Question about 2005 Volkswagen New Beetle Convertible

Open Question

How to reset radio in safe mode in 2005 vw beetle

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75066 Answers

SOURCE: unlock radio in 98 beetle

I've had this happen twice when the battery died. It goes into the SAFE 2 mode if you try entering it and don't do it right and then you have to leave the radio on for 1 1/2 hours to have it come on to 1000 and then set it with each number one at a time and then hold down right reset until he beeps on. So, if you are discouraged as I was, the answer is to leave it on with the SAFE showing for over an hour and it probably will come on with the 1000 for setting eventually.

Posted on Aug 19, 2008

johnny5846
  • 379 Answers

SOURCE: re setting the radio on my VW Golf

heres what u do , switch radio on , safe appears in radio display , followed by 1000 approximately 3 seconds later , input the security code found on the radio card using the station preset buttons on the radio , Button 1 corresponds to the first number in the security code , 2 is the second and so on . press the applicable button repeatedly until the desired number appears in the display , ( press button 1 three times if the first number is 3 ), when the entire code has been input and appears on the display , press the right side of the seek button for longer than 2 seconds until an audible signal is heard , ,,, if you do not get this procedure correct , in 2 attempts , the radio will lock up for 1 hour before you can try again .. if this happens , leave the radio on for minimum 1 hour without touching it , after that time you may try again ..

J5

Posted on Jan 15, 2009

alicantecoli
  • 22095 Answers

SOURCE: 2004 Volkswagen Beetle Radio/CD player

new one with a usb connector and sd card reader is better and cheaper

Posted on Jan 31, 2009

  • 2 Answers

SOURCE: 98 VW Beetle used-no radio code- I have radio & car serial #'s...

I assume you have this unlocked by now, but here's an answer for someone else for the future :-)
if you have the original radio that come with the car, look in the wheel well in the trunk, where the spare tire goes. (yep, you'll need to stand on your head). there is a sticker that will have the 4-digit code on it.
enter that into the radio.
I can't remember off the top of my head which one it is, but either the >> Scan or the am/fm button will be the "enter key"

Posted on May 26, 2009

BRADLEYFRANC
  • 104 Answers

SOURCE: 97 VW Golf radio flashes safe

you have to leave radio and ignition on for 1hr till no.1000 appears,then enter code

Posted on Aug 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1998 vw beetle its stuck on 2 safe mode i need help getting that out thanks


First of all you should exit from 2 safe mode. Then turn ON the radio and let it turned ON for at least one hour, in order to exit from 2 safe mode.

IMPORTANT NOTE:
You must have the security anti-theft code for your VW radio from the car manufacturer, or from a VW dealer!


You can find the radio code at: http://www.radio-code.co.uk/

The sequence of VW radio programming is:
1. Push simultaneous "SCAN" and "RDS" keys until on the screen will appear "1000" displayed.
2. Release keys. No more push on "SCAN" and "RDS" keys because otherwise number "1000" will be considered as first safe code attempt.
For example: we have the security code "5079". Then:
3. By the no.# 1 key you will set up the first safe code digit. Push 5 times on the no.# 1 button. The "5" number will be setted.
4. By the no.# 2 key you will set up the second safe code digit. Push 10 times on the no.# 2 button. The "0" number will be setted.
5. By the no.# 3 key you will set up the third safe code digit. Push 7 times on the no.# 3 button. The "7" number will be setted.
6. By the no.# 4 key you will set up the four-th safe code digit. Push 9 times on the no.# 4 button. The "9" number will be setted.
7. Then push again simultaneous "SCAN" and "RDS" keys for confirm this safe code. On the screen will be displayed "SAFE" notice. Release keys! For few seconds a radio frequence will be displayed.

The radio is now ready for use!

Sep 13, 2011 | 1998 Volkswagen Beetle

1 Answer

In my 200 vw beetle tdi, the radio will not turn on. the fuse is good for the radio, so what else should i try


You need to remove the radio out from the dashboard using special removal VW radio Gamma keys. In the rear face of the unit is placed a fuse (red color) = 10 Amp. Replace blown fuse with a new one. Then you will need to exit the radio out from the security "SAFE" mode.

IMPORTANT NOTE:
You must have the security anti-theft code for your VW radio from the car manufacturer, or from an Volkswagen dealer!


You can find the radio code at: http://www.radio-code.co.uk/
tdisline_701.jpg
The sequence of programming for a 2000 VW Beetle radio Gamma is:
1. Push simultaneous "SCAN" and "RDM" keys until on the screen will appear "1000" displayed.
2. Release keys. No more push on "SCAN" and "RDM" keys because otherwise number "1000" will be considered as first safe code attempt.
For example: we have the security code "5079". Then:
3. By the no.# 1 key you will set up the first safe code digit. Push 5 times on the no.# 1 button. The "5" number will be setted.
4. By the no.# 2 key you will set up the second safe code digit. Push 10 times on the no.# 2 button. The "0" number will be setted.
5. By the no.# 3 key you will set up the third safe code digit. Push 7 times on the no.# 3 button. The "7" number will be setted.
6. By the no.# 4 key you will set up the four-th safe code digit. Push 9 times on the no.# 4 button. The "9" number will be setted.
7. Then push again simultaneous "SCAN" and "RDM" keys for confirm this safe code. On the screen will be displayed "SAFE" notice. Release keys! For few seconds a radio frequence will be displayed.
The radio is now ready for use!

Jun 29, 2011 | 2000 Volkswagen Beetle

1 Answer

The radio is in SAFE mode....


It has to be the wrong code. You have to take in to the VW dealership, (because of so many stolen radios), they will have to verify your registration. Then they will remove your radio, get the serial number put it in to VW hub<( dealership only VW repair site), and retrieve the correct code. Even though the code shown is in your owners manual should have been the correct code sometimes radios get switched. Question at the end you said you pressed seek- did you hold the right lower arrow button, (scan), in till radio began to play?

Dec 31, 2009 | 2000 Volkswagen Beetle

3 Answers

2 safe


1998 vw new beetles radio is stuck on 2 safe how do I get it out of this mode?

Aug 24, 2009 | 1998 Volkswagen Beetle

1 Answer

VW radio


"2 safe" means that you have entered the wrong code twice. Leave the igniton switched on for about an hour and it will reset to - - - (three small lines) then you can enter the correct code. If you dont have the code you will need to speak to your vw dealer

May 29, 2009 | 1998 Volkswagen Beetle

1 Answer

How do i remove vw bug radio for code to reset


look in the owners manual in the radio section ... the 4 digit code is in there on a small sticker

Mar 24, 2009 | 1998 Volkswagen Beetle

1 Answer

Radio in safe mode


OK do you have the radio in your hands? IF not you have to remove it using the special tools slotted to unlock it and pull it out. The radio serial is etched into it but you have to remove it to see. With this and the car's serial and proof of ownership VW can get the radio code for you. Or they'd be happy to remove it for you as well and get the other info themselves.

Oct 31, 2008 | 2000 Volkswagen Beetle

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

758 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75066 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...