Question about 2004 Chevrolet SSR

Open Question

How to remove 2006 door panel for chevy ssr

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

csmock132
  • 4669 Answers

SOURCE: remove door panel

Remove the screws and lift up. There aren't any screws behind the window switch, it is screwed on from behind. There is a hidden screw behind the lock slider.

Posted on Mar 01, 2009

  • 1 Answer

SOURCE: need to remove back door panel

first buy a tool from cdn tire or an auto store call "door panel trim pad" ....looks like a large bent screwdriver with a groove on the end ...this will allow you to successfully remove the 4 panel pins you will see after you take off the handle strap mechanism and the two rubber stabilizers on either side of the liftgate...then carefully pry back the panel on the side and you will see the first set of pins ...one per side ....wiggle the pad trim remover in so that it engages the pin above the moulded post on the inside of the panel and prey up on the tool...like a hammer removing a nail ...shouldn't have too much problem getting these off ...further up the panel again going in from the side you will see the other pins ...same procedure ....now all that is left are 5 snap in moulded tabs(part of the actual panel itself ...one on each side of the window frame position of the panel about halfway up the window ...use the tool again as a lever and they will come out easily ...hold on to the panel carefully as the remaining 3 tabs are in top of the frame portion of the panel and not much is supporting the panel now except you...they disengage pretty easily as well ...now the panel is off ...while you are in there put some extra padding on the speakers by dropping them down and putting 1/4 in foam tape on the inside lip of the speaker rim ...these rattle in cold weather ...when you are putting the panel back start with the top 3 tabs and the the 2 side tabs ,one side after the other ...then the panel will support itself while you direct the sabre ends on the pin fasteners into the holes in the metal door ...used my head to snap them in position ...then reinstall the stabilizer rubbers and the back strap ....hope it goes well ...nothing to be worried about after i did it once ,,,David Little Toronto

Posted on Apr 14, 2009

c17hydro
  • 2984 Answers

SOURCE: need to remove left rear door panel

  1. If equipped, remove the window crank handle by using a retaining clip removal tool.
  2. Remove the door handle bezel by inserting a flat trim removal tool between the door panel and handle bezel to release the locking tabs.
  3. Remove all door panel electrical connectors .
  4. Remove the door panel push pins and trim screws. Lift the door panel up and out to release the door panel locking tabs.

Posted on May 22, 2009

  • 122 Answers

SOURCE: how to remove rear door panel on 2002 chevy blazer

usually two screws one at the armrest and one under the power window console , this console usually pops out to let you at the screw.

Posted on Oct 27, 2009

dennymulford
  • 1055 Answers

SOURCE: installing door mirror,right side,2006 chevy impala,no heater

yes yo do should be 2 bolts in the arm rest too remove then the rest of the panel just clips on!!!

Posted on Nov 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remove and replace an outside door handle on a 2006 Chevy colbalt?


the following quote is taken from the web site from a chevy cobalt forum. if you have any more questions they might be able to help you directly.
(all it is is 2 bolts. Just take off your door panel and pull back the protective plastic and look for 2 bolts that line up with the door handle.)

How Do You Replace The Outside Door Handle Chevy Cobalt Forum Cobalt...

Jan 30, 2015 | 2006 Chevrolet Cobalt

1 Answer

Switch for 2006 chevy ssr "roof hall switch fault" ?


most times scrap yards have switches and relays at a good price

Aug 28, 2014 | Cars & Trucks

1 Answer

Chevy ssr problems


they have rusted to the hubs , get a large rawhide mallet and hit he wheels until they come off, when replacing clean up both wheel and hub surfaces and cover with copper slip grease to stop happening again

Jul 15, 2014 | 2006 Chevrolet SSR

2 Answers

How do I remove the door paneling from the passenger from my 2006 HHR


Here's a video that will show you exactly how to remove it from your car.

Aug 28, 2011 | 2006 Chevrolet HHR

1 Answer

Remove door panel on a 2005 SSR inside door handel does not work


Hello,
Please remove all screw covers from the door panel, then remove screws, carefully remove the door panel and disconnect the cables to the power windows and power locks before getting the panel away.
Thanks

Jun 02, 2011 | 2005 Chevrolet SSR

1 Answer

2006 Chevy Impala drivers side rear door stuck from outside and inside. How do I remove door panel with door shut?


here is a picture of the door panel components:acceptwha619.gif
those numbered 2 and 4 are screws 7 and 8 are plastic fasteners that should just pull out the door frame with an a little force outward on the plastic door panel.

May 03, 2011 | 2006 Chevrolet Impala

1 Answer

Is it a big job to install complete carpet set in the box of a chevy ssr


it is a pain in the rear, but if you have some experience, go for it...but a snazzy car such as that should be done at an upholstery shop.

Feb 26, 2010 | 2006 Chevrolet SSR

1 Answer

Installing door mirror,right side,2006 chevy impala,no heater


yes yo do should be 2 bolts in the arm rest too remove then the rest of the panel just clips on!!!

Nov 12, 2009 | 2006 Chevrolet Impala

Not finding what you are looking for?
2004 Chevrolet SSR Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...