Question about 2000 Hyundai Accent
Hi guys umm so i have a Two Thousand And Two Hyundai Elantra SE that well the way me and my mother put it, "IT DOES NOT LIKE THE COLD" what i mean is, during the warm up period after i start it in the morning, as its warming up, the cars Tachometer needle drops below 485 Rpms and tries to stall but then sometimes the rpms come back up without it stalling.. othertimes it will just stall out and i have to restart it again... even when i drive it right after it warms up, itll try and stall while driving... any ideas on how to fix this?
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
ok when the check engine light comes on that usually indicates a engine malfunction...what you can do is go to your local autozone and they can do an OBDII test for free..my bet says it is the cam or crank sensor.. DO NOT SHUT THE CAR OFF AT AUTOZONE..LOL
Posted on Jan 01, 2009
Does the Check Engine light come ON when this happens? Whenever the "Check Engine" light comes on, there is always a DTC (Diagnostic Trouble Code) stored in the ECM (Engine Control Module). You'll need an OBDII (On-Board-Diagnostics) scanner to retrieve any codes recorded/set in ECM. Otherwise, guesswork. I have MANY ideas that could send you on a wild goose chase. I strongly suspect EMS (Engine Management System) sensor beginning to malfunction as it warms up. First strong suspicion is the crank position sensor (CKP) - however,usually always sets a DTC (i.e., P0335, P0336). The next suspicion is the Engine Coolant Temperature sensor. The ECM uses this sensor's signal to adjust fuel, timing, engine RPM, etc based on engine temp. If malfunctioning at a particuar point during engine warm up, it could be telling the ECM the temperature is LOWER or HIGHER than it ACTUALLY is, resulting in the ECM to increase fuel (flood it) or give it LESS fuel (starve it). If this malfunction lasts long enough, the ECM will usually set a DTC for that sensor circuit, either a Range/Performance code, or a "LOW Input" or "HIGH Input" code.
Posted on Jun 07, 2009
Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.Take/Tow your vehicle to an authorized Hyundai dealership and pay the diagnostic fee... they will tell you exactly what the problem is and the cost of parts/labor to fix it... at least this way you'll know what the problem is and what's required to fix it.Whenever the 'CHECK ENGINE' (Service Engine Soon) light comes on, the ECU (Engine Control Unit) sets a Diagnostic Trouble Code (DTC). These codes identify the particular engine management system which caused the light to come on.
You'll need to use/find an OBDII (On-Board Diagnostic) Scanner to retrieve any code which have been stored in the ECU computer. Afterward, we might be able to help you DIAGNOSE the problem and perhaps eventually fix the problem.
Posted on Oct 04, 2009
I am having the exact same problem with my 2001 Hyundai Elantra. I was told that the engine code that comes up when the sensor is on is called "Absolute Pressure In The Manifold". I was told by a "Hyundai Specialist" that when that code comes up it usually means that the seal on the manifold is Fuct. When my mechanic checked that out for me he had noticed that my manifold had 4 cracks in it(can varify cause he showed me). He replaced the manifold and gasket. The car ran fine for about 2-3 days and since then the problem has since come back and my check engine light will no longer go on/off it only stays on. Because of the check engine light always staying on I have noticed that on many occasions my car will hiccup many times in a row. The only way to stop the hiccup I have noticed is to take my foot right of the gas for approx. 2-3 sec then car will continue without hiccup(till it happends all over again). All in all I have been having this problem now for approx. 1 year and if there is somehow someway it could be repaired I would appretiate it.
Posted on Nov 06, 2009
Tips for a great answer:
Mar 09, 2010 | Hyundai Motor 2002 Elantra
Dec 16, 2009 | Hyundai Motor 2002 Elantra
Oct 26, 2009 | Hyundai Motor 2002 Elantra
Jun 24, 2009 | 2000 Hyundai Elantra
Jun 11, 2009 | Hyundai Motor 2002 Elantra
Apr 10, 2009 | Hyundai Motor 2002 Elantra
Apr 04, 2009 | Hyundai Motor 2002 Elantra
Mar 18, 2009 | 2004 Hyundai Elantra
Feb 13, 2009 | Hyundai Motor 2002 Elantra
29 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: