Question about Cars & Trucks
2 wires from maf for temp control go to ecm . I need to find these wires in the pcm
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Save your money, the chip is a ohm resistor at Radio Shack for under $2.00. It splices in to you IAT wire harness located at the intake tube between the air filter housing and throttle body.
Problem with this system is, that you can not adjust anything and have to run a constant 91 octane just to make sure you do not have a Detonation. The ECM will catch the Detonation from the knock sensor and compensate for it by retarding the timing which in turn lose of HP till next start up.
If you like and don't mind the check engine light on once and awhile, you can do the same by just disconnecting the IAT wire harness which give the ECM a 0 resistance thinking it's -20 out side and turn the timing up and lengths the injector pules.
When i was running a Nitro in the Toy before i sold it, i had installed a 10K ohm Potentiometer which you can buy at radio shack for under $5.00 i believe, I just spliced it in to the IAC wire harness so if i wanted to play with the Nitro I'ld turn the resistor up making the engine think it's 185 degrees F and would ****** the timing so i would not hurt the engine. But if i wanted to get more timing i would just turn the knob to drop the resistance to get more time since the engine thinks it's -20 out side.
Hope this helps. Keep me posted if you need more info. Best thing is to do a dyno tune and you can change everything right down to the Shift points.
Posted on May 29, 2009
SOURCE: Hello, 2004 Ford Escape XLT
Hi, below is a picture of your MAF sensor. There are 6 pins visible in the connector. Does your sensor have only 5 pins? Maybe one has broke off. The second picture is the wiring diagram for the MAF/IAT assembly. The IAT is the thermister on the right side of the diagram and uses the pink wire with a black stripe and the orange wire. Is this what you needed?
Posted on Aug 14, 2011
Tips for a great answer:
Jul 03, 2017 | Pontiac Grand Prix Cars & Trucks
Aug 08, 2016 | 2002 Ford Escape
Apr 23, 2016 | Chevrolet Suburban Cars & Trucks
Apr 30, 2013 | 2004 Honda Civic
Nov 01, 2012 | Cars & Trucks
Aug 02, 2011 | 2002 Ford Escape
Mar 03, 2011 | 2002 Ford E350
Apr 01, 2010 | 2004 Ford F150
Oct 13, 2009 | 2005 Ford Escape
87 people viewed this question
Usually answered in minutes!