I can pay 2 quid for a new battery for the central locking button,or demobilize it

Aug 18, 2009 | 1999 Honda CR-V

2 Answers

E36 BMW 318I CENTRAL LOCKING A. I bought a 2nd hand 1995 BMW 318I in South Africa. Good condition. No owner?s manual. Everything worked ok for a few months. Then the batteries of the remote key transmitter...


try locking and unlocking the car with the key 3 times slowly ,other than that i have no idea ?? another trick is to disconnect battery and join the cables together for a few minutes to discharge any capacitors that may be holding a charge in the computer..Only other thing i can think of is the main dealers who have the right connectors and software to re set it all .sorry i havent been of any help

Aug 04, 2009 | BMW 318 Cars & Trucks

1 Answer

Car alarm not activating central locking


It means that the remote is not passing the signal to the car . The alarm has triggered because the system has detected an illegal entry. Replace the remote batteries

Sep 10, 2008 | 2006 Mitsubishi Colt

1 Answer

Camry central door locking not working after alarm going off.


there is a sensor on the door lock in the door if it goes bad or falls off it will do that take the door panel off window up and look at the back side of the lock a small snap ring holds it on some even come unplugged

Jun 12, 2008 | 1998 Toyota Camry

1 Answer

Alarm and central door locking.


Replace the alarm control box, it is usually under the driver seat, or in the extreme left corner of the dash. If the box under the driver seat got wet for any reason, expect bizaare things to happen; in any case, replace the box.

Jun 12, 2008 | 1998 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...