Question about Cars & Trucks

Open Question

Were is locater torque converter clutch solenoid in 2001 honda accord ex 2.3 engine

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 132 Answers

SOURCE: Locationof the Torque Converter Clutch Solenoid

Your transmission should still work if the solenoid goes bad. It will just shift funny

Posted on Jan 30, 2009

Ad
emissionwiz
  • 77202 Answers

SOURCE: honda torque converter clutch solenoid circuit

P0740 is a Torque Converter Clutch Circuit Malfunction, you will need to have just this circuit tested, it is mostly just a defective Torque converter clutch solenoid in the trans or a defective connection to the trans, u do not need another overhaul.

Posted on Apr 06, 2009

  • 77 Answers

SOURCE: check engine reads P0740 honda civic

I am sorry to bum you guys out, but this usually means the piston in the torque converter is bad. The converter needs to be replaced along with a transmission flush.

Posted on May 26, 2009

philschneide
  • 448 Answers

SOURCE: ac compressor clutch relay 1991 honda accord

Difficult to describe, but I will give it a try.
Inside the driver's side fender, close to the front of the car, there is a bracket that is held in place by one bolt, but which has a short horizontal bar as part of it which has two large clips encircling two cylinderical devices which have wires clipped into them at the bottoms. The one closest to the front (radiator) is the compressor clutch relay. The other one is the condenser fan relay.
Hope this helps you find it.

Posted on Oct 20, 2009

  • 77 Answers

SOURCE: Where is the Torque Converter clutch solenoid

Actually, the Torque Converter Clutch Solenoid is located within the transmission housing that is easily accessible through the transmission oil pan. The TCC solenoid may vary in location dependent upon manufacture but generally it is located as aforementioned. It can cause your vehicle to stall if stuck open or close because it controls loads to the engine via your torque converter which is located between the vehicle's engine and transmission. Also, make certain that you attempt to change the transmission fluid and filter before changing the TCC solenoid because that may be your underlying issue. If not, simply reuse your fresh oil and change the TCC soleniod.

Posted on Dec 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2001 aurora and code p1860 p1860 came up what is this and how much to fix


P1860 All GM - TCC (transmission Torque Converter Clutch) PWM Solenoid Circuit Electrical.
P1860 Description The Torque Converter Clutch Pulse Width Modulation (TCC PWM) solenoid valve controls the fluid acting on the converter clutch valve. The converter clutch valve controls the TCC application and release. The solenoid attaches to the control valve body within the transmission. The solenoid receives ignition voltage through circuit 239. The Powertrain Control Module (PCM) controls the solenoid by providing a ground path on circuit 418. Current flows through the solenoid coil according to the duty cycle (percentage of ON and OFF time). The TCC PWM solenoid valve provides a smooth engagement of the torque converter clutch by operating during a duty cycle percent of ON time.
When is the code detected? When the PCM detects a continuous open, short to ground or short to power in the TCC PWM solenoid valve circuit, then DTC P1860 sets. DTC P1860 is a type B DTC.

Possible causes - Faulty Torque Converter Clutch Pulse Width Modulation (TCC PWM) Solenoid
- Torque Converter Clutch Pulse Width Modulation (TCC PWM) Solenoid harness is open or shorted
- Torque Converter Clutch Pulse Width Modulation (TCC PWM) Solenoid circuit poor electrical connection. Unless you have a factory manual and very good auto repair skills this is best left to an expert. It is a messy dirty job that requires removing the parts inside the transmission for testing..

Aug 23, 2016 | Cars & Trucks

2 Answers

I have been getting the code p0740 it says something about the torque converter clutch circuit. it doesn't seem to be going into over drive. dose anyone have any suggestions I can try.


On some cars, there is a TCC solenoid in the transmission which can be replaced by removing the bottom pan. In some cars this solenoid can't be accessed without major disassembly.

Jun 04, 2015 | Cars & Trucks

1 Answer

My 2003 Honda accord ex 4 cylinder will slip before hitting 3000 RPM and the transmission light is on any ideas of what's going on?


If it's a auto, the clutches are slipping. 1. it could be a shift solenoid 2. time for a transmission fluid flush 3. clutch packs are going out 4 torque converter going out. But with the problems I have seen with accords around that year, I would have to guess the clutch packs are going out

Mar 11, 2014 | Cars & Trucks

1 Answer

P0740 honda odyssey


P0740 Honda - Transmission Lock-Up Control System Fault Possible causes
- Low transmission fluid level
- Dirty transmission fluid
- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness is open or shorted
- Torque converter clutch solenoid valve circuit poor electrical connection

Tech notes
On some Honda vehicles the P0740 code may be set by an overheating torque converter problem which is caused by an insufficient flow to the torque converter release circuit.

P0740 Honda Description
The torque converter clutch solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module (ECM). Lock-up piston operation will then be controlled. When the torque converter clutch solenoid valve is activated, the torque converter lockup clutch will engage creating a 1 to 1 RPM ratio between the transmission input shaft and the rotational speed of the torque converter.
Lock-up operation, however, is prohibited when A/T fluid temperature is too low.
When the accelerator pedal is depressed (less than 2/8) in lock-up condition, the engine speed should not change abruptly. If there is a big jump in engine speed, there is no lock-up.

Dec 04, 2013 | 2000 Honda Accord

2 Answers

Honda Civic 2005 Check Engine Code P0741 Torque Converter or Stuck Off


Possible causes - Low transmission fluid level
- Dirty transmission fluid
- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted
- Transmission internal mechanical problem

Mar 01, 2011 | 1999 Honda Civic

1 Answer

2001 Pontiac Bonneville engine code: P0742 Torque Converter Clutch Circuit stuck on. How do I fix this?


Well you have to take transmission's valve body cover off and locate the torque converter clutch solenoid and take it off and change it if necessary. because without that solenoid your transmission will not survive for long. Good luck

Dec 14, 2010 | 2001 Pontiac Bonneville

2 Answers

Trouble code PO740 for 1998 honda accord lx 2.3 liter 4-cylinder


the common cause of this code is a shorted torque converter lock up clutch.

Jun 18, 2009 | 1998 Honda Accord

1 Answer

Honda torque converter clutch solenoid circuit


P0740 is a Torque Converter Clutch Circuit Malfunction, you will need to have just this circuit tested, it is mostly just a defective Torque converter clutch solenoid in the trans or a defective connection to the trans, u do not need another overhaul.

Apr 06, 2009 | 2001 Honda Odyssey

1 Answer

Check engine reads P0740 honda civic ex 2001... do i need to replace the transmission control solenoid?


I am sorry to bum you guys out, but this usually means the piston in the torque converter is bad. The converter needs to be replaced along with a transmission flush.

Jul 26, 2008 | 2009 Honda Civic

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...