Question about 2004 Kia Spectra

Open Question

How to rapair a evap vent valve solenoid on a 2004 kia spectra

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

TLRogue
  • 99 Answers

SOURCE: Kia Sportage 2003 - Solenoid Valve

This sounds like the idle air control valve. This valve sits on the inlet manifold and basicly regulated the flow of air for tickover( or idle). The usual operation of this valve is, when the engine is running at high speed the valve will be closed, when the engine comes down to idle, the main throttle butterfly will shut as you lift your foot off the pedal. The idle valve will open and give a small amound of air to the engine, just enough to run it at idle speed. These valves can stick open, therefore letting air in when the throttle is open, giving the engine too much air. WD40 is only a temporary repair untill it jams again. Best course of action is to have part replaced.

TL

Posted on Jan 24, 2009

  • 15 Answers

SOURCE: my 2003 kia spectra stalls

Hi,
It might have a partially blocked fuel line or ait intake supply.

  • Try to check your fuel filter.
  • The seive on the fuel pump.
  • The fuel injectors might be dirty.
  • The air cleaner might be clogged
or the fuel sensor might be malfunctioning.
Try to check the compression, it might be loosing compression when you demand the engine to move the vehicle.

Posted on Feb 01, 2009

alicantecoli
  • 22095 Answers

SOURCE: 2004 kia spectra no a/c

needs looking at because it could be switch that allows it to turn on if sufficient gas is present ,or a problem with the clima compùter ,but to do anything you will need the special machine to empty the system then check things out so take to an authorised AC garage ,because these systems are a potential accident and you could lose a finger with frostbite in a matter of less than 2 seconds .therefore i will not tell you how to look for a soloution because of the dangerous nature of playing with air con

Posted on Jul 31, 2009

  • 4044 Answers

SOURCE: I have a 2004 Spectra.

Well, it is either a timing belt/chain going out or a bad crank position sensor most likely causing the other problems. The O2 sensor may be bad as well but that usually doesn't cause the Misfire. The vehicle on board computer is confused, that is why it is throwing all those codes. and why it gives you that 1166 code which isn't defined. Check the crank position sensor and the timing and timing belt first. Once you have that fixed the rest should clear up.

Posted on Dec 29, 2010

acoates
  • 454 Answers

SOURCE: 2004 Spectra: I need a diagram for fan belt installation for 200...

Hello and thank you for asking your question here on fixya.com.

I have actually written a general information article that will walk you through the general process of changing the fan belt on your
2004 Kia Spectra. It will also point you to the resources you need for getting the diagrams of how the belt needs to go back on. Belts usually cost less than $20 and take a few minutes to put them on.

Here is a link to that article:
How to change the fan belt on your
2004 Kia Spectra

If this has helped you in any way, then feel free to follow my Twitter account for more great money saving tips and tricks. twitter.com/acoates23234
I follow back, too. :)

Thanks for reading.

Posted on Jan 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is evaporative emmission control vent located?


The EVAP canister vent control valve is located on the EVAP canister right in front of the left rear tire,under car.

press the helpful button

Jan 19, 2016 | 2007 Kia Spectra EX

1 Answer

P0449 OBD2 code meaning for 2004 Hyundai Elantra?


EVAP purge/vent solenoid circuit condition. the PCM has determined that a malfunction exists in the electrical circuit for the vent valve/solenoid in the evaporation emission control system (EVAP)

Dec 07, 2011 | 2004 Hyundai Elantra

1 Answer

I have a 2004 Spectra. Driving to work this morning, car stalled out twice. Cranked car later in the day and the engine sputtered and idling high to keep from dying. Engine smoothed out, but MIL came on...


Well, it is either a timing belt/chain going out or a bad crank position sensor most likely causing the other problems. The O2 sensor may be bad as well but that usually doesn't cause the Misfire. The vehicle on board computer is confused, that is why it is throwing all those codes. and why it gives you that 1166 code which isn't defined. Check the crank position sensor and the timing and timing belt first. Once you have that fixed the rest should clear up.

Dec 29, 2010 | 2004 Kia Spectra

1 Answer

I ran an engine analyst and got codes P0446 twice and code P0431 once. what does this mean.


P0431 Warm up catalytic converter, bank 2 - efficiency below threshold
Possible causes: Catalytic converter, wiring, HO2S 2

Usually caused by worn out catalytic converter, but always check fuel pressure regulator for proper operation before replacing a converter.


P0446 Evaporative emission (EVAP) system, vent control -circuit malfunction
Possible causes: Wiring, EVAP canister purge valve, ECM

May be caused by a loose or disconnected wire to the vent valve or possibly a bad valve solenoid

If you would like part locations, troubleshooting or replacement procedures, please let me know.

Dec 01, 2010 | 2004 Kia Sedona

1 Answer

2004 niisan infinty g35x code p2135


NISSAN OBDII DTC

P1105 Manifold Absolute Pressure/Barometric Pressure Switch Solenoid Circuit

P1110 Intake Valve Timing Control Circuit (Bank 1)

P1120 Secondary Throttle Position Sensor Circuit

P1125 Tandem Throttle Position Sensor Circuit

P1132 Intake Valve Timing Control Position Sensor (Bank 1)

P1135 Intake Valve Timing Control Circuit (Bank 2)

P1137 Intake Valve Timing Control Position Sensor (Bank 2)

P1140 Intake Valve Timing Control Position Sensor (Bank 1)

P1145 Intake Valve Timing Control Position Sensor (Bank 2)

P1148 Closed Loop Fault Detected (Bank 1)

P1168 Closed Loop Fault Detected (Bank 2)

P1210 Traction Control System Signal Fault

P1220 Fuel Pump Control Module Fault

P1320 Ignition Control Signal Fault

P1335 Crankshaft Position Sensor Circuit

P1336 Crankshaft Position Sensor circuit

P1400 EGR/EVAP Control Solenoid Circuit

P1401 EGR Temperature Sensor Circuit

P1402 EGR System Fault Detected

P1440 EVAP Canister System Leak Detected

P1441 EVAP Vacuum Cut Valve Bypass Valve Circuit

P1443 EVAP Canister Control Vacuum Switch Circuit

P1444 EVAP Canister Purge Volume Control Valve Circuit

P1445 EVAP Purge Volume Control Valve

P1446 EVAP Canister Vent Valve Circuit

P1447 EVAP Canister Purge Flow/Volume Control Valve Circuit

P1448 EVAP Vent Control Valve Circuit

P1490 EVAP Vent Control Valve/Bypass Valve Circuit

P1491 EVAP Vacuum Cut Valve/Bypass Valve Circuit

P1492 EVAP Canister Purge Control Valve/Solenoid Valve

P1605 Transmission Control Module A/T Diagnosis Communication Line Fault

P1705 Throttle Position Switch Circuit

P1706 Park Neutral Position Switch Circuit

P1760 Overrun Clutch Solenoid Valve Circuit
P1900 Cooling Fan Control Circuit
sorry but your code reader is not reading manufacturers codes ,if an american market vehicle then you should be able to read them but if this is a europeon model then how did you manage to get this code??

P0235....Turbo/Super Charger Boost Sensor 'A' Circuit

this is a generic code if its any help

Nov 02, 2010 | 2004 Infiniti G35 Sport Coupe

1 Answer

I have a 04 buick rend and i'm getting the p 0449 code how can i find out what it is and where


CODE PO449 - EVAP VENT SOLENOID CONTROL CIRCUIT MALFUNCTION CONDITION. FIRST CHECK EVAP SOLENOID FUSE.IF ALL IS GOOD EVAP VENT SOLENOID LOCATED ON A BRACKET NEXT TO FUEL TANK.

Oct 13, 2010 | 2006 Kia Spectra

1 Answer

"vent control circuit malfunction" code on a 2002 Kia Sedona


Evap vent solenoid control circuit? Is the solenoid plugged in? Possible bad solenoid?

Apr 01, 2010 | 2004 Kia Sedona

Not finding what you are looking for?
2004 Kia Spectra Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74896 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7689 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...