Question about 2007 Nissan Xterra S

Open Question

2007 nissan xterra cam sensor location

Cam sensor location

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: nissan xterra knock sensor

It's the valley of the engine underneath the intake manifold. It's about an $800 job because the top of the engine has to come off. However, unless you have a supercharged xterra it shouldn't effect performance. Also, the knock sensor will not trip the check engine light, as it does not indicate a primary problem, so if your light is on you should have another code that should be fixed first.

Posted on Nov 24, 2008

  • 1 Answer

SOURCE: knock sensor

You have to take the entire intake manifold off upper and lower. you will find it on the main block after you take the lower manifold off.

Posted on Jun 03, 2009

SOURCE: WHERE IS THE CAM POSITION SENSOR LOCATED ON A 2004 NISSAN MAXIMA

WHEN YOU STAND ON THE FRONT OF THE CAR YOU ONE IS RIGHT BELOW OF THE INTAKE WHICH IS BANK 2 OR THE ONE CLOSE TO FIREWALL , BANK 1 ONE IS ON SAME SIDE NEXT TO THE RADIATOR BUT THEY BOTH ON THE CAM RIGHT SIDE OF THE ENGINE, THE EASIEST WAY TO IDENTIFY THEM IS THAT THEIR CONNECTOR IS GREEN, ONCE YOU LOCATE THEM THE CLIP NEEDS TO BE PUSHED DOWN TOWARD THE SENSOR FOR THE CONNECTOR TO BE RELEASED, ONCE YOU REMOVE THE CONNECTOR THERE WILL BE ONLY A 10MM SCREW HOLDING THE SENSOR PULL IT OUT , THE SAME SETTING THE NEW ONE PUSH IT ALL THE WAY IN , THIGHT THE 10MM SCREW, CONNECT IT BACK AND YOU'RE DONE,BUT FOR THE ONE ON THE BACK SOMETIMES MIGHT BE NECESARY FOR YOU TO TAKE THE INTAKE OFF....HOPEFULLY IS NOT YOUR CASE....



Good luck!!! and if you need the crank for hard starting on hot/warm, it is located on the botton middle section on the transmission is the only cable that goes down to a small piece of metal and it is held by a 10mm screw only to protect the sensor, you will se the sensor once you remove that small about 6-8 inches piece of metal. Then you'll be able to unescrew the 10mm screw that holds the crank position sensor. when you pull it off you'll be able to see the fly wheel inside the transmission...



you all enjoy your rides out htere!!!

Posted on Jul 01, 2009

techbuster
  • 5081 Answers

SOURCE: where is the knock sensor for the 04 nissan xterra

Your knock sensor is located undernesth the air intake manifold on top of the engine block. This goes for 2000-2004 xterra V6 3.3L models.

Posted on Nov 05, 2009

ZJLimited
  • 17970 Answers

SOURCE: Diagram available for 01 Nissan Xterra Knock Sensor location?

V6 3.3L The sensor is located underneath the air intake manifold on top of the engine block. This should take an experienced mechanic about 3-4 hours to replace.

9bd8ec7.jpg

Fig. Engine compartment component locations

Hope this help (remember rated this free help) Good luck.

Posted on Feb 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of fuel pump relay switch on 2007 nissan xterra


Location of fuel pump relay Leslie, Fuel pump relay is above drivers right knee, under dash.
Links below are manuals to your problem.
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
http://www.nicoclub.com/FSM/Xterra/2007_Xterra/ec.pdf
http://www.nicoclub.com/FSM/Xterra/2007_Xterra/pg.pdf
2007 fuel pump relay

Mar 27, 2016 | Nissan Cars & Trucks

2 Answers

Have a 2000 xterra code comes up p0340 says camshaft position sensor.when i go to the dealer they say it has no camshaft position sensor plz help


Hey Travis here is the compleat definition of code P0340=
NO CAM SIGNAL AT PCM , NO FUEL SYNC. YOU CAN TRY THE AUTOZONE LIBRARY FOR MORE INFO. there is more to it than sensor not being there. check the power control moudel.

Oct 24, 2014 | 2000 Nissan Xterra

1 Answer

Where are the sensor located on a xterra truck it is a 2004


The cooling sensor is located on the intake , when you go to autozone for the replacement part ask for a diagran of its location.

Nov 23, 2013 | Nissan Cars & Trucks

2 Answers

Picture/location of crankshaft position sensor 2003 nissan exterra


The location is in back of the engine on the top of the transmission3_17_2012_9_03_53_pm.jpg

Mar 17, 2012 | 2003 Nissan Xterra

1 Answer

Need to replace camshaft on 1999 nissan xterra


Cam Position sensor its in the distributor and there is no way to get the sensor except to replace the distributor.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Feb 10, 2012 | 2000 Nissan Xterra

1 Answer

Could you tell me where the camshaft sensor goes for a 2001 nissan xterra 3.3L V6


the cam shaft sensor is inside the distributor
the distributor is located at the front of the engine
any more questions ill be glad to help

Jul 17, 2010 | 2001 Nissan Xterra

3 Answers

Diagram available for 01 Nissan Xterra Knock Sensor location?


V6 3.3L The sensor is located underneath the air intake manifold on top of the engine block. This should take an experienced mechanic about 3-4 hours to replace.

9bd8ec7.jpg

Fig. Engine compartment component locations

Hope this help (remember rated this free help) Good luck.

Feb 08, 2010 | 2001 Nissan Xterra

1 Answer

Where is the knock sensor for the 04 nissan xterra located?


Your knock sensor is located undernesth the air intake manifold on top of the engine block. This goes for 2000-2004 xterra V6 3.3L models.

Nov 05, 2009 | 2002 Nissan Xterra

Not finding what you are looking for?
2007 Nissan Xterra S Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14251 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...