Question about Cars & Trucks

Open Question

01 slk230 where is secondary air pump fuse located.

Cant find fuse in vehicle

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 373 Answers

SOURCE: secondry air injection system malfunction

Hi. I'm reading your request.

Your S10 . has a small fuse box Next to the battery.
1 - air solenoid 10 amp.
1 - air fuse 30 amp.
1 - Mini relay (air relay)

On under hood main fuse block you have.
1 - fuse Engine E 10 amp.

Posted on Jul 12, 2008

freetek
  • 5568 Answers

SOURCE: Secondary air injection pump, 01 GMC Jimmy V6

You didn't mention the fuse rating of the one you replaced so this method may not help if it was higher than ~5 amps.At this point, I would wire a 12 volt bulb, preferably, one with 40-50 watts rating (headlamp will do fine) in place of the fuse that is blowing and start pulling likely connectors until the light goes out. If you don't get results this way, you might try disturbing one bundle of wire after another since this could be happening because of insulation that has been pinched or worn through to reach ground.
Using a bulb instead of bridging the fuse with a piece of coathanger will prevent melting the wire and possibly compounding the problem.   

Posted on Nov 24, 2008

csmock132
  • 4669 Answers

SOURCE: were is fuse location for secondary air pump 2001

It is in a little fuse box in the passenger fender. Just to the left of the battery looking from the grill.

Posted on Aug 20, 2009

  • 118 Answers

SOURCE: 2002 pontiac montana van ''service engine soon'' light

Diagnostic Aids

  • Low system airflow can cause an intermittent complaint. Inspect for the following conditions:
    • Any restriction in the exhaust system that may produce back pressure
    • Pinched, kinked, restricted, or leaking pipes, hoses, or fittings
    • A restricted pump inlet hose, duct, or filter
    • Pinched, kinked, restricted, or leaking vacuum lines
    • Heat damage
  • A short to voltage in the pump relay control circuit can result in the AIR pump running continuously with the ignition OFF by back-feeding to ground. This will eventually result in pump failure.
  • An AIR pump that had become inoperative and had shown indications of having exhaust gases in the outlet port would indicate check valve failure.
  • Notice Do not operate the AIR pump for more than 60 seconds. Continuous operation of the AIR pump in excess of 60 seconds will damage the AIR pump.

    If the DTC cannot be duplicated and is determined to be intermittent, reviewing the Failure Records data can be useful in determining when the DTC was last set. Also refer to Intermittent Conditions

Posted on Oct 11, 2009

  • 400 Answers

SOURCE: secondary air injection pump location

under the radiator on the passenger side of the truck. There is a little splash guard you will need to remove to see it, The guard is held in with 4 15mm headed bolts, then you will be able to see the bottom of the air pump.

Posted on Oct 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can I find the fuse and relay for air injector pump on a 2005 chevy trailblazer LS?


AIR SOL - fuse #54 15amp - AIR fuse #56 60amp location under hood fuse / relay box
54
AIR SOL Fuse
15A
AIR SOL Relay, Secondary Air Injection (AIR) Pump Relay, Secondary Air Injection (AIR) Pump, Secondary Air Injection (AIR) Solenoid
55
AIR SOL Relay
--
Secondary Air Injection (AIR) Solenoid

Sep 13, 2016 | 2005 Chevrolet TrailBlazer LS

1 Answer

Where is fuel pump relay located on 1998 mercedes slk230


where is the fuel pump relay located in a 1998 mercedes slk230?

Feb 20, 2013 | 1998 Mercedes-Benz SLK

1 Answer

Where is the fuse located for a 2005 chevy trailblazer secondary air injection pump


my 2008 Trailblazer has the same issue P0411, changed the Air check valve and still the light comes on

Jan 18, 2012 | 2005 Chevrolet TrailBlazer

1 Answer

2002 CADILLAC DEVILLE CODE P0412


p0412 Secondary air injection switching valve A circuit
Right side of engine compartiment. ( underhood fuse block )
- Air pump fuse 50A- Air control valve relay- ignition1 fuse 10A ( positive for the relay )The secondary air injection pump relay is located near radiator surge tank.Left front of engine compartiment = Secondary air injection pump

Nov 15, 2011 | 2002 Cadillac Deville

2 Answers

Secondary air injection system malfunction


CHECK AIR PUMP FUSE 25 AMP AND CHECK THE SECONDARY AIR INJECTION PUMP RELAY.IF ALL IS GOOD AIR PUMP HAS A BAD SOLENOID OR THE PUMP IS FAULTY.

Mar 01, 2010 | 2004 Chevrolet TrailBlazer

1 Answer

Cant find location of relay for secondary air


take it to a cheap mechanic and have them look at it

Sep 01, 2009 | Dodge Stratus Cars & Trucks

2 Answers

I have a 2001 gmc jimmy wiTh a secondary air injection code. bought THE VEHICLE used and had the code checked in the summer because it is hard to start it turns over,i replaced the fuel pump relay i also...


this is most certainly the electric motor driven secondary air injection pump, very prone to failure.
Price at www.rockauto.com $207.00 (lowest anywhere)
AC DELCO Part # 219505 {#17803251}
PUMP,SECD AIR Injection w/ELEC AIR INJECTION REACTOR(K18)

Feb 13, 2009 | 2001 GMC Jimmy

2 Answers

Location of a secondary air pump on a 2002 chevy venture


The A.I.R pump is located on the driver's side of the vehicle, just in front of the front tire. If you remove the tire & look at the inner fender well, you'll see that it's designed with a "trap door". Remove the screws that hold the door closed, then fold the door back to reveal the pump. What usually happens is the pump sucks in the sponge filter on the intake side & it lodges in the impeller blade...this causes the fuse to blow & eventually a code will set & the Service Engine Light will come on. The fuse is located under the hood in the black fuse box on the passenger side...the box should be clearly visible & easily accessable. Look for a 30A fuse, probably in location # 39.

Jul 28, 2008 | 1997 Chevrolet Venture

1 Answer

Vw passat 2000 1.8t front wheel drive


please rate me solved...thanks

DTC P0411/16795: SECONDARY AIR SYSTEM - INCORRECT FLOW DETECTED
Test Requirements
Ensure all fuses are okay, battery voltage is at least 11.5 volts, all electrical accessories are off, A/C is off.
Ensure engine is mechanically sound.
Test Procedure

NOTE
Secondary air system is activated by ECM and blows air into exhaust pipe
upstream of catalytic converter for 100 seconds during a cold start, 41-91°F (5-
33°C). Engine must be cold to perform following test procedure.

1. Ensure fuse and secondary fuse (secondary fuse is 40 amp and is located in fuse holder on top of battery)
are okay. Check hoses and components of Secondary Air Injection System, for damage, loose fit and
improper installation, check vacuum hoses for Secondary Air Injection System. Repair as necessary.
Erase DTC memory. Verify repair. If DTC does not reset, test is complete. Perform ECM relearn
procedure. See TEST DRIVE RELEARN PROCEDURE .
2. Remove engine cover. Disconnect pressure hose from Secondary Air Pump Motor (V101), by pressing
buttons on hose connector. See Fig. 33 . Using scan tool, check Secondary Air Pump Motor (V101) in
scan tool Output Diagnostic Test Mode (Secondary Air Pump Relay activation mode). See OUTPUT
DIAGNOSTIC TEST MODE .
3. Secondary Air Pump Motor (V101) should run in intervals and air should exit pump at hose connection.
If Secondary Air Pump Motor (V101) is okay, go to step 7 . If motor runs and no air exits secondary air
pump motor, replace faulty Secondary Air Pump Motor (V101). Erase DTC memory. Verify repair. Test
is complete. Perform ECM relearn procedure. See TEST DRIVE RELEARN PROCEDURE . If
secondary air pump motor does not run, go to next step.
4. Disconnect Secondary Air Pump Motor (V101) harness connector, install LED test light at secondary air
pump harness connector terminals. Turn ignition on. Using scan tool, activate Secondary Air Pump Motor
(V101) in scan tool Output Diagnostic Test Mode (Secondary Air Pump Relay activation mode). See
OUTPUT DIAGNOSTIC TEST MODE . LED test light at Secondary Air Pump Motor (V101) harness
connector should flash. If LED test light at Secondary Air Pump Motor (V101) harness connector does
not flash, go to next step. If LED test light at Secondary Air Pump Motor (V101) harness connector
flashes, replace faulty Secondary Air Pump Motor (V101). Erase DTC memory. Verify repair. Test is
complete. Perform ECM relearn procedure. See TEST DRIVE RELEARN PROCEDURE .
5. Using DVOM check resistance of Secondary Air Pump Motor (V101) wiring. See appropriate WIRING
DIAGRAM under ENGINE PERFORMANCE in SYSTEM WIRING DIAGRAMS. Resistance should
be a maximum of 1.5 ohms for each reading. Check wiring for short circuit to one another in Secondary
Air Pump Motor (N101) harness connector. Repair as necessary. Erase DTC memory. Verify repair. Test
is complete. Perform ECM relearn procedure.
Secondary Air Pump Motor (N101) wiring is okay, go to next step.
6. Check Secondary Air Pump Relay (J299) and Secondary Air Pump Relay (J299) wiring. See DTC
P0418/16802: SECONDARY AIR PUMP RELAY (J299), MALFUNCTION . Repair or replace as
necessary. Erase DTC memory. Verify repair. Test is complete. Perform ECM relearn procedure. See
TEST DRIVE RELEARN PROCEDURE .
7. Disconnect vacuum hose from Secondary Air Injection Valve (N112) and disconnect pressure hose from
secondary air pump motor, press buttons on pressure hose connector to disconnect pressure hose. See Fig.
34 . Blow lightly into disconnected pressure hose, Combi-Valve should be closed. Connect hand vacuum
pump to disconnected vacuum hose and apply vacuum to Combi-Valve, Combi-Valve should open. If
Combi-Valve opens when vacuum is applied, Combi-Valve is okay. Go to next step. If Combi-Valve
does not open when vacuum is applied, replace faulty Combi-Valve. Erase DTC memory. Verify repair.
Test is complete. Perform ECM relearn procedure. See TEST DRIVE RELEARN PROCEDURE .
8. Check Secondary Air Injection Valve (N112). See DTC P0412/16796: SECONDARY AIR
INJECTION VALVE (N112), ELECTRICAL CIRCUIT MALFUNCTION . Repair as necessary.
Erase DTC memory. Verify repair. Test is complete. Perform ECM relearn procedure.
NOTE: Do not use compressed air to check Combi-Valve.
2000 Volkswagen Passat GLS
2000 ENGINE PERFORMANCE Self-Diagnostics - 1.8L Turbo

Jun 21, 2008 | 2000 Volkswagen Passat 4Motion

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...