Question about 2007 Acura TL Sedan New Cars

Open Question

I want to change the differential fluid in my 2007 Acura TL

What are the torque settings for both the drain and vent/fill plugs? Also what is the fluid capicity of the differential? May I use a synthetic like Amsoil 75W/90 and a slip-lock Differential Additive?

Posted by on

5 Suggested Answers

  • 14 Answers

SOURCE: how to change spark plugs on 2005 acura tl

Hi,

you need a 6 inch extension, short 3/8 ratchet, 5/8 plug socket, 3/8 swivel "u" joint, (sold at sears) 8mm 1/4 drive socket deep well and 1/4 inch ratchet.

find the coil packs (6 total, three in each head.)
remove the two retaining nuts holding each coil pack using 1/4 8mm socket and ratchet.
twist the pack to break the sticking boot below.
pull up (be careful to not rip the boots however it may still happen but rare.)
remove coil packs, the rear is a little more difficult with the intake.
use 6" extension and u joint and ratchet to remove plugs and replace.
reverse order to assemble. Good luck, and hoped this helped.

Posted on Jan 04, 2009

  • 66 Answers

SOURCE: rear differential leaking

Gear lube is SAE 75W-90 GL-5 gear lubricant. If you have a limited slip diff, add 4 oz of limited slip additive.
Torque cover to 15-20 ft-lbs.

Posted on May 21, 2009

tneubauer
  • 437 Answers

SOURCE: What is torque specification for rear end differential cover bolt

8.8 Axle = 28-38 ftlbs

7.5 Axle = 18-28 ftlbs

moz-screenshot-1.jpgmoz-screenshot.jpg

Posted on Jun 10, 2009

  • 9 Answers

SOURCE: How to reset the maintenance code B12 on a 2007

hold the reset button for 30 secs then will enter a new screen press the rest one more time than done

Posted on Jun 14, 2009

66 chrgr
  • 1011 Answers

SOURCE: Can I run 80W-90 top-off for limited slip rear end

yes you can ,this actually perfect.

Posted on Aug 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Changing rear end oil


Most rear differentials, it's a drain and refill operation.

SOME differentials have a drain plug, but others have ONLY a fill plug.

If yours doesn't have a drain plug, then you need to suck the old fluid out, with suction/transfer pump:

http://www.harborfreight.com/gear-oil-and-fluid-pump-61746.html

You can also use this to refill with the new fluid.

Most rear ends are filled to the bottom of the fill plug hole.
If you overfill, just let it overflow/drain until it stops dripping.

Now, different differentials require different fluids, so check what you need.
It might be in the owner's manual.

May 31, 2014 | 1993 Lincoln Town Car

1 Answer

How many qts of oil do i need


Depends on your engine.

1980 JEEP CJ-7 2.5L 4-cyl Engine Code [B]
CAPACITIES
Engine, GM without filter..........2.4 quarts[1]
Wix Filter ........ 51040
Cooling System, Initial Fill..........8.0 quarts
Automatic Transmission, A904, 30RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, A999, 32RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, Total Fill
3 speed A999, 32RH..........8.4 quarts
3 speed A904, 30RH..........7.0 quarts
Manual Transmission, 4-SPD, SR-4..........3.0 pints
Manual Transmission, 4-SPD, T176..........3.6 pints
Differential, Front..........2.5 pints[3]
Differential, Rear..........4.9 pints
Transfer Case,..........4.0 pints

1. Add extra oil when replacing filter. After refill check oil level.
2. With engine automatic transmission operating temperature, shift through all gears.
Check fluid level in NEUTRAL and add fluid as needed.
3. 1984-1992 Models with command-Track, add 5 oz of 75W-90 GL-5 to shift motor housing opening.

TORQUES
Oil Drain Plug.....25 ft-lbs
Manual Transmission T176
Fill Plug.....15 ft-lbs
Drain Plug.....15 ft-lbs
Manual Transmission SR4
Fill Plug.....20 ft-lbs

1980 JEEP CJ-7 4.2L 6-cyl Engine Code [C]
CAPACITIES
Engine, without filter..........5.0 quarts[1]
Wix Filter..... 51522
Cooling System, Initial Fill..........11.0 quarts
Automatic Transmission, A904, 30RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, A999, 32RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, Total Fill
3 speed A999, 32RH..........8.4 quarts
3 speed A904, 30RH..........7.0 quarts
Manual Transmission, 4-SPD, SR-4..........3.0 pints
Manual Transmission, 4-SPD, T176..........3.6 pints
Differential, Front..........2.5 pints[3]
Differential, Rear..........4.9 pints
Transfer Case,..........4.0 pints

1. Add extra oil when replacing filter. After refill check oil level.
2. With engine automatic transmission operating temperature, shift through all gears.
Check fluid level in NEUTRAL and add fluid as needed.
3. 1984-1992 Models with command-Track, add 5 oz of 75W-90 GL-5 to shift motor housing opening.

TORQUES
Oil Drain Plug.....30 ft-lbs
Manual Transmission T176
Fill Plug.....15 ft-lbs
Drain Plug.....15 ft-lbs
Manual Transmission SR4
Fill Plug.....20 ft-lbs

1980 JEEP CJ-7 5.0L 8-cyl Engine Code [H]
CAPACITIES

Engine, without filter..........4.0 quarts[1]
Wix Filter..... 51258
Cooling System, Initial Fill..........13.0 quarts
Automatic Transmission, A999, 32RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, A904, 30RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, Total Fill
3 speed A904, 30RH..........7.0 quarts
3 speed A999, 32RH..........8.4 quarts
Manual Transmission, 4-SPD, SR-4..........3.0 pints
Manual Transmission, 4-SPD, T176..........3.6 pints
Differential, Front..........2.5 pints[3]
Differential, Rear..........4.9 pints
Transfer Case,..........4.0 pints

1. Add extra oil when replacing filter. After refill check oil level.
2. With engine automatic transmission operating temperature, shift through all gears.
Check fluid level in NEUTRAL and add fluid as needed.
3. 1984-1992 Models with command-Track, add 5 oz of 75W-90 GL-5 to shift motor housing opening.

TORQUES
Manual Transmission T176
Fill Plug.....15 ft-lbs
Drain Plug.....15 ft-lbs
Manual Transmission SR4
Fill Plug.....20 ft-lbs

Oilman

Feb 02, 2013 | 1984 Jeep CJ7

1 Answer

Does a 1500 sierra 4x have a rear drain plug


I assume you are talking about the rear differential. There is not a drain plug. Two ways you can change fluid - 1) Remove differential cover, let fluid drain, reseal with rtv, and tighten down. To refill there is a plug that you need to remove, fill until fluid comes out the hole. 2) Use a device to **** fluid from fill hole, then refill.

Mar 28, 2011 | 1994 GMC Sierra

1 Answer

What is the fluid capacity of the gear oil in a 1997 nissan 5 speed 2 wd truck


CAPACITIES
Engine, 2WDwithout filter..........3.5 quarts[1]
Engine, 4WDwithout filter..........4.0 quarts[1]
Cooling System, Initial Fill..........8.5 quarts
AMSOIL Antifreeze and Engine Coolant
Automatic Transmission, Total Fill..........7.4 quarts
Manual Transmission, 2WD..........4.2 pints
Manual Transmission, 4WD..........8.4 pints
Differential, 2WD Rear..........3.2 pints
Differential, 4WD Rear..........2.7 pints
Differential, Front..........2.7 pints
Transfer Case,..........4.6 pints

1. Add extra oil when replacing filter.
refill check oil level.

TORQUES
Oil Drain Plug.....22-29 ft-lbs
Transfer case
Fill Plug.....18-25 ft-lbs
Drain Plug.....18-25 ft-lbs
Manual Transmission
Fill Plug.....18-25 ft-lbs
Drain Plug.....18-25 ft-lbs

Oct 17, 2010 | 1997 Nissan Pickup

2 Answers

How do you add transmission fluid to a 2000 town country


The tranny fluid is added through the tranny dipstick (make sure it's not the oil dipstick). Fluid color should be red and the dipstick should have instructions on how to check level (car in park, engine at idle). Funnels are your friend here.

Jul 26, 2010 | 2000 Chrysler Town & Country

1 Answer

My 2007 Acura TL is having an air conditioning issue... The air is coming out cold from the two vents on the driver's side, but the air coming out of the passenger's side vents is very warm. The air on the...


Navigation has no relevence at all. but what does is the vent system in the dash.there is a flap inside the vents under the dash it sounds like it is not moving on the passengers side.

Jul 30, 2009 | 2007 Acura TL Sedan New Cars

2 Answers

Where do i put the differential gear oil


Front Differential Oil Change dd7e0eb.gif
  1. Before changing or inspecting oil, be sure to stop engine and lift vehicle horizontally.
  2. With vehicle lifted up, check leakage. If leakage exists, correct it. NOTE: Whenever vehicle is hoisted for any other service work than oil change, also be sure to check for oil leakage.
  3. Remove oil filler plug (2).
  4. Remove drain plug (1), and drain old oil.
  5. Apply sealant to thread of drain plug (1), and tighten it to specified torque.Tightening torque Differential oil drain plug a: 23 Nm (2.3 kg-m, 17.0 ft. lbs.)
  6. Pour new specified oil until oil level reaches bottom of oil filler plug hole (3) as shown in figure. NOTE:
    • Hypoid gear oil must be used for differential.
    • It is highly recommended to use API GL-5 80W-90 gear oil.
Differential oil specification: API GL-5 (For SAE classification, refer to viscosity chart [A] in figure.)

Differential oil capacity (Reference): 0.9 - 1.1 liters (1.9/1.6 - 2.3/1.9 US/Imp. pt.)

  1. Apply sealant to thread of level / filler plug, and then tighten it to specified torque. A: Sealant 99000-31260SUZUKI Bond No.1217G Tightening torque Differential oil level / filler plug b: 23 Nm (2.3 kg-m, 17.0 ft. lbs.)

Jun 04, 2009 | 2007 Suzuki Grand Vitara 4WD

2 Answers

Servicing tranny


DONT DO IT! It has Toyota W/S fluid in it, its a lifetime fluid that doesnt have to be changed. If you can tfind a dipstick, dont touch your drainplug. It requires a complicated procedure that requires dealer only tools

Aug 23, 2008 | 2006 Toyota Tundra

1 Answer

Changing the transmission fluid


Once you've drained the transaxle by removing drain plug, re-install drain plug and torque to mfg. specs. To fill transaxle, you need a 5/8" square drive attached to a 9" extension, breaker bar or ratchet. Raise vehicle on hoist, or jack up and secure with jackstands. The fill plug is located above and slightly to the right of the location where the passenger side c.v. halfshaft enters the transaxle. Remove fill plug. Using a fluid exchange tool available at your local parts store, fill with automatic transmission/transaxle fluid available only from a Suzuki dealership, (part# ESSO LT 71141) until fluid starts to run out of fill hole, then replace fill plug, and torque to manufacturer specifications. I'm a former Suzuki technician. I hope this was helpful.

Aug 02, 2008 | 2007 Suzuki Forenza Sedan

Not finding what you are looking for?
2007 Acura TL Sedan New Cars Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6864 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...