Question about Plymouth Grand Voyager

1 Answer

Key is stuck in ignition.... not all the way in.... won't turn over ..... won't come out....what do you suggest....

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

I had the same problem on my car, but i drive a honda. Try pushing the key in, and turn it at the same time towards u. I did this once, and it worked.. after the key got stuck again a couple of days later. This second time i had to get the whole thing out (ignition switch). Took it apart, and changed the combination on the key. When this happens once, its most likely to happen again

Posted on Jan 20, 2009

6 Suggested Answers

  • 4 Answers

SOURCE: mitsubishi galant 2004 key stuck in ignition

1st Remove Battery cable from Battery because the only time the air bags will deploy is when the key is in the ignition. I have tilt steering and when I put the steering wheel in the up most position. I came right out. But now it seems to stick more lately.

Posted on Jan 02, 2010

  • 22 Answers

SOURCE: Ignition key won`t turn on my chrysler cirrus

tap the lock cylender with a small hammer it will free up the tumblers and the insert key and its working again.

Posted on Jan 08, 2009

polarcycle
  • 1392 Answers

SOURCE: key stuck in ignition Plymouth passenger Van 97

You need to find a way to replace the lock cylinder. Will the key tap in all the way to turn it? That would make it easier to get the cylinder out.

Posted on Mar 06, 2009

  • 69 Answers

SOURCE: ignition key won t turn. steering wheel locked

the key may be worn badly or the ignition needs to be replaced.

Posted on Jul 31, 2009

  • 55 Answers

SOURCE: 1997 pontiac grand prix key won t turn ignition

well does the key go in does it turn to the start pos? if the dash dost power up its because the switch is bad if it will power up but not start it can be becuse of the resitor chip depends on what is going on if you cant get power its becuse of the switch

Posted on May 09, 2010

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ignition of ford edge will not turn completely off..it is stuck in position 2 in auxillary power


1-
My ignition key will not turn to off. I can remove the key, but it stays in the accessory mode. What's the fix?
My ignition key will not turn to off can remove the key but it stays in...

2.
Ignition key is stuck and does not turn Inspection Service & Cost
Ignition key is stuck and does not turn Inspection Service Cost...

3.
Ignition key won turn

Aug 24, 2016 | 2012 Ford Edge

1 Answer

I have my key stuck in the ignition of my 2007 Buick Lacross. How do I get it out.


Sounds like the battery or the ignition switch has gone bad. The key won' release until the shift lock solenoid is energized to allow the key to turn all the way back.

Feb 23, 2015 | 2007 Buick LaCrosse CXL Sedan

1 Answer

Key won't come out of ignition on 1999 vw jetta


IGNITION KEY WILL NOT RELEASE

It can be faulty ignition lock cylinder. I suggest to wiggle the steering wheel a bit and see if the key gets released out. If that is not helping then first turn steering wheel to right and try removing the key, or next turn steering wheel to left and see if you can remove the key.

----------

Spray wd-40 in the ignition key hole and let it remain there for few minutes, after that once again try to remove the key and see if that helps.

---------

But if that is not helping then ignition lock cylinder has to be removed out and key has to be manually removed.

-----------

For more troubleshooting on these types of issues, I suggest you to refer the help links mentioned below. Its the accurate solutions mentioned in it. That will help you to narrow the problem: -----

Click the link below: ------


-----------

1999 Toyota Camry: Key Will Not Come Out Of Ignition?

http://whatisbyme.blogspot.in/2012/05/1999-toyota-camry-key-will-not-come-out.html

---------------

2001 Toyota Tacoma: Ignition Locked?

http://technoanswers.blogspot.in/2012/04/2001-toyota-tacoma-ignition-locked.html

------------

Ignition Switch Will Not Turn Off?

http://schematicsdiagram.blogspot.in/2012/04/ignition-switch-will-not-turn-off.html

-----------

Car will not turn the ignition to start?

http://technoanswers.blogspot.com/2012/01/car-will-not-turn-ignition-to-start.html

-----------

Ignition Key OFF but engine still running?

http://howtobyme.blogspot.in/2012/03/ignition-key-off-but-engine-still.html

--------------

Chevrolet Malibu: Key Stuck in ON position?

http://technoanswers.blogspot.in/2012/04/chevrolet-malibukey-stuck-in-on.html

2012 Dodge Ram: Ignition Key will not release?

http://whoisbyme.blogspot.in/2012/07/2012-dodge-ram-ignition-key-will-not.html

-----------

Ignition locked up on Mercury Villager?

http://technoanswers.blogspot.in/2012/01/ignition-locked-up-on-mercury-villager.html

-------------

Key won't turn in the ignition on Toyota land cruiser?

http://technoanswers.blogspot.in/2012/02/key-wont-turn-in-ignition-on-toyota.html

-------------------

How to remove ignition switch on VW Car models?

http://schematicsdiagram.blogspot.com/2011/12/how-to-remove-ignition-switch-on-vw-car.html

-------------

How to Replace Ignition Switch on Chevrolet Caprice Classic?

http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-ignition-switch-on.html

-----------------

1995 Ford Taurus: Ignition switch not turning OFF?

http://repairhelpcenter.blogspot.in/2012/06/1995-ford-taurus-ignition-switch-not.html

-------------

Ignition Problem Troubleshooting

http://whoisbyme.blogspot.in/2012/07/ignition-problem-troubleshooting.html

------------------

These will help.

Thanks.

Feb 15, 2013 | 1999 Volkswagen Jetta

2 Answers

2002 honda civic key stuck in ignition, won't start, shift lever stuck


Your Civic has immobilizer, which means it will not allow duplicate keys. There are high chance that your old keys are worn out and this could be the reason. Any ways i would suggest you how to remove the keys but involves bit technical work . The LHS dash board part can be unscrewed and removed fully using the car manual, once removed the key holder joints to 4 brace compartment and there is a button beneath it, you need to press the small red button to release the key. This is not a standard method of removal, if your car has security alarm make sure you turn it off.. please remember - this suggestion should be followed only if this is your car. I;m not responsible for the solution being incorrectly followed without following manual.

Jan 28, 2013 | 2002 Honda Civic

1 Answer

Stuck eldorado key in DTS ignition now car won't start


Make sure your steering wheel isn't locked. Sometimes a key won't turn until you jiggle the wheel while trying to turn the key.

Aug 21, 2012 | 2004 Cadillac DeVille DTS

1 Answer

My key is stuck in the ignition of my ML 320 2000 benz it will start and shuts off but I cannot get the key out any suggestions


Make sure shift lever is all of the way into the Park position. Also make sure that the steering wheel is turned to a position where it can be locked.

Chances are that the key is not turning far enough back to release. The 2 issues listed above are the most common reasons a key won't turn all of the back.

Good luck!

Aug 05, 2012 | Mercedes-Benz Cars & Trucks

1 Answer

I put key in ignition and it won't turn. Steering wheel will turn but key won't turn. We have 2 keys and neither will work. What can I do?


If the wrong key was inserted it may have bent a tumbler pin,maybe try some wd-40 or similar and work it with the right key,might drop the tumbler back,,if not the whole ign. cylinder will have to be changed

Jan 26, 2012 | 2007 Cadillac CTS 3.6L

1 Answer

2002 sunfire key stuck in the ignition (run) position, won't turn off, no gages working, and will not shift out of park. now the service and theft system lights are on


Sounds as if the ignition cylinder is bad. You will have to replace it if the key is stuck. It is a lot easier to replace with the key in the on position as that will be required to remove the cylinder. If you get the key out and then the cylinder will not turn, replacement of the cylinder will be more complicated

Dec 22, 2011 | 2002 Pontiac Sunfire

1 Answer

My key wont turn to off in order to remove my key from ignition while in parking


Ignition - Key Stuck In Ignition Switch/Won't Turn Bulletin No.: 06-02-35-005 Date: February 28, 2006 TECHNICAL Subject: Key Stuck in Ignition, Key Will Not Return to Off Position, Shifter Button Won't Release in Park Position (Adjust Shifter Detent Finger) Models: 2002-2005 Chevrolet Monte Carlo Condition Customers may comment on any of the following conditions: - The key is stuck in the ignition cylinder. - They cannot return the key to the off position to remove the key. - The shifter button won't release in the park position. Cause This condition may be caused by the detent finger shifting over time. This may result in mis-alignment and binding of the shift rod on the shift position guide.
WHERE YOUR SHIFTER IS YOU WILL HAVE TO TAKE IT APART ..MAYBE THE RUBBER BOOT IS IT THE WAY,OR THE SHIFT LOCK SELINOID WHENT BAD

Aug 05, 2011 | 2005 Chevrolet Monte Carlo

2 Answers

Key stuck in on posistion of 2004 envoy. Engine could not turn off. Had to unplug battery to turn off. Key still stuck in on posistion. Will not come out


Hello and welcome to FixYa!
As a first course of action, I strongly suggest that you spray WD40 on the ignition switch. This will help loosen the gearing, by then you can remove the key.
Hope this helps and thank you for using FixYa! Have a good one!

May 24, 2011 | 2004 GMC Envoy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

288 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6880 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...