Question about Cars & Trucks
After I tried opening the drivers door without pressing unlock on the key it now flashers fast lets me drive but then alarms going down the road sumetime flashing the indecators left right left and stops after about 20 Seconds .. after 2days in the garage it went back to normal steady light when armed and no light while driving. But partner tried to open door before I hit the button bask to the same problem again
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
If you lock the car from the outside with the key your alarm will not go off this happened to me too
good luck with buying a new keypad they're over 150 each
Posted on Feb 20, 2009
The alarm might have a relay to kill the ignition. Disconnect the negative or ground from the battery, wait five minutes then connect it again. This is to try and restart the alarm. Then lock and unlock the car to get the remote in sync. Try and operate your vehicle now and let me know.
Posted on May 06, 2009
First, try to re-programme the RKE (Remote Keyless Entry) transmitters before searching for anything else. Assure that the batteries in the transmitters are in working condition and replace them if you are not sure. To pro-gramme the transmitters, perform the following:
Open the driver's door and let it be open throughout the programming process. Then, shift the mechanical door lock lever to the LOCK mode, turn the ignition key to the rUN mode. Within a period of twenty seconds, point a transmitter at the receiver dome and push the lock button for a period of five seconds at least. After the receiver has accepted the programming code the driver's door will unlock on its own. The first transmitter has been programmed, in the same extra transmitters up to four may be programmed in the same way, within twenty seconds.
If the alarm does not work properly, you may have a faulty alarm module and may have to be replace and its common problems with and older model. the systems work like a security systems, if you arms your system with the remote you have to disarm it also with the remote in order for the engine to start and run. The logic in the PCM prevents the VTSS engine no-run feature from arming until the engine start; Its one of the security systems jeep has and if you ask for my opinion its junk. hope that help some..
Posted on Jul 26, 2009
I found a solution on another site showing if i turn the ignition on and hold the reset button on behind the alarm light untill it turns to solid blue light then turn off the ignition , it will disable the alarm.
Posted on Dec 13, 2009
Tips for a great answer:
Feb 27, 2015 | 2011 Jeep Grand Cherokee Laredo
Oct 21, 2014 | Kia Sedona Cars & Trucks
Aug 19, 2013 | 2005 Jeep Grand Cherokee
Sep 17, 2012 | 1995 Jeep Grand Cherokee
Dec 26, 2010 | 2005 Jeep Grand Cherokee
Dec 12, 2009 | 2001 Jeep Grand Cherokee
Jan 03, 2009 | 2005 Jeep Grand Cherokee
Jun 27, 2008 | 1994 Jeep Grand Cherokee
May 14, 2008 | 1995 Jeep Grand Cherokee
23 people viewed this question
Usually answered in minutes!