Question about 2004 Pontiac Montana

Open Question

Remove center console from 2004 pontiac montana

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
dgjtex
  • 405 Answers

SOURCE: 2004 Pontiac Montana blows cold air in defrost

There is a mix damper inside your duct that controls the heat over heater core and ac evaporator that to your floor and one to your defrost. it is probable an electric actuator, that is not functioning properly. If yu can locate it and manually move it, you might have to remove the actuator motor first, you should be able to figure out your problem, I hope this helps! merry Christmas!

Posted on Dec 22, 2008

Ad
  • 1 Answer

SOURCE: low beam headlights not working on 2004 Pontiac Montana extended

You headlight lamp have a diffuser mechanism which allows it to flip between the hight beam and low beam feature of the bulb. In fact, you high beam will function even if the low beam is not working.

I would recommend the purchase of the new headlight lamp. It would cost you you any where from $15.00 per unit to get a replacement lamp

Posted on Jan 06, 2009

  • 1 Answer

SOURCE: how to put out the radio in montana 2003

there are 4 screws. two in the front behind the cup holder and two up underneath in the cupholder bay after the cupholder is removed. they are phillips head and 8mm I believe. this is all you need to remove the cover.

Posted on Jan 12, 2009

daves944
  • 1050 Answers

SOURCE: 2003 Pontiac Montana Front Wheel Bearings

Remove the wheel, remove the hub nut, remove the brake caliper and rotor, put your socket and extension through the hub flange onto the bearing retainer bolts, undo them, release the abs sensor connector if it has it, remove the bearing and hub flange as an assembly, put the new one on and go backwards from here. Torque the hub nut to 180 ft/lbs, your done.

Posted on Apr 08, 2009

SOURCE: Pontiac Montana '99 Water Thermostat removal

Yes, it can be removed and run without the thermostat. However, your gas mileage will suffer and the heater may not work very well.

Posted on Apr 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the ac expansion valve located in a 2004 Pontiac Montana


the expansion valve (TX valve) is located at the inlet side pipe of the evaporator under the dash

Sep 23, 2015 | 2004 Pontiac Montana

1 Answer

Can't find switch for rear windows on 2004 pontiac montana


Owner's Manual page 2-26 : http://www.vadengmpp.com/owners-manual/pontiac/2004-Pontiac-Montana.pdf

This switch, located in the overhead console switchbank, is used for opening and closing the power rear quarter windows. Press the textured part of the switch to open the windows; both windows will open. The windows will continue to open as long as the switch is pressed, until they are fully opened. Press the part of the switch with the symbol to close both windows. The windows can be closed fully or partially, depending on how long the switch is pressed.

Apr 17, 2015 | 2004 Pontiac Montana

1 Answer

My 2004 pontiac montana wont start, need help ASAP!


your shift cable is stretched or broke. try starting in nutral. if this doesn't work you need to adjust or replace shift cable. this is a very easy fix but it should start in neutral.

Mar 14, 2013 | 2004 Pontiac Montana

1 Answer

I need to replace the battery in my 2004 Pontiac Montana. It is mounted under a cross brace and the under hood fuse panel. Help Please!!


remove and reposition the underhood electrical center (fuse panel)
remove front end of the brace and loosen the other end
remove the _ and the postive cables from the battery
remove hold-down retainer (bottom of battery)
remove the battery

Jan 13, 2011 | 2004 Pontiac Montana

1 Answer

Where are the grease fittings on the front end on my 2004 Pontiac Montana


many vehicles no longer have grease fittings. This does not remove the need for lube, however. When items fail be sure to install aftermarket parts (like Moog) and they will have grease fittings.

Sep 03, 2010 | 2004 Pontiac Montana

1 Answer

My 2004 pontiac montana is heating up , I need to know where the thermostat is


Follow the radiator hose from the top of the radiator. It will end at a small cover with 2 bolts that hold it on. Remove the 2 bolts and the thermostat is under that cover.


Please Vote! Thanks!

Aug 31, 2010 | 2004 Pontiac Montana

1 Answer

Just removal of radio in my 2004 montana mini van


you have to remove the console storage box first and the ash tray there will be screws behind ashtray the top of the trim panel pops out has clips on the back side pry out with a flat blade screw driver and a rag to not damage dash then youll see the radio mount screws remove these and unplug radio

Apr 04, 2009 | 2004 Pontiac Montana

Not finding what you are looking for?
2004 Pontiac Montana Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...