Question about Cars & Trucks

Open Question

Check engine has a code p0450 on my 2004 Volvo 1.9

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Molson02536
  • 3854 Answers

SOURCE: check engine light code PO442

You likely won't notice any drivability problems. P0442 indicates a fuel vapor leak in the EVAP control system. It means a very small leak has been detected. In fact, the leak can be from a hole as small as 0.04" in diameter. 
The (EVAP) emission control system prevents the escape of fuel vapors from a vehicle's fuel system. Fuel vapors are routed by hoses to a charcoal canister for storage.
Later, when the engine is running a purge control valve opens allowing intake vacuum to siphon the fuel vapors into the engine.

With a P0442, the most common repair is to Remove and reinstall the gas cap, clear the codes, and drive for a day and see if the codes come back. Otherwise, replace the gas cap, or Inspect the EVAP system for cuts/holes in tubes/hoses.

Good luck and hope this helps

Posted on May 07, 2009

Ad
Outofworkjoe
  • 216 Answers

SOURCE: check engine codes

1-2-3* Signal missing to/from coolant temp. sensor Wiring fault to or in ECT sensor;grounds corroded on intake manifold or engine Difficult to start engine when cold Same Same

Posted on Jun 22, 2009

afarri
  • 1386 Answers

SOURCE: 2005 volvo the check engine 2005 volvo the check

Hello and welcome to FixYa!
As a first course of action, I strongly suggest that you remove the positive battery connector and let it sit for atleast 10mins. or more before reconnecting it. This will reset the system and can get rid of the dash lights.
If the problem still persists, I suggest that you take it in to a reputable shop to have it resetted manually.
Hope this helps and thank you for using FixYa! Have a good one!

Posted on Aug 07, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is a fuel trim bank 1 on a 2006 xc90 volvo an whatvis a evap emission system switching valve mean


  • P0170 Fuel Trim Malfunction Bank 1 OBDII Engine Light ... www.engine-codes.com/p0170.html Possible Causes and Repair Information for P0170 code. Learn what does P0170 means? P0170 Fuel Trim Malfunction Bank 1
  • P0170 Volvo Fuel Trim Bank 1 - Car OBD Code www.carobdcode.com/p0170-volvo-fuel-trim-bank-1 Dirty air filter, air filter housing or Mass Air Flow (MAF) sensor, or faulty MAF sensor are common causes for the P0170 Volvo code.
  • P2420 Volvo Evaporative Emission (EVAP) System Switching ... www.carobdcode.com/p2420-volvo-evaporative-emission-evap-system... Trouble Code Description: Evaporative Emission (EVAP) System Switching Valve Control Circuit High
  • P2420 Evaporative Emission System Switching Valve Control ... www.engine-codes.com/p2420.html P2420 Evaporative Emission System Switching Valve ... Evaporative Emission System Switching Valve ... P2420 SCION Evaporative Emission Pressure Switching Valve ...

    http://www.carobdcode.com/p2420-volvo-evaporative-emission-evap-system-switching-valve-control-circuit-high#.V4_T_uSV-P8
  • http://www.carobdcode.com/p2420-volvo-evaporative-emission-evap-system-switching-valve-control-circuit-high#.V4_T_uSV-P8

    Jul 20, 2016 | 2006 Volvo XC90

    1 Answer

    What is check engine code SA 16 DTC P113300 on 2014 Volvo


    p1133, is a bad heater on the O2 sensor. Usually the sensor, some times the wire, rarely the PCM. bank 1 sensor 1.

    Mar 17, 2016 | Volvo Cars & Trucks

    1 Answer

    I have 2003 volvo s40, its check engine is on and i used OBD and gave me this code: P0015, anybody knows what it means and how to figure it out?


    P0015-camshaft position actuator B-Bank 1 timing over - ******.

    1.9 ltr right? Engine prone to sludge. Try and engine flush like seafoam (don't drive with it in your engine.... run it for a few minutes then shut it down) then change your oil and filter to a good quality synthetic. Then clear the code. Won't hurt it if you drive it with this code but can be annoying.

    Jan 10, 2012 | 2003 Volvo S40

    2 Answers

    I get various lights on: transmission, ABS and


    More like computer.. you will need to isolate the problem with one code at a time... sometime two codes are fixed, try this:
    1. Check the rotor and break pad thickness, that normally will fix abs, brake or abs and tracs.
    2. check engine could be as simple as an O2 sensor or fuel filter, coil pack, starter... each needs to be check'd.
    3. check engine should identify condition codes.. go to princess auto and pick up the comptuer untit for 60$.
    4. If it ain't burning oil.. heck have fun with it.
    Have fun..

    Jun 07, 2010 | 1999 Volvo V70

    7 Answers

    I have 05 volvo vnl 670, isx cummins 450/500. keeps losing power, check engine ECU comes on knowbody seems to know what it is. they just keep replacing sensors.


    I have a 2007 Volvo 670. The check vehicle ecu comes on. The fault code is MID 144 PID 191 FMI 5. THe truck won't go pass 1400 rpm, the speedometer doesn't work, the cruise doesn't work, the engine break doesn't work. I have to turn the truck off going down the road at highway speed for about 10 seconds and it'll go back to normal. Can anybody help?

    Feb 16, 2010 | 2005 Volvo XC90

    1 Answer

    Check engine light is on---failed inspection


    This code means: 'O2 Sensor Circuit (Sensor 1), Electrical fault'.

    Jan 12, 2010 | 1998 Volvo S90

    1 Answer

    Check engine codes


    1-2-3* Signal missing to/from coolant temp. sensor Wiring fault to or in ECT sensor;grounds corroded on intake manifold or engine Difficult to start engine when cold Same Same

    Dec 23, 2008 | 1994 Volvo 940

    1 Answer

    Check engine light on and Troubleshooting code is P0116


    Hi, I managed to find a graphic illustration of the ECT sensor.
    02c7b2a.gif

    Good luck!

    Dec 15, 2008 | 1999 Volvo V70

    1 Answer

    I have a check engine light on


    code p2404 is from a none volvo tester it would convert over to volvo code ecm 432a ,leak diag. pump failure,now dont play with it driving should be ok but you should take it to the dealer or a volvo only shop and read codes and fix it when your ready

    Aug 16, 2008 | 2004 Volvo S60

    Not finding what you are looking for?

    Open Questions:

    Cars & Trucks Logo

    Related Topics:

    48 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Cars & Trucks Experts

    yadayada
    yadayada

    Level 3 Expert

    76132 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    Randy Ohler

    Level 3 Expert

    14585 Answers

    Are you a Car and Truck Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...