Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
YEs but if you are going to do some secrifice on your luck of car model from front,
otherwise its impossible,
you can get this from older car dealer or service center,
Posted on May 20, 2008
The tail lights and the brake/turn lights use the same bulb but, there is 2 filamants in the bulb. One for tail lights and one for brake/turn lights. So just because the brake lights and turn signals work doesn't mean the bulbs are good. If bulbs are good you can check to see if there is power getting to the tail light assy's by unplugging the connector at the assy and using a test light probe the connector (harness side) with the headlights on. If you are getting power to the assy the test light will light. To make sure, turn off the headlights and test light will go off. Hope this is helpful. Good luck.
Posted on May 29, 2009
Running lights in front sides of vehicle short out in time. I simply disconnected the plugs found inside the front wheel wells and packed them with grease for time being. When the weather improves I will find the chaffed insulation and repair. Replaced the 15amp fuse found under the hood and shwing, back on the road.
Posted on Jan 31, 2010
do you have a hole in the piston or gasket? If in the piston it is most likely from coolant or water. If water, could be a cracked head, or being sucked in through the intake and building up in the 6th cyl. I have a lexus that had a hole in the side of the motor and noon could figure out why. I pulled the head and found water... Put new block in and egr codes came up. Pulled EGR and found it was sucking in water, due to an exhaust leak that was allowing condensation to build and would not blow out once in the egr tube. If you face the same problem (hole in block) I am going to say too much compression. Could be from head gasket not being torqued properly and leaking cooland, cracked head, or wrong spark plugs-and worst case scenario which I have yet to witness, bad spark plug gap. Not likely on your car, i would think.
Posted on Mar 29, 2010
Tips for a great answer:
Mar 12, 2016 | Cars & Trucks
Jan 08, 2016 | Nissan Cars & Trucks
Apr 13, 2015 | Cars & Trucks
Jul 11, 2017 | 1999 Toyota Camry
Apr 23, 2012 | Nissan Navara Cars & Trucks
Mar 23, 2011 | 1997 Nissan Maxima
Nov 26, 2010 | 2005 Nissan Frontier
Sep 30, 2009 | 1987 Nissan Pickup
38 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: