Question about 2002 Hyundai Accent

Open Question

What is the light bulb size of the illumination lights in the dashboard behind the air conditioning controls?

The bulbs behind the air conditioning are blew out not sure of the correct size to replace them with

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 566 Answers

SOURCE: 2007 Hyundai Santa Fe - Replacing fog light

hi have not had pleasure of this on santa fe yet? but will try to help dependant of which side o/s or n/s ? i would first remove the screws holding the front of the under engine plastic cover/shield and drop down sufficient to gain view/access? to the rear of fog lamp then if a cover is on? try turning anti clock to remove? or if rubber cover pull off? then the bulb and clip should be visible? unplug the wire from bulb then the spring clip holding bulb in place normally just sring the 2x top ends together and swing down/clear to remove bulb? refit new bulb correctly! pay attention to position old bulb positioned? then clip securely and re connect wire at this stage it would be best to ensure bulb works ?? before you re assemble all else? wish you luck and hope this helps with your problem ?

Posted on Oct 28, 2008

  • 1214 Answers

SOURCE: bulbs keep burning out

When you replace headlights in today's cars, DO NOT TOUCH THE GLASS OF THE BULB!. Handle the bulb only with the packing material the bulb ships in, or with a clean dry cloth.The oils in your skin will cause premature failure of the bulb.

Also, check the sockets (car side) carefully to make sure they are not burned.

Posted on Feb 03, 2009

ghost4548
  • 776 Answers

SOURCE: Fog Light Bulb 2008 Elantra

Simple to do.

3624ae9.gif

5e693d8.gif

Posted on Jun 20, 2009

  • 1 Answer

SOURCE: need to replace dash board backlights - 2004 hyundai elantra

trying to do the same on my 01. ready to change the bulb but can't find it anywhere.
anyhow, here's how you do it:

remove the dash by taking out 2 screws behind the ashtray and 2 above the instrument cluster
begin prying off the dash from the ashtray up, when you reach the heater vents stop. next take a flat head screwdriver and pry off the dash from the left side with the door open. work left to right till you reach the heater vents and it'll come right off. you don't necessarily have to unplug any of the electric connectors if you don't want to, but you;ll have to reach around the dash while working. all you need to do now is remove the heater control unit via the 4 screws around it, then unplug the electric harnesses from the back of it. make sure you remember which goes where. the bulbs are the 3 white (or is it 2 white and 1 grey) circles on the back of the control unit. just turn them with a flathead screwdriver and turn it over and give it a little bump to get 'em to fall out (or grab 'em with a needle nose pliers if necessary). anyhow, that's how it's done, question is, where do ya find the bulbs?

Posted on Jul 10, 2009

  • 86 Answers

SOURCE: 2003 Hyundai Tiburon light bulb size chart

go to the public libary look at thier chilton manual for free copy the page you need for 10 to 15 cents.

Posted on Aug 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

One Brake Light Not Working


Inspect Brake Light Bulb: The number one reason for a brake light operation failure is a failed brake light bulb. To check this condition access the bulb by removing the rear cover located in the trunk or rear compartment. Some cars allow you to remove the entire brake light lens to retrieve the brake light bulb. Once the bulb has been removed inspect the bulb filament. If it looks broken or if the bulb is smoked the bulb needs to be replaced. If you have replaced the bulb but it still doesn't work remove the bulb. With the key in the "on" position have someone hold their foot on the brake pedal and use a grounded test light to carful test the terminals inside the light socket. One of the terminals should illuminate the test light. (Note: Do not touch the outer metal ring that holds the bulb in place for it is grounded and can blow the system fuse if connected to the inner terminals.) If the test light illuminates reinstall the brake light bulb. While the brake pedal is depressed test the outer metal ring that holds the bulb, if power is present the ground lead from the light socket is bad. If the outer ring does not illuminate the bulb has failed and replacement is required.

Scan BCM for Trouble Codes: Some cars are equipped with a body control module or BCM this onboard computer controls and lighting signals and can malfunction not allowing the electrical current to continue to the brake light circuits. This condition is rare but it can happen. If you have performed all of the tests above and all results are positive scan the BCM for trouble codes if no codes are present try replacing the BCM.

on Dec 18, 2009 | Honda Civic Cars & Trucks

3 Answers

How many bulbs on my 2001 camry dashboard?


I believe there are 6 general illumination bulbs plus 1 for each paticular warning/signal/trans signals-about 16 or so total

May 25, 2014 | 2001 Toyota Camry

1 Answer

How do I replace dashboard heater light? The glowing lights that indicate direction of air flow.


Heater light bulb, and all other bulbs for the air conditioning buttons, are on the same mini panel, and attached to the back of the radio front fascia. To dismount this fascia, you need 1) To pry out (no screws) the clock 2) Unscrew the one screw that holds the top of the fascia (screw is hidden behind clock) 3) Unscrew the two screws at the bottom of the fascia 4) Disconnect all connectors from the back of the fascia 5) Look for the burnt minibulb.
You could replace the bulb without disconnecting, but the cables are short, and the possibilities of marring your dashboard are high.

Jun 19, 2010 | 1999 Honda Accord

1 Answer

I have a 2000 Jeep Wrangler Trouble Symptoms: -When lights are on, brake lights (all three) remain illuminated and only flicker when brake pedal is depressed. Facts: -With lights off, dashboard lights...


sounds like wireing is shorted together. you need to trace down wires and check for bad spots in wireing. also be sure and check plug if you are set up for trailer lights.

Feb 13, 2010 | 1990 Jeep Wrangler

1 Answer

My dashboard lights do not come on when I turn the lights on.


CHECK YOUR HEADLIGHT SWITCH.THE DIMMER IN IT CONTROLS YOUR DASH LIGHT BRIGHTNESS

Jul 29, 2009 | 2001 Chevrolet Impala

1 Answer

Replace A/C illuminent light bulb


Youi have to remove the lower finish panel, and then the center finish panel, and then remove the heater control from its holder.

Oct 18, 2008 | 2003 Toyota Corolla

2 Answers

No lights on heater/fan panel.


Yes, there is illumination behind the heater control panel.

You need to remove the center inst cluster upper (radio) & lower finish (heater) panels to gain access to the heater control; the light socket is behind the heater panel.

Oct 06, 2008 | 1994 Toyota Corolla

1 Answer

How to replace headlight on a 2003 Chevy Tracker


There are two black plastic clips behind the the air filter, remove them and release the whole assembly to access the lights.

If you still get in troubles, have it replaced at a petrol station, they will help you in fitting the bulb, and it won't be expensive.


Here follows
2003 Chevrolet Tracker Light Bulb Size Chart
Low Beam Headlight Bulb Size: 9003/HB2
High Beam Headlamp Light Bulb Size: 9003/HB2
Parking Light Bulb Size: 1157A
Front Turn Signal Light Bulb Size: 1157A
Rear Turn Signal Light Bulb Size: 921
Tail Light Bulb Size: 7443
Stop Light Bulb Size: 7443
High Mount Stop Light Bulb Size: 168 Or 921
License Plate Light Bulb Size: 168
Back Up Light Bulb Size: 921
Front Sidemarker Light Bulb Size: 194
Ash Tray Light Bulb Size: 74
Step/Courtesy Light Bulb Size: 168
Trunk/Cargo Area Light Bulb Size: 168
Instrument-General Light Bulb Size: 158 or 74
Check Engine Indicator Light Bulb Size: 74
Hi-Beam Indicator Light Bulb Size: 74
Seat Belt Indicator Light Bulb Size: 74
Brake Warning Light Bulb Size: 74
Automatic Transmission Indicator Light Bulb Size: 74
Directional Signal Indicator Light Bulb Size: 74

Oct 02, 2008 | 2003 Chevrolet Tracker

Not finding what you are looking for?
2002 Hyundai Accent Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...