Question about Cars & Trucks

1 Answer

2005 Nissan pathfinder won't accelerate when I push gas pedal down doesn't matter how far down I push it

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 4 Answers

Nissans are Infamous for MAF (mass air flow sensors)going bad. when they do you will get sympotoms as you described.
change that and it should be good

Posted on Jan 07, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: automatic transmission dipstick location for 2005 nissan pathfinder

The dipstick is located under the air cleaner on the right-hand side, identified by a yellow ring.

Posted on Jun 28, 2009

  • 41 Answers

SOURCE: hand brake nissan pathfinder

If you lift the hand brake you should find an adjustment nut (I think it is 10MM). Tighten that and you should be good to go. Be careful, it doesn't take much to adjust - turn gradually/slowly.

i hope i was able to help you with your problem! tc!

Posted on Oct 12, 2008

  • 5 Answers

SOURCE: sticky gas pedal

it is a dirty throttle plate. $280 is an absolute ripoff for a cleaning, it is about 10-15 minutes of work. They are probably quoting replacing the throttle body which about a $150 part.

Got to Autozone and get "CRC Throttle Body Cleaner". Remove aire inlet hose at throttle body with a screwdriver. Spray a *small* bit onto throttle plate, use clean rag or qtips to remove gum/varnish. Spray pivots and also clean around perimeter of the plate. Take it to an independent mechanic if you are unsure of the procedure.

Posted on Jan 13, 2009

  • 3 Answers

SOURCE: 1995 nissan pathfinder

You'll probably have to change the clutch plate on the flywheel. You'll have to get a floor jack, but a transmission jack is easier to remove the transmission. To remove the transmission you'll have to remove the tortion bars on both front wheels. Also, you'll have to remove the crossmember aft of the transfer case. You'll also have to remove the front and rear drive shafts. The manual says you should keep the transfer case from leaking oil out the back. but, you can just top it off after you're done. Be careful not to damage the seal seal for the rear drive shaft. Anyway, once you get the transmission and transfer case out (you'll have to remove the shift and transfer case levers), you should have enough space to remove the clutch plate from the flywheel on the engine. You should have an alignment tool to make sure the clutch plate is aligned with the crankshaft so you can put the transmission back on.

Posted on Feb 06, 2009

  • 2 Answers

SOURCE: rattle when accelerating

had the same issue, had someone look and it seems the noise was caused by heat shield being loose covering exhaust system. Have that checked out.

Posted on Feb 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why my car is not accelerating when i push down the gas pedal


This kind of cars the gas pedal is electronic, that means there is no metal cable to the carb. the first thing is check for any disconnected wire harness at the pedal or on the engine compartment at the throttle body everything looks fine the pedal could be defective

Nov 25, 2015 | 2005 Nissan Altima

1 Answer

1998 mercury cougar rx8 155000m Hi the few problems my car is having is when I first push in the pedal it has a hesitation and won't immedieatly accelerate. It'll finally **** and take off after...


ENGINE HESITATES WHILE ACCELERATION

LOSS OF ACCELERATION


It can be fuel pressure issue or it's the problem with accelerator pedal or its clogged filters causing there.

There are many other possibilities. I suggest you to go through the list of help links mentioned below, these will help you to confirm where the actual fault lies: -------

Jerks and Hesitates During Acceleration?

http://technoanswers.blogspot.in/2012/07/2004-dodge-town-country-jerks-and.html

-----------

Loss of acceleration?

http://technoanswers.blogspot.in/2012/02/loss-of-acceleration.html

---------

Headlights flickering and car hesitates to start?

http://howtobyme.blogspot.in/2012/02/headlights-flickering-and-car-hesitates.html

--------

How exactly the Vehicles Accelerator Cable works?

http://repairhelpcenter.blogspot.com/2011/11/how-exactly-vehicles-accelerator-cable.html

-------------

How exactly Vehicles Accelerator Pump Diaphragm Works?

http://repairhelpcenter.blogspot.com/2011/11/how-exactly-vehicles-accelerator-pump.html

--------

2000 Toyota Avalon: Engine Lean Codes and Knock Sound on Acceleration?

http://whatisbyme.blogspot.in/2012/05/2000-toyota-avalon-engine-lean-codes.html

---------

2004 Toyota Avensis: Acceleration And Deceleration makes noise on Front End?

http://whatisbyme.blogspot.in/2012/05/2004-toyota-avensis-acceleration-and.html

---------

Wheel hop under hard acceleration?

http://technoanswers.blogspot.in/2012/04/wheel-hop-under-hard-acceleration.html

--------

2009 Chevy impala accelerator pedal sensor?

http://technoanswers.blogspot.in/2012/02/2009-chevy-impala-accelerator-pedal.html

---------

Nissan Pathfinder stalls and bucks on Acceleration?

http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-stalls-and-bucks-on.html

--------

Acceleration lag problem?

http://repairhelpcenter.blogspot.com/2012/01/acceleration-lag-problem.html

-------------

These details will help.

Thanks.

Nov 28, 2012 | Cars & Trucks

1 Answer

Why can't I press down on my gas pedal?


yea check sensors and throttle body make sure nothen hitten and linkage free and clear hope helps

Oct 13, 2012 | 2005 Dodge Grand Caravan

1 Answer

1996 nissan pathfinder driver side window won't go up and down


does it click or grind when pushing window button if so the window lift track may need replaced, if there are no sounds then disconnect the wires from the lift motor and with the ignition on so power is sent to switch, push button and check wires to 12 volts dc. If no power I would replace the driver side switch after checking the wires for defects. If there is power then I would re-install wires to motor after turning off key and try button again with power on. replace motor if it doesn't work.

Dec 31, 2011 | 1996 Nissan Pathfinder

2 Answers

Have 2003 Nissan Pathfinder. Engine rattles under acceleration.


I would have to hear it. may be the engine mounts.

Nov 27, 2009 | 2005 Nissan Pathfinder

2 Answers

How do i solve a sticking accelerator on my 99 nissan pathfinder?


It will have to be lubed, but first find out what is sticking. Disconnect the cable from the pedal and work the pedal if it is free go under the hood and disconnect the other end work the throttle is it free. If the throttle and pedal are free the cable is binding or going bad. The best thing to do is replace the cable.

Nov 17, 2009 | 2005 Nissan Pathfinder

1 Answer

1993 Impreza bogs down


certainly chec gas flow and do tuneup--inspec trans for out of ajusment-seems like alot of miles on vehicle and gears may need inspection

Sep 08, 2009 | 1993 Subaru Impreza

1 Answer

Nissan terrano accelerator button, whats it do??


this is the kick down for the auto trans it kicks back a gear on acceleration

Apr 13, 2009 | 1993 Nissan Pathfinder

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...