Question about Cars & Trucks

Open Question

Kia rondo shifter light bulb replacement - Cars & Trucks

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: replacing gear shifter light bulb

As a warning, this is a little difficult and requires some patience. I just had to do with to my 2000 accord, and I'm betting the process is very similar for your '98 model. Before starting, you're going to want to get a Phillips head screw driver and a pair of pointy needle-nose pliers. The first thing you'll want to pop off it the driver's side fuse box cover. Under that you should see two screws towards the bottom that hold on the plastic trim that covers the underside of the steering column. This was held along the top with a few pins that should pop lose with a little effort (not too much force though!). There is one screw holding this piece in on the other side (holding it into the center console) but you wouldn’t need to remove this, you just need to get behind this piece of trim. Behind it, you should see two screws holding in the piece of trim that covers the side of the shifter. Take those out and it'll give you the little bit of wiggle room you're going to need. Lastly, pop off the black trim around the shifter. All you'll need to do is put something flat under it and gently pull up, working your way around it. This should pull off relatively easily. You should see the two wires leading to the bulb that will be located right in the middle on the driver's side. What you'll need to do is wiggle you're hand up under the side of the plastic side trim and grab the bulb. It will take a quarter turn to loosen it. Put the new bulb you have in the socket, wiggle it back in its proper place (don't forget to give it a quarter turn again to lock it in) and you should be set. Make sure you test the bulb before putting everything back together! I’m sure something doesn’t make complete sense in here, so if you need any clarification on anything in here, let me know!

Posted on Jun 14, 2009

  • 11 Answers


take it to tire shop have them use the tool to reset the sensors inside the tires. the sensors tell the computer when one tire is low.

Posted on Dec 15, 2009

  • 67 Answers

SOURCE: engine light came on kia 2007 rondo

you need to have the code read to see what it is most auto parts store can do that for free that will help use tell you what it is

Posted on Mar 04, 2010

  • 4977 Answers

SOURCE: Airbag light is staying on on Kia Rondo

you will have to have the code pulled from the SRS module(airbag) to know were to start to diagnose.

Posted on Jul 25, 2011

  • 6468 Answers

SOURCE: how do i change the bulb in a dome light 2007 rondo

the lens should just pry off

Posted on Aug 26, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

08 kia carens/rondo I need instructions on installing breaks & rotors

Check this video out and be ready to jot a few notes. It's really well done. Good luck! How To Replace Front And Rear Brakes On Kia Rondo

Jul 04, 2017 | Kia Cars & Trucks

1 Answer

2007 kia rondo brake light fuse keeps burning out. replaced the brake light switch already. any idea what would cause this? its a 15 amp fuse can i replace with a 20 amp? ty

yes you can but only if you want to burn the wire harness.
fuses burn to prevent damage to the harness and setting the car on fire and the correct fix is to find the dead short after the fuse
check that you have the correct bulbs in the stop lights because if a single point contact has been used in a double contact holder that is a dead short
check for damaged wires or screws that have cut through the wires

Jun 19, 2017 | Kia Cars & Trucks

1 Answer

Does my 2009 Kia rondo LX have heated seats? I've seen no buttons or indicator light for this feature but DEFINITLY felt the seat heating up, no question it was warming.

If equipped with heated seats, there will be a switch to control their function. Usually located near the shifter or mounted close to the center of the dash console or even located on the seat itself. Check owners manual for heated seat operation and controls

Mar 10, 2016 | Kia Cars & Trucks

2 Answers

Replaced roof dvd players side bulbs lights in kia sedona 07 plate now they only work when switched not automatically when door opens?

Kia Carnival & Sedona Forum [Archive] - Kia Forum - > Kia Forum > KIA Models
Jul 8, 2006 - [Archive] Discussion area for every generation Kia Carnival and Kia Sedona. ... 2006 SEDONA EX front and rear blowers dead · 2007 Kia Sedona LX 3.8L... out of the intercooler air intake · 2002 Kia Sedona Front heater will only work with a slap! ... 2003 Kia Sedona, Will Crank but not start after replacing MAF, crank and ... Kia Carnival & Sedona 2006+ [Archive] - Page 3 - Kia Forum
Apr 11, 2012
Kia Carnival & Sedona (2002 - 2005) [Archive] - Page 5 - Kia Forum
Jul 24, 2008
Kia Carens & Rondo Forum [Archive] - Page 2 - Kia Forum - Kia ...
Aug 15, 2007
More results from

[PDF]2006 Sedona Owner's Manual - Kia Canada Kia Motorsrecommended special tools, genuine Kia replacement parts and .... Room light main control switch.....3-123 ...... work properly, the power sliding door and ..... fuel only. • Check to make sure the fuel filler cap is securely closed after refu- .... roof, you have to reset your sunroof sys- ...... bulb check when you turned the ignition.

Jan 30, 2016 | Kia Cars & Trucks

1 Answer

How do I replace a brake light switch on my 2007 kia rondo?

It's located on the brake pedal. you'll need a 14mm wrench. There are 2 14mm nuts that sandwich the switch to the bracket. take the bottom nut off and the switch will come off. Install reverse of removal but you need to adjust the switch depth once its on the bracket. then snug the bottom nut and plug in the switch.

Aug 06, 2012 | 2007 Kia Rondo LX V6

1 Answer

The ESC off button of my kia rondo activates when brake pedal is pressed.

Rodos have an issue with the brake light switch which might cause the ESC light to turn on. Have the ABS system scanned, and if your car is still under warranty, then get the brake lights switch replaced.

Jan 28, 2010 | 2006 Kia Rondo

2 Answers

My kia rondo, driving ligths dont work , i have brigths, dimms, did check all fuses inside and engine

ur head lights are blown out but ur brights will still be good for a min but ya need to replace head lights positive

Jan 14, 2010 | 2007 Kia Rondo LX V6

2 Answers

2007 Kia rondo interior lights stay on when headlights turned on

I had the same problem for months. Finally took it to the dealer. The first time, they diagnosed is as a short in the rear interior bulb, and put in a new bulb. Got it home and still had the same problem.

The second time in, they figured things out. On the dash to the left of the steering wheel is a knob that controls the brightness of the dash lights. But, if this knob is all the way on, it turns on the interior lights and keeps them on. Just had to turn this knob down, and the problem was solved!

Jan 27, 2009 | 2007 Kia Rondo LX V6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides