Question about 1995 Toyota Camry
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
the thermostat is located driver's side of the vehicle. Follow the upper radiator hose to its end to a water outlet housing. the thermostat is in the outlet. take off the air flter lid and hose and it is easier to get to. take the hose off and the metal line to the housing. the other part of the housing is holding the thermostat. it is held with two 10 mm bolts. good luck.
Posted on May 26, 2009
Firstly, ensure you have the required 'mixture' of coolant/water (must have required coolant).
Second, I would recommend you re-test all the cooling system sensors again (make sure they're within specifications), in case a new one is faulty.
Third, ensure the new thermostat was of the correct temp setting (they all differ), so that it opens at the required time. Most cooling systems operate within 90 - 100degC.
Fourth, make sure the radiator (and associated hoses) aren't blocked.
If your temp gauge is reading higher than normal, but NOT in the danger zone...then this can be considered normal (especially if you've replaced with new components) and nothing to be concerned about.
However, if the temp gauge IS in the danger zone....then this suggests the coolant is not flowing through the cooling system properly.
If all above components test ok, then it's possible your water pump may not be pumping enough volume.
Posted on Aug 16, 2009
Testimonial: "I appreciate your help...Maybe I should just relace the water pump, that would be the last thing that I would need to replace."
This is better done when your engine is cold.
Park the car on a level fround.
Open the hood and remove the radiator cap.
Put a sizable container under the radiator and open its drain-plug.
(the drain-plug is by the radiator lower back wall).
Thermostat is in the inlet pipe held by three 10mm bolts that's attached to the engine block. (please note how it sitted)
Installation is reverse of removal. (replace o-ring around thermostat with a new one)
Posted on Nov 13, 2009
Tips for a great answer:
Mar 08, 2017 | 1995 Toyota Camry
Jan 12, 2013 | 1995 Toyota Camry
Jan 25, 2011 | 2000 Toyota Camry
Dec 31, 2010 | 1996 Toyota Camry
Jan 04, 2010 | 2000 Toyota Camry
Aug 16, 2009 | 1995 Toyota Camry
Dec 06, 2008 | 1995 Toyota Camry
168 people viewed this question
Usually answered in minutes!