Question about Tata Cars & Trucks

Open Question

Tata indigo cs blower not working in first three levels

The car blower is not working in first three levels but working in its fourth level

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 41 Answers

SOURCE: 2004 Dakota dashboard heater blower problem

It seems that the electronic heater control is bad.

Posted on Sep 14, 2008

  • 3854 Answers

SOURCE: Yukon a/c blower doesn't work on low settings

I really think the Blower resistor is at fault.
It is located on the Passenger side, directly next to the blower motor.
It has a 7 or 8 wire connector from controller,  and then the 2 wires coming out for the motor.
They are VERY common problem.
2 small screws holding it in.
easy fix.
Part SHOULD cost in the $40-$50 range Depending on which Auto parts store you go to, Auto Zone will have this part and can give you the step by step instruction to get the job done. 
Hope this helps.
Good Luck

Posted on Jun 29, 2009

  • 295 Answers

SOURCE: blower for ac/heat only work on lower 3 levels.

Check the blower motor resitor. Use a 12v test light at the switch and notice the bulb brightness change as you switch settings.. Probably have a bad blower resiter.

Posted on Jul 07, 2009

  • 60 Answers

SOURCE: 2003 Chevy Silverado AC blower only works on 5

Hi some of them are a pain ,but if your paitient you'll get it ,they are normally held in by 3 7/32nd bolts just remove the connector and remove the screws and it will come out ,if the floor insulation under your carpet gets in the way I usually carfully take a utility knife and cut out a small square to allow more room to pull it down and out ,depending on the placement of the resistor.

Posted on Aug 08, 2009

  • 2 Answers


i had the same problem with mine there is a bleed down solenoid on the side of the air pump this can stick and let the air the pump is pumping straight to the outlet i cleaned it and chacked the spring and it now works fine

Posted on Sep 27, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I lost my remote for my Tata indigo and I bought a new one. How do I program my new remote?

Hi Nothando, It should work as soon as you put the batteries in.... CHEERS

Mar 31, 2016 | 2007 Tata Indigo 1.4

1 Answer

Where is the thermostat housing on a Tata Indigo station wagon 2006

There can only be two places and they are located on the engine at the upper radiator hose or the lower hose. Some thermostats are built into the waterneck and may not appear like the thermostat. Im sorry I work on so many different vehicles and cant give exact location.

Oct 08, 2015 | 2007 Tata Indigo 1.4

1 Answer

How to override immobilliser Tata indigo?

if you cant find it on google. you may have to take it to a dealer.

Jul 25, 2014 | 2007 Tata Indigo SW

1 Answer

Tata indigo 1.4dsl

Sorry we have no diagrams or manuals.

May 25, 2014 | 2007 Tata Indigo 1.4

1 Answer

Tata indigo vehicle valve timing setting procedure

Valve timing setting procedure of tata indigo vehicle

Dec 20, 2013 | Cars & Trucks

1 Answer

P1200 tata indigo cs dicor

Starting that morning and coling time problam. What reasion

May 11, 2013 | Tata Cars & Trucks

1 Answer

Tata indigo dicor trouble code p1200

what is thep1200 troble code in tata indigo cs dicor

Feb 10, 2012 | Tata Indigo Cars & Trucks

1 Answer

I have a ford focus 2000 and is not blowing hot air from the first three levels only the fourth level works what is the problem?

You need to replace your blower resister.......... The blower resistor is located behind the glove box in the back left corner, follw the wiring harness to the resistor. there is one screw that holds it in place ( a little hard to get to ) unscrew and remove from connector. part is $15 but call different dealers because they price differently. PS squeze the sides of the glove compartment to drop the glove box down
I hope this helps you and please vote on this solution

Dec 30, 2009 | 2000 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

302 people viewed this question

Ask a Question

Usually answered in minutes!

Top Tata Experts


Level 3 Expert

76109 Answers

old marine
old marine

Level 3 Expert

1985 Answers

David Harrelson
David Harrelson

Level 3 Expert

5316 Answers

Are you a Tata Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides