Question about Hyundai Motor 2003 Sonata

1 Answer

Replacement of 2003 hyundai sonota instrument cluster

I have a new cluster for my daughters car and need to know what needs to be removed to gain access to and remove the instrument cluster. the vehicle is a 2003 hyundai Sonota.

Posted by on

  • Anonymous Mar 18, 2014

    can you drive a vehicle after the instrument cluster has been taken out

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 42 Answers

Removed the dash bezzle and low and behold there were the screws to remove the dash cluster

Posted on Jan 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 Jetta Tdi instrumentation cluster both LCD segments are no longer displayed Remove cluster and disassembled carefully removed displays and cleaned contact pads on circuit board and cleaned zebra...


Your LCD display is out of order. You can try to find one new on eBay. Chinese brand is cheaper, but VDO is better. After buying the LCD display you will need to install it.
See this link as an example of a new LCD display installation in the instrument cluster.
http://www.audizine.com/forum/showthread.php/263498-Official-DIY-2000-Audi-S4-LCD-Instrument-Cluster-Pixel-Repair

Aug 02, 2011 | Volkswagen Jetta Cars & Trucks

1 Answer

I have 2003 nissan sentra, the readings on the millage meter does not show up as a result i don't know and can't tell the millage of the car. What could be the problem


There is not much you can do. The instrument cluster is one piece and is not serivable. You will need to replace the entire instrument cluster. In this case you order the cluster with the milage on it and then you would get a new cluster with the milage in it already. I hope that helps you

Jul 11, 2011 | 2003 Nissan Sentra

1 Answer

Do you know where I can get the small replacement bulbs that fit into the back of the heater and a/c control unit? This is for a 2003 hyundai sonota. thanks


you can stop by any Napa or autozone auto parts store you can also stop by any Hyundai or Kia dealership in the parts department you can also ask them for pictures and diagrams showing you how to get to the blulbs Merry Christmas and Happy New Year as always wish you the best of luck Michigan Man.

Dec 20, 2009 | Hyundai Motor 2003 Sonata

1 Answer

How do you get the clock out of a 2003 Hyundai Elantra? It doesn't work and I want to see if it can be fixed or replaced.


you will need to replace the clock.the clock has (2) 12 volt power supplies fuse 25 and fuse 9 in the pass. compartment fuse block if these have power and are good check ground g11 located behind the radio.ok you will need to remove the instrument panel facia.thers (2) screws behind the ash tray and above the instrument cluster.be carefull somtime its difficult to pop off use a plastic pry bar to keep from bending the dash.the rest is easy.

Oct 23, 2009 | Hyundai Motor 2003 Elantra

1 Answer

Need to replace instrument cluster/AC bulbs


Hello, You can obtain a 2004 Ram Factory Service Manual with all of that information available from Promanuals.net. The reason why it may be so important is because right before the removal instructions the service manual has diagnostic instructions to try. There are numerous pages on removing the instrument cluster, and cluster bezel.

(1) Disconnect and isolate the battery negative
cable. (For Airbag)

(2) Remove the cluster bezel from the instrument
panel. (Refer to 23 - BODY/INSTRUMENT PANEL/
CLUSTER BEZEL - REMOVAL).

(3) Remove the four screws that secure the instrument
cluster to the instrument panel structural support
(Fig. 5).

(4) Pull the instrument cluster rearward far
enough to access and disconnect the instrument
panel wire harness connectors for the cluster from
the connector receptacles on the back of the cluster
housing.

(5) Remove the instrument cluster from the instrument
panel.
9e8a042.jpg

Oct 01, 2009 | 2004 Dodge Ram 1500

1 Answer

I need to remove the cover on the gauges on a 2001


Instrument Cluster Removal and Installation Disconnect the battery ground cable. For additional information, refer to Section 414-01 . Remove the instrument panel center finish panel. Remove the screws. Disconnect the connectors and remove the instrument panel center finish panel. Remove the hood latch release handle. Remove the screws. Lower the hood latch release handle out of the way. Remove the instrument panel steering column cover. Remove the screws. Remove the instrument panel steering column cover. Remove the instrument panel steering column opening cover reinforcement. Remove the four screws. Remove the instrument panel steering column opening cover reinforcement. Position the column gearshift lever in the low position. Partially remove the instrument cluster finish panel. Remove the screws. Position instrument the cluster finish panel to gain access to electrical connectors. Remove instrument the cluster finish panel. Disconnect the connectors. Remove instrument the cluster finish panel. NOTE: Illustration shows steering column removed for clarity. Remove the instrument cluster. Remove the screws. Remove the transmission range indicator and position the cluster forward to disconnect the three electrical connectors on the back. Remove the instrument cluster.

May 15, 2009 | 2001 Ford Explorer Sport

2 Answers

Hyundai getz radio


Here's a pic

5781d0b.jpg
Pops out, then remove 4 screws which mount the audio & instrument panel.7be2186.jpg

Apr 11, 2009 | 2003 Hyundai Tiburon

1 Answer

How to change a instrument panels lightbulb ?


Unfortunately you must remove the cluster to gain access to these bulbs. Remove radio, heater fan knobs, temp slider knobs,and temp control faceplate (carefully remove bulb in faceplate), then remove the Phillips screws inside the holes where these came out that hold the cluster . unscrew or unclip and remove the speedo cable from the back of the cluster. you may have to disconnect some electrical jacks (remember where and how they go back in!) to gain complete access. Then it's just a matter of pulling out the little bulbs and replacing them. Because this is so involved I would replace ALL of them at once. Hope this helps...;-)

Apr 09, 2009 | 1993 Volkswagen Golf

1 Answer

My 2003 sonota's ignition will not turn it is as if it is locked.


Try turning the steering wheel to one side a little when turning the ignition. The locking mechanism for the key tumbler will not turn if there is eccessive force on it. This can happen if you hit a curb while parking and turning off the car, or if the wheels are turned when shutting of the vehicle. My daughter had the same problem after parking and had to call me to ask me what to do. If that doesn't work there is something wrong with the key tumbler locking mechanism.

Jan 18, 2009 | Hyundai Motor 2003 Sonata

Not finding what you are looking for?
Hyundai Motor 2003 Sonata Logo

Related Topics:

350 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...