Question about Cars & Trucks

1 Answer

On my 2000 grand prix the power cord that run to my starter is torn can it be replace and how

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Spread the Word:

    An expert who has shared 5 answers on their Facebook wall.

  • Expert
  • 120 Answers

It would be best to replace the cord as it might be corroded and will have high resistance. Cut the piece which is chaffed and get copper connector and add a joint.

Posted on Jan 08, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

taran_2005
  • 10515 Answers

SOURCE: where is the starter located in a 2000 grand prix

Hi,

If it is a V6 the starter is at the bottom front of the engine. The front of the car has to be raised to access it from underneath. This is best done when the engine is cool.

Hope i helped you.

Thanks.

Posted on Sep 08, 2009

  • 52 Answers

SOURCE: 1998 pontiac grand prix starter

disconnect the negative battery terminal first then disconnect the positive treminal so there are no accidents, raise the car safely go underneath & remove the starter cover should be 3 10mm bolts holding the cover on then remove the 2 through starter bolts 15mm then disconnect the + battery cvable from starter then disconnect the solenoid wire should be a 7 mm bolt. good luck

Posted on Sep 11, 2009

  • 1075 Answers

SOURCE: how do you replace a torn driver's side power

wheel off /steering turned hard left /loosen trackrod end and remove/open both clips remove boot and replace .adrian,,,,

Posted on Jun 25, 2010

duane_wong
  • 6826 Answers

SOURCE: How to Replace the Starter in a 1999 Pontiac Grand

starter is located on the engine block down below.

Removal & Installation To Remove:
Before servicing the vehicle, refer to the precautions in the beginning of this section.

  1. Remove or disconnect the following:
    • Negative battery cable
    • Radiator lower air deflector
    • Torque converter cover
    • Electrical connections from the starter
    • Starter motor
To Install:
  1. Install or connect the following:
    • Starter motor and torque the bolts to 32 ft. lbs. (43 Nm)
    • Starter solenoid BAT terminal
    • Starter solenoid S terminal
    • Torque converter cover and torque the bolts to 89 inch lbs. (10 Nm)
    • Radiator lower air deflector and torque the bolts to 15 ft. lbs. (20 Nm)
    • Negative battery cable
Starter removal/installation – 3.1L & 3.4L engines 9306zg15.gif

Starter removal/installation -3.8L engine 9306zg17.gif

Posted on Jul 15, 2010

  • 1 Answer

SOURCE: power windows in 2000 grand prix

driver side window stopped working motor works all other windows work

Posted on Sep 13, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2000 pontiac grand prix starter will not disengage after starting and keeps trying to start with ignition turned off


You either have a defective starter drive or the flywheel has damage teeth. Remove the starter and inspect it and the flywheel.

May 11, 2016 | 2000 Pontiac Grand Prix

2 Answers

How do i bypass security on 2001 Grand Prix that has ignition torn out


You can physically Hot wire it, but the theft system will stop you from driving it. You can read/learn about a bypass system here. http://www.diy-gm-security.com/

25608737-tjuc4yuqtyhwy1g5ckyd5etn-4-0.jpg

Mar 26, 2015 | 2001 Pontiac Grand Prix

1 Answer

Plenty of power turn key car just clicks 1999 pontiac grand prix


have you checked power and signal at the starter motor, the large wire @ the starter will have battery voltage at all times and the smaller "signal wire" will have power only when the ignition cylinder is being cranked, if both ok then you will have a stuck/seized solenoid on the starter . lightly tapping the starter motor while "cranking " will sometimes allow the vehicle to start.

Oct 22, 2013 | 2000 Pontiac Grand Am GT

1 Answer

2002 grand prix front tires are wearing out on the inside tread ?


It could be either the ball joints or the tie rod ends are worn out. With it being a front wheel drive car also check your drive axles. Make sure that the axle boots are not torn or cracked which if they are cracked or torn replace them and repack the cv joints.

Jun 28, 2012 | 2000 Pontiac Grand Prix

1 Answer

Starter of 2003 pontiac grand prix


It's a little unclear exactly what you are wanting. Are you wanting to know how to replace the starter? In any case, it would be helpful to know which engine your 2000 Pontiac Grand Prix is equipped with.

Jun 16, 2012 | 2000 Pontiac Grand Prix

1 Answer

How do you replace a torn driver's side power steering boot on a 2000 pontiac grand prix?


wheel off /steering turned hard left /loosen trackrod end and remove/open both clips remove boot and replace .adrian,,,,

Jun 25, 2010 | 2000 Pontiac Grand Prix

1 Answer

2000 gran am has electrical power but only clicks once when turn the key. is it the starter or ????


Charge or replace your battery. It sounds like there is not enough power to crank the starter over. Usually starters make a grinding noise when they go bad.

Dec 21, 2009 | 2000 Pontiac Grand Prix

1 Answer

Where is the starter located in a 2000 grand prix


Hi,

If it is a V6 the starter is at the bottom front of the engine. The front of the car has to be raised to access it from underneath. This is best done when the engine is cool.

Hope i helped you.

Thanks.

Sep 08, 2009 | 2000 Pontiac Grand Prix

2 Answers

Front end vibration


this is most often caused by worn out drive axle constant velocity joints or CV joints as we tech's call them, have them checked for torn boots or excessive wear, I am sure one or both will be found.

Jan 06, 2009 | 2000 Pontiac Grand Prix

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...