Question about Cars & Trucks

1 Answer

How do I install a fob to a 94 buick le sabre

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 61 Answers

Are you're talking about the key Fob, which would go with your keyless entry system? All we're really getting is a short video showing your ALDL or diagnostic connector for onboard diagnostics.

Posted on Jan 08, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
greg_margo
  • 1959 Answers

SOURCE: procedure to repaloce rear shocks

Removal & Installation

  1. Remove the tire and wheel assembly.
  2. Support the control arm with a jack stand.
  3. Remove or disconnect the following:
  4. Electronic Ride Control (ELC) air tube from the shock
  5. Two bolts securing the shock to the control arm
  6. Trunk trim to gain access to the shock upper mounting nuts.
  7. Cover, the two nuts, and the reinforcement from the top of the shock
  8. Shock from the vehicle
01ccab9.gif

Here are links to more diagrams. Best of luck on your repair.
Greg


http://www.chiltonlibrary.com/content/images/7922/images/7922UG21.pdf

http://www.chiltonlibrary.com/content/images/7922/images/7922UG22.pdf

Posted on May 20, 2009

  • 29 Answers

SOURCE: Where is the egr valve in a buick le sabre

The EGR Valve on this 3.8 L engine should be in front of the throttle body on the drivers side of the engine just to the right of the front valve cover. If you locate where the intake tube/duct attaches to the throttle body and then move just a few inches toward the front of the car it should sit right in that spot. It will have two bolts attaching it to the intake/tube. Hope you find it!!

Posted on Jun 23, 2009

  • 850 Answers

SOURCE: HOW MUCH SHOULD IT COST TO REPLACE A FUEL PUMP IN

its just a gestament based on my experience with the cost of submersible electric tank pumps costing around $150 so allow around 200bucks for pump & labour although some pumps are over $300
Cheers rob.

Posted on Jul 28, 2009

  • 491 Answers

SOURCE: installing ignition module

Unscrew the ignition coil(s) from on top of the module...(leave plug wires attached)....and set aside noting coil position on module....unplug module and replace with a known working module.If there is grease under old module...transfer it to new module.Replace coil(s) and start her up.
TIP. While you are there,why not also change the crank sensor (if it not new).....it is THE trouble maker on these engines.

Posted on Nov 03, 2009

  • 16 Answers

SOURCE: i need a fuse box diagram

http://www.wiringdiagrams21.com/2009/07/13/1993-buick-lesabre-fuse-relay-and-circuit-breakers

Posted on Nov 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 Buick le sabre


It appears to be right above crankshaft pulley. Your lower radiator hose should go to the pump.
water pump-uidgvhs2br0zifoq3ysmidea-1-0.jpg

Jun 14, 2017 | Buick Cars & Trucks

1 Answer

What engines interchange with a 1998 Buick Le Sabre?


1996-2001 3.8 V6 gm motor designed for front wheel drive mounting.

Jul 20, 2014 | 1994 Buick Park Avenue

1 Answer

How to change the fuel filter in buick le sabre 1992


hi, this is an article and it shows you how to change the fuel filter in buick le sabre 1992.
if help, you can vote me. thanks

Jul 10, 2011 | 1992 Buick LeSabre

1 Answer

My horn quit working on my 94 Buick Le Sabre. i replaced the horn but still no sound. i cant figure out what relay is the horn


Hello: Remove the cover on the fuse box, on the inside there should be a key to follow. also check the fuse box under the dash for the same.

Jan 14, 2011 | 1994 Buick LeSabre

2 Answers

Serpentine belt diagram for 2003 buick le sabre


Since there is NO sticker under the hood of this 2003 Buick LeSabre and it is not in the owner's manual, a Google search revealed that it is the same as at http://www.fixya.com/cars/t3438653-change_serpentine_belt_1998_buick

8_1_2012_4_17_57_pm.jpg

Jul 11, 2010 | 2003 Buick LeSabre

2 Answers

93 buick le sabre transmission slipping


fluid low and possibily need of replaceing try this first. hope this helps?

Aug 25, 2009 | 1993 Buick LeSabre

1 Answer

Catalytic converter,1990 buick le sabre


The Catalytic Converter is part of the muffler system, and can be found between the rear of the engine and before the muffler on the exhaust system.

Aug 14, 2008 | 1990 Buick LeSabre

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...