Question about 1996 Kia Sportage

Open Question

Trouble shifting high rpm

Repm's rev and wont shift gears

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 233 Answers

SOURCE: Kia Rio (2003, manual) losing power

Sorry,

That is tell-tale signs of your clutch going out..almost gone. Be sure to replace your clutch plate, pressure plate, have the flywheel turned by a machine shop and replace the throw-out bearing and the master/slave cylinder or it will need to be fixed again way too soon. Only other thing I can think of is if it has a cable controlled clutch (not likely) these type need to be adjusted from time to time as the cable stretches.

Posted on Jun 08, 2009

  • 10 Answers

SOURCE: i have a 2004 kia rio 5 speed

there are 2-3 bushings underneath the car that can be changed.....they are about 5-7 dollars each that you can pick up at the dealership and do it yourself...it's not hard at all...drive it on ramps and chock the wheels to make it safe....get underneath and then have someone in the drivers seat to shift the gears(while it's off) so you can see where the moving points are, then just undo the bolts and replace the bushings or you can just remove or loosen the bolts and lubricate them with lots of grease....I would try the grease first, it should do the trick...Kia will charge you about $130 to do it for you...

Posted on May 14, 2010

markmayes66
  • 786 Answers

SOURCE: takes time shifting, and won't shift into high gear unless you gas on it.

May check fluid level and if low would more than likely indicate a leak. could also be a sensor that controls the shifting. does check engine light come on and if so,this could indicate a bad sensor.

Posted on Aug 13, 2012

kdh1961
  • 312 Answers

SOURCE: 2003 kia spectra. I changed the speed sensor, but it still doesnt want to start of in drive. I have to manually shift and sometimes it wont go at all in any gear. just revs up until it kicks into gear

problem is the tork convertor sticking check transmition fluid first

Posted on Aug 19, 2012

SOURCE: my 2001 kia optima want shift out of second gear

Get to a trans shop or where ever you want to go,
& get it road tested

I doubt there is much left in that transaxle,but a
complete rebuild

Posted on Dec 07, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

High transmission shift points 1-2 and 1-3


Chevy automatic transmission workings (Bob Hale) - Yarchive

yarchive.net/car/transmission.html
When a sufficiently high RPM is reached then the weights hit stops and do ... There are two shift valve assemblies, one for the 1-2 shift and the other for the 2-3 shift. .... Thehigh RPM factory governor appears to have about 1/3 less metal in the ...

Possible Transmission Issue - weird shift points/high RPMs ...

thespeedfreaks.net > Jeep Talk/Tech > Tech Questions
Oct 2, 2012 - Thread: Possible Transmission Issue - weird shift points/high RPMs ... throttle pressure, but seems to blow past the 1st gear shift point and revs up to 4500 RPM or so then shifts. .... The 1 - 3 shifts actually felt pretty natural.

[PDF]Simple Shift Installation and Tuning Guide for Ford Trans ...

https://www.powertraincontrolsolutions.com/.../download.php?...Simple...

Dec 29, 2015 | Cars & Trucks

1 Answer

Why wont my isuzu rodeo stay in gear


there are only 3 issues here.
1 weak engine, , even 1st gear I have no engine power.
2: 1st revs normal but wont shift up.
3: the transmission slips. (flares) RPM goes nuts.

which one?

Jul 14, 2014 | 2001 Isuzu Rodeo

1 Answer

Why will rpm rev fine on 1995 chevy Silverado 4x4 till its put in gear then it wont rev past 2100 rpm


it sounds like its is shifting strange it could be the torque converter or something inside the tranny making it shift sooner than wanted.

Oct 22, 2013 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

My rpm rev's past 3 car stalls then shifts...sometimes won't shift


Due for a transaxle rebuild,common on that veh

The fact you continued to drive it when it won't
shift correctly & has been slipping, your done

Aug 30, 2012 | 1998 Plymouth Grand Voyager

1 Answer

1992 chevy 3500 wont shift unless under hard acceleration


there is a transmission sensor on the top of your motor by the intake. it senses the accelerator or motor rpm's and tells the ****** to shift. its about 30.00 and easy to change. get it at any auto parts store.

Aug 26, 2012 | 1992 Chevrolet C/K 3500

2 Answers

WHICH BUTTON TO APPLY IN NISSAN STANZA 1991, POWER OR COMFORT BUTTON?


Acutally there is 3 position settings for the transmission selector, the power setting which changes the shift points higher ,more rpm's, center position basic auto selection the transmission selects the best driving gears based on your habits, and the comfort mode which shifts the transmission easily and smoothly, no high rev shifts, best for good fuel mileage, but if you need to get on it it will go.

May 19, 2010 | 1991 Nissan Stanza

2 Answers

My transmission wont shift properly rpm goes up too high


sounds like the clutches are slipping or you have a bad seal in tranny, which wont allow it to keep pressure. have you changed the fluid and filter?

Aug 16, 2009 | 2003 Chevrolet Silverado 1500

1 Answer

Trouble in shifting


I am having trouble understanding what you are saying but it sounds like you are saying the transmission shift points are too high. (Holds the gears too long, RPM's too high before it shifts) RIght? Check to see if you have vacuum to the modulator at Idle. If yes replace the modualtor.

May 27, 2009 | 1992 Ford Explorer

Not finding what you are looking for?
1996 Kia Sportage Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75051 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...