Question about 2005 Hyundai Getz 1.3

Open Question

Engine check light comes on intermittently when starting and car seems to misfire

Engine check light comes on when starting the car, however it does go out sometimes after a few seconds. During this period the engine appears to misfire and stagger but will clear IF engine check light goes off. The car was Mot'd only a couple of weeks ago and has not been used apart from local shopping a couple of times. Any suggestions?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75197 Answers

SOURCE: Check engine light

they most likely left something disconnected like the O2 sensor, that is common and saw it allot at my shop.

Posted on Apr 23, 2009

emissionwiz
  • 75197 Answers

SOURCE: 02 accent sounds like it wants to turn off while driving

trust the guy who said the other guy was full of it, I doubt it is the timing belt at 72,000 miles, more likely the idle speed control motor needs to be cleaned or a you have a defective MAP or MAF sensor...

Posted on Apr 27, 2009

ghost4548
  • 776 Answers

SOURCE: I have a high pitched noise which appears to be

Could be several things. WHICH ENGINE?.. 4 cylinder (has three belts, power steering/water pump, alternator & A/C compressor, one tensioner pully A/C compressor), The V6 2.7 (has only one belt, 1 Idler pully and 1 tensioner pully), the V6 3.5 has two belts - A/C/alternator, and power steering - there are two tensioner pullys). Noises can be caused by the belt(s) themselves, pullys, bearings, pully bearings, water pump shaft bearings (or belts/pullys rubbing up against something). Let's not forget that there is also belt(s) behind the Timing Belt cover as well as pullys and bearings associated with the timing system. You could start by removing one accy drive belt at a time (alternator, water pump, compressor, power steering, etc) to see whether or not the noise goes away in each case. If after each case, you discover the noise is still there, it's probably behind the timing belt cover (idler/tensioner pully, water pump shaft bearing, crankshaft bearing, etc.). Good Luck

Posted on Jun 30, 2009

  • 2 Answers

SOURCE: check engine light is on intermittenly during driving

Well, My engine light came on. I have an 03 4 cylinder sonata and we changed ignition coils, my car vibrates and was hesitating. disconnected battery to reset engine light/computer, and today my car died on me while going down the road. it starts and kills. and when it does run it sputters. i say most hyundais have similar probs.

Posted on Sep 07, 2009

  • 1509 Answers

SOURCE: My check engine light comes on intermittently.

The car should be under warrentee and the dealer should fix it free. Don't try to fix it your self as you'll throw the dealer a loop that will make them take longer to fix it

Posted on Oct 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fiat seicento sx 2001 mil light comes on intermittently.code reader gives error p0300 but car seems fine. What could be wrong


code p 0300 refers to random/multiple cylinder misfires detected==causes spark plug/s ---HT lead/s--injector/s--ignition coil/s-low compression --- wiring
it could be simple moisture in the distributor cap, wiring connections
It could be a problem ECM unit
monitor the condition or take it to an accredited service center that has experience on your make of vehicle and have it checked out
could be a problem that has already been identified and has a manufacturer service bulletin in place

Sep 01, 2016 | Fiat Seicento Cars & Trucks

1 Answer

Engine miss when cold, engine light on, new gas, air filter. fuel pump in tank. hot engine loght goes on off, when off at stop stalls out engine light off.


Diagnose Engine Misfire - Auto Diagnosis Repair Help

www.aa1car.com/library/misfire.htm
The engine may shake so badly at idle that it causes vibrations that can be felt in ...The engine may only misfire and run rough when cold but then smooth out as ...

What is causing an intermittent misfire only when engine is ...

community.cartalk.com/.../what-is-causing-an-intermittent-misfire-only-...
Jun 27, 2013 - NOTE: You MUST restart the engine for the misfire to go away. ... in an expert to do that test, but it might be worth it to prove/disprove the injectors being thecause. 0 ... The first is that the car should run fine even on cold starts.

Engine misfires when cold but runs fine after warming up few ...

https://answers.yahoo.com/question/index?qid...
Mar 24, 2009 - They also gave it to me because of this misfire problem it has. ...Engine misfires when cold but runs fine after warming up few minutes later? ... and you start next morning will also cause a misfire until it burns off the coolant.

"Miss/splutter" with cold engine, but fine when warm? M103 / also ...

www.peachparts.com > ... > Tech Help
Jul 13, 2011 - My moms old 300SEL (with the M103) that was once my car is now my "work car" again as she is getting a brand new SUV very soon.

Cold start misfire solved (finally!) - Bimmerforums


Dec 16, 2015 | Cars & Trucks

1 Answer

How do I fix a check engine light intermittent misfire?


check fuel pressures, clean and test injectors, replace HT leads with quality units

Apr 20, 2015 | Cars & Trucks

1 Answer

Intermittent misfiring


Had the same thing. The didtributor was going bad. Lived with it for a few months finally it died. 1 year after replacing the distributor the problem started again. Glad I got a warranty on the distributor. Running great now on the second distributor.

Jul 08, 2010 | 2001 Mitsubishi Diamante

1 Answer

I have a check engine intermittent light with some shaking in the engine also intermittent, also air bag light comes on intermitently.


Something shaking is almost always a cylinder misfiring.
Which is usually a bad plug or wire. But it could also be an intake manifold vacuum leak.

Jun 07, 2010 | 2002 Jeep Liberty

2 Answers

Every time it rains my 2003 Mazda MPV misfires and sputters, then the check engine light flashes on and off intermittently. I ran an OBDII check on it and it reads cylinder 5 misfire. If I let it sit and...


may have hair line crack in coil,,or bad wire,,spay wire while running with a water missed spray bottle,,& see if u can make it misfire,,start at spark plug & work ur way up,if it starts to misfire when u get to the coil,,u will no with part to replace,,hope it helped,,

Apr 05, 2010 | 2003 Mazda MPV

1 Answer

It is missing when i first start it and check


Hi:
It seems that your intermittent problem could be a cheap fix,and you can try a few things that might fix or eliminate the problem. Since the code pointed to the #1 cylinder misfire, You could change out your spark plugs and spark plug wires as a possible cause. If it doesn't fix it, they were 5-6 years old, and a new set isn't a bad investment. If the problem persists, then you are looking at a ignition coil, coil pack, distributor cap/ rotor,depending on your particular engine. Often if you have an ignition module failing, it will affect all cylinders misfiring, often randomly , so once you change your plugs and wires, have someone clear the check engine light, so if it comes back on ,you can check to see what the new code problem is...I hope you get a cheap fix!

Jan 24, 2010 | Nissan Pathfinder Cars & Trucks

1 Answer

2005 monte carlo seems to run rough / misfire when warm.


Remove your ignition module and take it to a parts house to be tested. This is common behavior for a failing module after it gets warm. Have them check it several times to insure it gets hot during testing.

Sep 11, 2009 | 2000 Chevrolet Monte Carlo

1 Answer

Intermittent misfiring and stalling


this sounds like a definate problem with vacuum check valve on your brake booster or the hose going to booster....that should solve your prob! good luck.......ps----------cheap part...quick fix!

May 22, 2009 | 2001 Daewoo Lanos

Not finding what you are looking for?
2005 Hyundai Getz 1.3 Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...