Question about 2006 Chevrolet Cobalt

Open Question

2009 chevy cobalt suspension diagram

Front wheel drive diagram

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
awcforever
  • 359 Answers

SOURCE: Front end Chevy cobalt loud squeak?!

If you have the time, take the vehicle to an autoshop of your choice, and ask them to grease all fittings on the front end. My car did the exact same thing, it was the ball joints. You may need a new ball joint, but being a 2009, I highly doubt it unless its been in an accident or something. There are grease fittings on the front, I believe there should be at least 5, maybe more, but the sound you are experiencing is the equivalant to a pogo stick if I'm correct. Hope that helps.

Posted on Mar 13, 2009

Ad
  • 1 Answer

SOURCE: Noises problem 2006 Chevy Cobalt 4 cyl Front Wheel Drive Automati

Have a mechanic check lower control arm bushing at the rear of the control arm.It is a horizontal bushing retained by a vertical bolt clamping it to frame.The tire will move more forward and back more than it should during braking. canuck mechanic.

Posted on May 07, 2009

  • 10 Answers

SOURCE: I need to remove the front headrest of a 2008 chevy cobalt lt

Push the button and pull up on it at the same time

Posted on May 25, 2009

Cycoman
  • 81 Answers

SOURCE: Key won't turn in 2008 Chevy Cobalt. Tried moving

now what it sounds like is the key has a sensor built in it the keys cost around 60.00$ but this is most likely what is wrong. the sensor is a security feature with the car if the light glows while trying to turn the car then this your problem :)

Posted on Mar 23, 2010

  • 335 Answers

SOURCE: Chevy cobalt noise knocking in front end when you

Hello and welcome. this noise is normally caused by a noisey steering I-shaft. there is a steering shaft that goes in between the steering column and the steering gear. this shaft has a slip joint that becomes noisey. all you need to do is lube the i-shaft with some special lube and you will be good to go

Posted on Sep 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the pcb relay for low beam on 2009 chevy cobalt


Here is a link to the diagram that will show you where the relay you seek resides.
http://www.bing.com/images/search?q=2009+cobalt+headlight+relay+location&view=detailv2&qpvt=2009+cobalt+headlight+relay+location&id=800012CDB9A3904873F6257AF5F40147424F9222&selectedIndex=7&ccid=9Z06veV%2b&simid=608010999078125730&thid=OIP.Mf59d3abde57e21c7e1f681f1ae307de5o0&ajaxhist=0

Sep 02, 2016 | 2009 Chevrolet Cobalt

1 Answer

2008 chevy cobalt violent vibration arouhd 55mph ok below and above speed have replaced joints tires struts, vibration still there


Warped rotors or out of balance tires can cause this. Have you had a front-end alignment after putting these steering/suspension parts on? When replacing these parts IT IS CRITICAL TO HAVE ALIGNED. Also, Have you checked condition of front HUB/WHEEL BEARINGS?

Nov 14, 2013 | Chevrolet Cobalt Cars & Trucks

1 Answer

Check transmission fluid 2005 chevy cobalt


Cobalt has a front engine front wheel drive layout. The transaxle has a dip stick that can be accessed from by opening the hood. The dip stick has markings on it indicating full/half//low oil level.

Jul 11, 2013 | Cars & Trucks

1 Answer

Suspension problem in chev cobalt 2006


Have the tire checked for a separated internal steel cord, also for any signs of a bent wheel. Most tire shops will do this inspection for free.

Feb 10, 2012 | 2006 Chevrolet Cobalt

2 Answers

Front end Chevy cobalt loud squeak?!


If you have the time, take the vehicle to an autoshop of your choice, and ask them to grease all fittings on the front end. My car did the exact same thing, it was the ball joints. You may need a new ball joint, but being a 2009, I highly doubt it unless its been in an accident or something. There are grease fittings on the front, I believe there should be at least 5, maybe more, but the sound you are experiencing is the equivalant to a pogo stick if I'm correct. Hope that helps.

Mar 13, 2009 | 2009 Chevrolet Cobalt

6 Answers

Noises problem 2006 Chevy Cobalt 4 cyl Front Wheel Drive Automati


Have a mechanic check lower control arm bushing at the rear of the control arm.It is a horizontal bushing retained by a vertical bolt clamping it to frame.The tire will move more forward and back more than it should during braking. canuck mechanic.

Mar 11, 2009 | 2006 Chevrolet Cobalt

Not finding what you are looking for?
2006 Chevrolet Cobalt Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...