Question about Cars & Trucks

1 Answer

89 f250 7.3 won't go over 35mph

Changed the fuel/water filter thinking that it was that but wasn't

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a 94 7.3 F350 that will not run until it warms up usually takes 10 to 15 min. I also have been running some lukas fuel injector cleaner through it and it is helping. Hope this helps

Posted on Jan 08, 2013


5 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: peugeot 306 won`t start off ignition

started car had only just gone around the corner and heard a burst sound then hissing thought it might of been radiator hose. stopped car checked main radiator hoses took radiator cap of released pressure ,but hissing continued sounded like it was coming from mid part of engine any ideas what it could be..

Posted on Nov 09, 2009

  • 2468 Answers

SOURCE: '89 suburban 5.8l.. acts like too much fuel to

check the O2 sensor in the exhaust manifold and the E.G.R. valve in the intake as these aid in how much fuel is introduced into the system through the computer system

Posted on Jul 18, 2010

SOURCE: 1998Chevy malibu won't start changed fuel filter

watch the lights on your dash.. if all the lights except the theft system go off then it has to do with your ignition.. they are a couple hundred to have installed here in Bama.. I took my dash apart and when I have a lot of problems I leave it open some so I can wiggle the wires on the bottom side of the ignition.. a cheaper thing would be call the chevy dealer and have them make you a new key from your vin.. and keep it weight free.. after they have some wear on them they do not work as well.. they fit kind of like a puzzle piece in the ignition and on one of the peaks on the key when it hits a certain place in the ignition switch it activates the " I OWN THIS CAR, SO CRANK" mode.. In my personal opinion they should have a recall on the dang things because the buyers are getting ripped off having to replace the ****.. For some reason though, a lot of the OEM wiring connections on GM's are faulty.. I still love my chevy though! Hope this helps!

Posted on Nov 05, 2011

  • 9 Answers

SOURCE: I have a 89 dodge lancer with out turbo it was

It could be the chrankshaft sensor or the egnition coils. check to make sure that your plugs are getting spark.Can be a lot of things but this is a place to start.

Posted on Feb 18, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

89 lancer wont start


Jul 21, 2013 | Mitsubishi Lancer Cars & Trucks

1 Answer

Fuel pump volvo 240

have you changed the fuel filter?

Jul 06, 2013 | Cars & Trucks

1 Answer

I have a 06 dodge ram 3500 cummins turbo diesel. I drained the water from the water seperater. The light on the dash went out but truck won't start still what else could be wrong? I had to push start...

Unscrew the filter canister and check for debris. If you haven't changed the fuel filter in a while it would be a good idea to do that as well.

Jul 01, 2013 | Cars & Trucks

1 Answer

89 f250 7.3 non turbo that has no power and the rpms will barely go over 2000 anybody know what could be wrong with it

Had the same problem. It turned out to be a bad copper seal on an injector. Unfortunately none of the test that I ran with the MT2500 SnapOn suggested this. It was just by chance that I found it.

Jan 21, 2013 | Ford F-250 Cars & Trucks

1 Answer

I've got an 89 cutlass suprem 2.8 it won't hardly

2.8 were nkow for computer problems in there early days.
Start with a compression check. fuel supply, then I would loo into compter or crank sensor, more likely the computer if it runs at all
But you have some testing before you spend any money

Dec 18, 2012 | Cars & Trucks

1 Answer

Have a 89 jeep Comanche starts but won't stay

If is fuel injected try checking the fuel regulator and if is has a carburetor possible bad choke or needle seat / worse case jump timing

Dec 19, 2011 | 2006 AMC Comanche

2 Answers

The car is lurching as I am driving. Could this be water in the gas, or even filter problems?

Yes. It sounds like your fuel filter is stopped up. Mine was doing that then I changed the fuel filter and it solved my problem

Sep 13, 2011 | 2001 Saturn SL

1 Answer

Hello. My 1997 Chevy Tahoe refuses to start. The problems began with a bad fuel pump. I changed. It worked. The fuel pump died again. I changed it again and it has been working. I parked it for two weeks....

Now you have a good battery & a starter that turns over the motor

Have you cycled the key on & off with a fuel pressure gauge on the
fuel rail?

Do you have a fuel filter that isn't over 3 or 4 years old?

Have you checked for spark while cranking ? Use an old plug on the wires,
if you have ignition wires,don't ground the wire without resistance

If you removed the ducting & MAF Sensor it won't start

Tell us what you checked & exactly how that was done.

Jun 09, 2011 | 1997 Chevrolet Tahoe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides