Question about 2005 Dodge Ram 1500

Open Question

My 2005 dodge ram 1500 5.7 surges at low speed and jerks hard going into passing gear when getting on it hard

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 74945 Answers

SOURCE: dodge ram 1500 engine rpms surge at freeway speed

those sensors could cause the issue, clean the MAF 1st, also clean the idle system using the following procedure, the IAC can cause cruise surge. I use this to cure these problems all the time.

Here is the most common cause of surges and stalls and low idle, it is the idle speed control air-bypass valve (IAC) and throttle valve, they get full of gunk over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Posted on Jan 13, 2009

rockitman187
  • 2559 Answers

SOURCE: 1999 Dodge Ram 1500 2WD won't shift properly

Sounds like the speed sensor on the rear axle.

Posted on Jan 20, 2009

  • 240 Answers

SOURCE: 2005 dodge ram need to find out drive pattern to

http://www.discountedwheelwarehouse.com/Vehicle_Bolt_Pattern_Reference.cfm i think this ste link will do the needful for u

Posted on Jun 15, 2009

  • 1596 Answers

SOURCE: I have replaced the thermostat and clutch fan on

Did You Replace the (FAN CLUTCH) or just the FAN ? Sounds Like FAN CLUTCH Problem, os long as Coolant Level is FULL , There ALSO May be An OBSTRUCTION in RADIATOR , Check in Front of Radiator for Debris and CLEAR ANY that May be There.

Posted on Aug 28, 2009

  • 64 Answers

SOURCE: 1998 dodge ram 1500 Cruise control , speed

Look under the hood to check and make sure there is two steel wire cables connected to the throttle body. i had the same problem on my 02 dodge ram, turns out that just one of the cables came loose

Posted on Sep 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will not go in to four wheel drive


Dodge Ram 1500 Questions - 4WD not engaging all the ...

www.cargurus.com > Questions > Dodge > Ram 1500

CarGurusOct 18, 2013 - to get it into 4LOW is to 1st get it into HI and then stop and shift it intoLOW. ... I have a 98 Dodge Ram 1500 that I can not get the 4 wheel drive to ... what web site can i go to so i can see how the inside looks on timing gears.

Diagnosing 4WD Engagement Problems on Dodge Ram ...

dodgeram.org > Main > Tech > Maintenance
Nov 1, 2000 - This shift will be easier if you momentarily release the accelerator pedal. Apply a ... Do not attempt to shift to or from 4L while transmission is in gear or clutch is engaged. ... OK, now when you shift into 4WD it gets a little more complicated. .... I have a 97 RAM 1500 Club Cab Sport 4 X4 and I am having

2008 Dodge Ram 1500 Won't Engage 4 Wheel Drive: 20 ...

www.carcomplaints.com/Dodge/Ram_1500/.../drivetrain/wont_engage_4...
Ram 1500 Won't Shift Out Of 4 Wheel Low - Ram got locked into 4 wheel low. Found this ..... It would not go into full time 4 wheel drive or go into 2 wheel drive.

Software Update and Axle Disconnect Actuator ... - RepairPal

repairpal.com > Problems > Dodge > Ram 1500

Feb 08, 2016 | 2004 Dodge Ram 1500

1 Answer

2011 dodge ram 1500 jerks hard going into passing gear when you get on it.


check engine or tranny dash light come on when this happens. Check codes??

Dec 08, 2015 | Dodge Cars & Trucks

1 Answer

How to fix ram 1500 2005 transmission that sometimes gets stuck in 3rd gear. from start to finish truck will stay in 3rd gear.


When did you last replace trans filter and fluid? Dirt may be causing shift valve to stick.

Dec 28, 2014 | 2005 Dodge Ram 1500

1 Answer

Dodge ram 1500 reving up and down


sounds like your tranny. it could be slipping, it could be shifting in and out of over drive, or passing gear.

Feb 21, 2010 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

A/c not blowing hard


the blower motor may be bad but check the blower resistor,if its bad it will work only at low speeds.

a04982b.jpg
this is what it looks like

Sep 08, 2009 | 2005 Dodge Ram 3500

1 Answer

Transmision acting rashinal,


Dodge had a lot of transmission problems like yours so I would check with the dealer to see if there are any recalls for your ram.

Jul 24, 2009 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Dodge ram 1500 engine rpms surge at freeway speed


those sensors could cause the issue, clean the MAF 1st, also clean the idle system using the following procedure, the IAC can cause cruise surge. I use this to cure these problems all the time.

Here is the most common cause of surges and stalls and low idle, it is the idle speed control air-bypass valve (IAC) and throttle valve, they get full of gunk over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Jan 13, 2009 | 2001 Dodge Ram 2500 Truck

1 Answer

Noise from middle to front of truck, when in 4WD at slow speed


If you are driving on pavement or solid surface in 4 low you will get a heck of a noise. Should only be used for slow off road, or pulling stumps. 4 hi is used for snow, rain etc.

Jan 09, 2009 | 2004 Dodge Ram

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

200 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...