Question about Ford E350

Open Question

I have a 1989 Ford E350 cube van with the 5.8 fuel injected engine. Recently it started ahving issues with ppower loss when I step on the gas. At first is was only hard acceleration now it is when eve

Slight noise from in tank fuel pump, van only has 43K on the clock.

Posted by on

  • Wayne Swingle Jan 09, 2013

    I have four codes with this, 21, 31, 24, and 63

  • Wayne Swingle Jan 10, 2013

    I have a code 63 and 31, if I replace the egr and the throttle position sensor should this correct the problem or should I look for something else first.

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: Tremendous loss of power when A/C is turned on as well as hesitation and bucking on acceleration.

fuel pump possibly?

Posted on May 21, 2009

Ad
rnb_tnt
  • 111 Answers

SOURCE: 1979 chevy step van 350 new fuel pump rebuilt carburetor wont sta

remove the fuel line from the carb, put it into a bottle, crank the engine, If the bottle has fuel in it the fuel pump is working properly, if not, check the filter, and the fuel lines to the tank!!!

Posted on Nov 02, 2009

Lloyd Six
  • 560 Answers

SOURCE: 95 Nissan Maxima with fuel injection issue.

Could be battery, starter or coolant sensor.

It is hard to understand / get across engine noises with words so difficult to diagnose over the net but try to push start the car and let me know if it starts ok with a push. Also, maybe try a jump start, preferably using a circuit protector if you have one.
Let me know results of the above.

Lloyd

Posted on Dec 05, 2009

Testimonial: "Very good results. Diagnosed the issue with 2 questions."

tribrach
  • 1 Answer

SOURCE: 2001 ford windstar van (fuel pump)

changing fuel pump on my 2001 ford windstar van....trying to replace pump only not whole housing like i'm used to...i'll post results

Posted on Jan 02, 2010

ftw1952
  • 10319 Answers

SOURCE: I have a 1988 Ford F250 with the 460 engine and

The fuel pump relay and the oil pressure switch as well. The oil pressure switch runs power to the fuel pump when you first start it
When the oil pressure reaches operating range the relay takes over
They are both inexpensive so replace both of these parts to be safe and kill two birds with one stone. If one goes out the other will soon enough

Posted on Mar 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel injector not working ford e350


Are they getting gas?... if so bad injectors maybe clogged
If no pressure to fuel rail then clogged fuel filter or bad fuel pump

Sep 02, 2014 | Ford E350 Cars & Trucks

2 Answers

So I have a ford 97 e350 ambulance. I finally got the engine codes they read p0308 and p1662. Showed up at the same time. The truck ran rough, turned engine 9ff, back on, idled fine, and then a few mi utes...


cylinder 8 is missing combustion which caused the o2 code the black box will not cause a specific cylinder to miss, there fore a fuel distribution problem is evident, the injector on eight is proablly the culprit the #8 cylinder is the last cylinder to be fed a fuel, pressure test is needed to determine if the fuel pump is strong enough to deliver diesel, ambulance spend a lot of time idling causing fatigued fuel pumps

Nov 08, 2013 | Cars & Trucks

1 Answer

Ford E-350 2001 V-10 gas. 70k mi. - problem developed suddenly, no gradual lead up. - runs rough, stalls both driving or sitting idle, seems to surge a little i.e. surges above idle rpm while sitting. was...


Check your fuel vapor recovery system, your van has unusual set up, and the effect is RAW fuel gets purged, rather than vapor.
The dead giveaway test is does the issue happen on light acceleration? Does it stop if you let off the throttle? Can you accelerate harder and "get past" the issue?

Dec 12, 2010 | 2002 Ford E350

1 Answer

Have ford e-co-van 1 ton 350 series, 460 engine.1989


Ethanol really causes problems in cars that sit around.Thanks for us going green huh?It decomposes non-metal parts in the gas system.If the car sits around for something like 6 weeks the gas does go bad.You have to siphon the tank as much as possible.When filling up,add octane boost first then gas.It still may not work though.I did all that for a scooter and it still didn't work.So if you try it,when you add gas,probably only use 4 or 5 gallons,so you don't waste too much money if it doesn't work,and it is enough to mix the octane boost fairly well.Good luck bro'!That's all i have for now.And gas is gas no matter where you buy it.All those additives the companies claim clean this or that is just sales.Since fuel injection came out,companies are required to add a certain amount of detergent to keep injectors clean anyways.And 93 octane is not better than 87 octane enough to pay 20 cents more per gallon.

Jul 22, 2010 | 1989 Ford F 350

1 Answer

I have a 1990 ford econoline van e350 that would not start, we replaced fuel pump and fuel injector, still nothing then we replaced the ignition module and still can't get it started


I have a 1989 E350 that had the same problem. I finally found that I had corroded connectors under the hood. There was a group of 5 connectors behind the air cleaner housing under the hood. Two of them had hot wires that feed the computer and the injectors. Repaird these and the van starts right up. Hope this helps.

Jan 28, 2010 | Ford E-350 Cars & Trucks

1 Answer

1989 ford f150 loss of power


1989 is fuel injected, on the intake there is idle air control valve, make sure this is not dirty, also you may want to check the coolant temperature sensor, if the engine thinks it is warmer then waht it is the fuel air ratio will be off and your truck will run bad.

Jul 15, 2009 | 2000 Ford Focus

2 Answers

Can't find fuel filter on 2004 ford e350 van


Should be on inside of frame just behind the driver door. You will need the tool to pull off lines.

May 08, 2009 | 2007 Ford E-350 Super Duty Length XLT

1 Answer

Engine wont run when reved up


sound like you have a bad senser. it would be a good i dear to have it scanded. i would check the fuel presher. you may have got a bad fuel pump

Apr 07, 2009 | 2002 Ford E350

1 Answer

Sputtering wont start no power


most likely a fuel filter problem. try takeing a rubber mallet {not steel} and pound on the bottom of the gas tank. this will sometimes dislodge whatever is clogging the filter screen. Your engine fuel injected and needs a certain amount of pressure to operate correctly. You can have a repair shop do a pressure test on the system.

Dec 27, 2008 | 1989 Ford Aerostar Cargo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...