Question about 2007 Nissan Tiida 1.6

Open Question

How to reset computer on nissan tiida

I change plug and clean trottle body and the rpm keeps going up and down what could be the problem

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
SUPERMAN_B_1
  • 294 Answers

SOURCE: Idle jumping up and down

MAKE SURE WHEN YOU PLUGGED THE SPARK PLUGS IN THAT YOU GOT THEM IN THE RIGHT FIREING ORDER,ALSO MAKE SURE THAT YOUR THROTTLE BODY IS OPERATING NORMALY WATCH IT WHILE THE CAR IS RUNNING TRY MOVING THE THROTTLE BODY ROD BY HAND

Posted on Mar 07, 2009

Ad
  • 1 Answer

SOURCE: I have a 89 nissan 4x4

if its gas check ignition coil and contact point had the same exact problem and did replace a lot of parts before I was able to zero in on the main culprit which is the contact point

Posted on Jul 11, 2009

  • 1 Answer

SOURCE: 2003 nissan sentra se-r spec-v, started idle

i had a similar problem a few months ago with my se-r. i went to the dealership and had them reprogram the ecm and it fixed it(its on the recall list for your car.) once i did that everything ran great.

Posted on Aug 25, 2009

  • 226 Answers

SOURCE: i have a nissan altima 2003, got the the throttle

Debris must of gotten inside the IAC, start there

Posted on Feb 25, 2010

nicole99wu
  • 1049 Answers

SOURCE: Starting problem. Code found in

this is an obd2 trouble code table, it can help you understand the meaning of code. and for the p1615, you need to reset the code first, i know this tool is helpful for your car, hope help.

Posted on Jul 13, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

P1111 code on Nissan TIIDA 2007 Sedan was Diagnosed loosing power when driving.I was told about changing oil and cleaning the Intake Selonade valve.How do i clean it.


Try changing oil first. Intake Valve Timing Control solenoid is located on passenger side of engine bay, with an electrical connection on one end. It's held in by one 10mm bolt. It is inside the cover that goes over the camshaft pulleys. Don't use any oil additives, they can gum up the solenoid as it uses oil pressure to adjust your valve timing. If you remove solenoid, it can be cleaned with throttle body cleaner.
p1111-code-nissan-tiida-2007-sedan-31tyrtuzydbfleqvu5qtsvw1-2-0.jpg

Apr 22, 2015 | 2007 Nissan Tiida 1.6

1 Answer

I have got a manual tiida vehicle with a problem of idling uneven.


How is the clutch and pressure plates and shaft bearing this may cause idealing problem

Feb 14, 2015 | 2011 Nissan Tiida 1.8

1 Answer

Hi.My name is Alvin.I have a Nissan micra with error code p1171.When my is on lower gears or rev is under 1500,it switches off.


P1171 is not a nissan specific OBD2 code. are you certain that is the code you have recieved?

Sep 25, 2014 | Cars & Trucks

1 Answer

What can cause Nissan tiida 2007 not to accelerate?


run the fault codes as it appears that the engine /transmission has gone into limp mode and is restricting the rpm to prevent damage .

May 12, 2014 | 2007 Nissan Tiida 1.6

1 Answer

Reset idling on nissan tiida 1.6


my sensor light stays on and the car idles very ruff, what can it be

Mar 03, 2012 | 2007 Nissan Tiida 1.6

1 Answer

How to adjust idle on 94 eclipse


you should be able to adjust it by the trottle cable check under the hood and see if theres not two nuts holding your trottle cable in place if so ajust if need be. this is a easier way to increase your rpm at idle but you shouldnt be able to decre your rpms at idle this way. for that yu may have to look and see if there is a adjustment screw on your trottlebody that can increase and decrease your rpm at idle. if your have a low idle problem try cleaning the inside of your trottle body really good with a lint free rag and some trottle body cleaner also try cleaning your idle control vavle if cleaning your trottlebody didnt help.

Jan 22, 2010 | 1994 Mitsubishi Eclipse

2 Answers

Car will start but will not idle. If RPM's not


Possible low fuel presure at idle. If new fuel filter does nt fix , then it will
require a new "fuel pump". Have you driven this car on low fuel level often?

Nov 23, 2009 | 2003 Mitsubishi Eclipse Coupe

2 Answers

Code p0506 for mustang gt


change the throtle air idle valve on the inlet manifold.

Jul 24, 2009 | 2005 Ford Mustang

1 Answer

Idle jumping up and down


MAKE SURE WHEN YOU PLUGGED THE SPARK PLUGS IN THAT YOU GOT THEM IN THE RIGHT FIREING ORDER,ALSO MAKE SURE THAT YOUR THROTTLE BODY IS OPERATING NORMALY WATCH IT WHILE THE CAR IS RUNNING TRY MOVING THE THROTTLE BODY ROD BY HAND

Mar 07, 2009 | 2003 Nissan Altima

1 Answer

Idle 2001 mazda protege ES 2l


relpace the fuel rail pressure regulator

Dec 24, 2008 | 2001 Mazda Protege

Not finding what you are looking for?
2007 Nissan Tiida 1.6 Logo

Related Topics:

345 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...