Question about 1993 Nissan Quest

1 Answer

Someone tried to break into my Nissan quest'93 and now the sliding door is all messed up AKA does not shut all the way causing my battery to die all the time cause the lights stay on, i have to co

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Nissan Master
  • 42,218 Answers

There is probably something bent and not allowing the latch to connect easily. It may be possible to readjust the mechanism or door tracks. probably best to have apanel beater look at it

Posted on Jan 08, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: sliding door won't close. 2004 nissa quest

Mine was doing the same thing. I took it in and watched them fix it and first they steam cleaned the area under the floor where the rollers are. Then they took a spray and lubricated the rollers and the track where the rollers are. then they cleaned the brass connectors on the side of the door where the safety pins touch. I could have saved ALOT of money doing this myself. I hope this helps!

Posted on May 12, 2009

  • 7 Answers

SOURCE: 1995 Nissan Maxima alarm system

Hey, I bought my 1995 Nissan Maxima GLE brand new back in July 1994 with factory installed alarm, it just doen't make any sound when you arm or disarm it with remote. The only way you can tell whether it is armed or disarmed is from the lever position of your doors and the blinking red light under the dash. Only the newer versions of Nissan/Infiniti's has the "Audio/Silent" mode button on the remote which allows you to activate/deactivate you car alarm with an audiable sound or no sound at all. No worry, there is nothing wrong with your remote or car alarm.

Posted on Jun 27, 2009

mpurai
  • 14 Answers

SOURCE: Does the nissan quest 1999 timing belt needs to be

The Quest has a non interference engine meaning that should the belt break the engine would just die without breaking anything. Nissan recommends 105K for changing but that depends on the way the vehicle was driven (driving habits), road conditions etc. If driving on roads for e.g. that are hilly, it labors the engine more thus shortens the lifespan of the belt according to mfg.

Posted on Mar 18, 2010

  • 42 Answers

SOURCE: I have also broke off my 2001 Nissan Quest sliding

the child lock rod may have been extended...
open the driver side door, and with a skinny finger, push that child lock rod back in towards the rear of the sliding door
use the passenger side as reference
once you pushed it in, you can now open it from the inside handle

Posted on Jun 17, 2010

  • 7 Answers

SOURCE: Reprogram my 2004 Nissan Quest keyless remote w/sliding door

it diddnt work

Posted on Nov 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the rear sliding door interior panel on 2001 Nissan Quest?


Mostly clips, screws hold the handle on and bezel around it has clips that can carefully be pried off.. A door panel tool should be used to enage and pry panel clips off

Aug 22, 2014 | 2001 Nissan Quest

1 Answer

My sliding door hinge broke


if it will go back in the track reinsert it in and slowly close the door..and dont use until a replacement hinge is gotten from the towyard...

Jan 21, 2013 | 2000 Nissan Quest

1 Answer

My 1994 nissan quest dies when set on drive,,,or stalls really bad.


Engine stall or RPM fluctuates at idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Sep 16, 2012 | 1994 Nissan Quest

1 Answer

2004 Nissan quest battery drain


check your alternator to see if its charging fully,i think you will find this is the cause

Feb 14, 2010 | 2004 Nissan Quest

1 Answer

Driver Side Sliding Door Won't Open at All - 07 Quest


Either it has rusted up or the mechcanisim has been bent,take door panel off check it out if rusted use some wd40 work lock untill it moves.

Jun 19, 2009 | 2007 Nissan Quest 3.5 Minivan

1 Answer

2005 Nissan Quest automatic sliding door does not close


I would advise you check the guide area at the bottom where the door slides. There could be something lodged in the guide causing the problem.

Good luck!

I Can Fix It

Jun 11, 2009 | 2005 Nissan Quest

2 Answers

Im looking for a sliding door handle for a 2000 nissan quest van.


ebay has them all the time also, go here for help on Quests http://autos.groups.yahoo.com/group/villagerquest/

Jun 01, 2009 | 2000 Nissan Quest

1 Answer

Broken door handle - 2001 Nissan Quest SE


first you van order parts at discount from tascafordparts.com.
quest & mecrury villager are the same vehicle made at the same assembly plant. good luck to all. If you were in detroit area, I wold help you.

Trim Panel —Sliding Door Removal
  1. Remove the sliding door trim panel finish panel.
532ac84.gif 2. Remove the sliding door trim panel 2965fbe.gif Latch Remote Control —Sliding Door Removal
  1. Remove the rear sliding door trim panel. For additional information, refer to Section 501-05 .
  1. Position the watershield aside.
  1. If equipped, disconnect the sliding door power door lock actuator electrical connector.
f373e91.gif
  1. NOTE: Mark the position of the sliding door rear latch cable adjusting bracket before removing the bolt.
  2. Disconnect the sliding door rear latch cable.
  3. Remove the bolt.
  4. Remove the sliding door rear latch cable adjusting bracket from the latch remote control.
  5. Disconnect the sliding door rear latch cable from the latch remote control.
b8f2f32.gif
  1. Remove the 4 sliding door front latch bolts.
NOTE: If necessary, transfer parts to the new sliding door latch remote control.
Remove the sliding door latch remote control.
  1. Remove the bolts.
  1. Remove the sliding door latch remote control.
cb5ee71.gif
Handle —Exterior, Sliding Door Removal
  1. Remove the sliding door latch remote control. For additional information, refer to Latch Remote Control—Sliding Door .
  1. Remove the sliding door exterior handle.
    1. Remove the nuts.
    1. Remove the sliding door exterior handle.
0c820f3.gif

Mar 08, 2009 | 2001 Nissan Quest

Not finding what you are looking for?
1993 Nissan Quest Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...