Question about 2004 Ford F150

1 Answer

Ford F150 4x4 2004 Starter does not always engage spins then after several bumps of switch engages and starts motor. Have changed starter problem still exist

Posted by on

  • hne6336950 Jan 25, 2009

    Flywheel is fine, is there a solinode on the firewall or is it mounted to the starter motor. The wiring looks great running from battery to the starter. It just seems not to have enough juice or ground.

  • tomcat2272 May 11, 2010

    have you checked the cylinoid on the firewall? also its rare but you could have gotten another bad starter. did it come with a warranty? are you sure the starter spins or does it click?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 180 Answers

Starter ring is worn out.

Posted on Jan 21, 2009

  • Kelley Duncan Jan 25, 2009

    Selonoid is on starter

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Starter stays engaged. why?


The return spring on the bendix has broken or the helix is so dirty, that the bendix is stuck.

Jan 27, 2016 | 2003 Ford F-150

3 Answers

Starter issie???


Check the alternator first

Jul 18, 2008 | 1999 Chevrolet S-10 Pickup

1 Answer

Starter spinning but not always engageing on my 2012 Hyundai sonata


The starter/solenoid is going bad, (flat spots) will need to replace, hopefully under warranty...please don't get stranded...last resort if stranded...tap starter with hammer, and try to start again...

Jun 21, 2014 | 1991 Isuzu Rodeo

1 Answer

Intermittent starter won't engage on mercrusier7.4 1988 boat engine


might be a burned spot on the starter contacts where the brushes power the motor.
tap the starter to see if problem goes away.
sometimes you can clean the contacts but that is a temporary fix.

Mar 11, 2013 | Cars & Trucks

1 Answer

1982 Pontiac Firebird Trans Am, starter solenoid only engages sometimes (starter motor always spins), occasionally starter gets stuck ON, and sometimes no spark (fuel is fine but car won't start u


ANY FAULT CODES? HAVE YOU CHECKED THE STARTE DEPTH FOR PROPER CLEARANCE? HAVE YOU RITIATED THE FLYWHEEL TO LOOK FOR MISSING TEETH? I HAD AN 82 T/A AND THAT WAS WHAT CAUSED MY STARTER PROBLEMS. AS FAR AS NO SPARK DO YOU HAVE ANY FAULT CODES INTHE ELECTRONICS? TO TEST WITHOUT A SCNNER GO TO THIS LINK

Feb 11, 2012 | Cars & Trucks

1 Answer

I have a 1998 f-150 4.2l v-6 tryed to start it today it turned over and did not catch. turned key to try again it bumped the starter but would not turn the engine over. I tryed jumping it but I knew I had...


When you say 'it bumped the starter but did not turn the engine over' and 'it bangs the starter' it sounds like you mean it hits the flywheel and will not turn the engine. If it engages and does not turn the motor you need to try to manually turn both directions. Do not have the key in the ignition. If it won't turn you may have a froze up motor.
If you mean the starter spins freely but won't engage the engine - than you need a new starter. Let us know what you find out.

Mar 06, 2010 | 1998 Ford F150 Regular Cab

2 Answers

Starter makes grinding noise sometimes and just spins but does not start my 2002 x-type jaguar, did it several times in one day The day before it was fine and was very quiet starting What is the problem ?...


take your starter out and rotate your flywheel that connect to your starter full turn look for any damaged teeth on that flywheel if you notice any your flywheel need replacement if not your starter gear also could be a problem or starter itself is no good .

Jan 26, 2010 | 2002 Jaguar S-Type

1 Answer

Hey there, I have a P reg Audi A4 avant sport. The initial problem was that the ignition key did not spring back from cranking the starter motor, I believe this has caused my bigger problem which is that I...


It sounds like you have 2 problems.

The first is the ignition switch. Call or visit your Audi dealer and ask about a recall for your ignition switch. I believe it should be replaced under recall.

Next, it sounds like the starter solenoid is not engaging. The starter has probably been damaged due to the faulty switch.

The third, and I hope it is not the case, is that the teeth on the flywheel which engage the starter are damaged and missing.

Once the starter is removed it will be obvious if there is damage to the flywheel.

Good luck.

Dec 14, 2009 | 1998 Audi A4

2 Answers

How to trouble shoot starting system 98 ford crown victoria


Also check to see if there is power in the start wire form the ignition switch, the wire is a white wire with pink stripe, most likely not a common problem, but still something that could go wrong. this wire will feed the starter relay under the hood...

Sep 21, 2009 | 1997 Ford Crown Victoria

1 Answer

Ford F150 starter does not engage, spins the catches off and on


Most Likely The Starter I Know We Changed It Is What your Thinking.
I Done 3 In A Row And The Fourth One Was Finally Good.

Jan 21, 2009 | 2004 Ford F150

Not finding what you are looking for?
2004 Ford F150 Logo

Related Topics:

551 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...