Question about 2001 Ford Escape
Battery starter relay is good but motor will not turn over on my 2001 food escape
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Even though I bought the vehicle new, there was an aftermarket security system installed. The system had a bad diode, so i removed the system and reconnected the factory wires.
Posted on Mar 30, 2009
No special tools as i recall. Can be tough had to get the door panel off in you never done before and the motor is in a tough tight area ...I bet if you take your time and common sense you be just fine ...
Posted on Nov 19, 2009
SOURCE: 2001 ford tarus will not start
You need to replace the starter solenoid that is on the starter it'selfWhile your at it remove the rear cover and then the dust cover from the brush holder and see if you should be replaceing the brushes as well.They should be about a half in long but won't need replaceind unti they're down to 1/8".
Posted on Nov 24, 2009
IT COULD BE THE STARTER NOT ENGAGING YOU CAN TAKE IT OUT AND BRING IT TO AUTO ZONE AND MOST LOCATIONS WILL TEST IT FOR FREE AND HOW DO YOU KNOW THE BATTERY IS GOOD DID YOU TEST IT IF NOT IT COULD BE THE BATTERIE OR THE ALTERNATOR AS IT WILL CLICK WHEN THEIER IS NOT ENOOUGH POWER TO TURN THE CAR OVER IT MAY HAVE STARTED YESTERDAY WITH NO PROBLEM BUT ALTERNATORS CAN JUST GO AND WHEN YOU GO TO STRT IT NOTHING TRY TO JUMP IT WITH CABLES IF STARTS BUT ONLY GOES SO FAR IT PROBLY THE ALT IF STARTS AND DRIVES FINE TILL YOU SHUT IT OFF PROBLY THE BATT MY 2002 MUSTANG GT LOST THE ALTERNATOR AND IT LEFT ME JUST CLICKING TO
Posted on Jan 19, 2010
check battery terminals for corrosion. clean with a wire brush. check starter terminals for corrosion and clean as nessarray. if the connections between the wire and terminal connectors are corroded you may need to replace that wire and terminals.
Posted on May 27, 2010
Tips for a great answer:
May 12, 2013 | Cars & Trucks
Sep 27, 2012 | 2010 Ford Escape XLT
May 15, 2012 | 2001 Ford F250 Super Duty Super Cab
Apr 15, 2012 | Cars & Trucks
Nov 07, 2017 | Ford Escape Cars & Trucks
Jun 21, 2011 | 2001 Ford Escape
Jun 12, 2011 | 2001 Ford Escort ZX2
83 people viewed this question
Usually answered in minutes!