Question about Toyota Corolla

1 Answer

Where's iac valve located on a 2005 corolla - Corolla Toyota Cars & Trucks

Posted by Anonymous on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Toyota Master
  • 2,760 Answers

I .A.C. = inlet air control valve wouldn't you think it be right at front of where air goes into engine (intake) ??

Posted on Jul 29, 2016


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 3854 Answers

SOURCE: IAC Valve Location - 1996 Jeep Grand Cherokee

The idle air control valve is located on the back of the throttle body. It has an oval electrical connector and two torx screws holding it in. Unplug the connector, remove the two screws then lightly tap the body with a soft faced mallet to loosen it from the body. 
Once you have it out and prior to installing a new valve clean the seat inside the throttle body where the idle control fits. This must be very clean! Installation is in the reverse order. 
 To save some cash, pull the valve out and clean it with throttle body cleaner, this usually fixes the problem for quite a while.
Good luck and hope this helps.

Posted on May 28, 2009

  • 14 Answers

SOURCE: IAC control valve. Locato\ion 2002 ford escape

If it's not idling and has problems starting, it's probably the IAC motor. It's located on the throttle body. Follow the airfilter box all the way to the engine, where the rubber flex hose attaches. The throttle body should be the first aluminum part you come to. Attached to the side you'll find small little aluminum part with a small wire harness attached. Unplug it, take the IAC motor off and clean inside with carb cleaner. This should fix the problem with the idle.

Posted on Sep 11, 2009

  • 617 Answers

SOURCE: Where are these valves located?

c0552ec.jpg7f30725.jpgEGR(top)IAC(3bottom views).EGR will be on the intake,IAC will be on the throttle body.

Posted on Dec 19, 2009

  • 77194 Answers

SOURCE: Pressure Control Solenoid "D" location on a 2005 Toyota Corolla?

this solenoid is part of the solenoid pack that is located on the valve body inside the transmission.

Posted on Mar 28, 2010

  • 154 Answers

SOURCE: location of iac valve f150 5.4 triton

This particular vehicle does not have an IAC valve. This is because it is equipped with ETC (Electronic Throttle Control). This means there is no mechanical connection between the accelerator pedal and the throttle plate. Instead, the throttle plate is controlled by an electric motor to control its engine speed, based on "input" it receives from the PCM. The accelerator pedal is connected to three poteniometers. Two that increase, and one that decreases voltage in a particular proportion. If they fail, the vehicle goes into what's called a "forced idle" mode of operation. Hope this helps.

Posted on Apr 23, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 1992 toyota corolla dx with a manual trasmission. i am trying to locate the iac to clean it. where is it located? thanks

The idle air control valve should be on or extremely close to the throttle body. But half of it might be hidden because its inside of something so look for parts that look similar but maybe arent as big

Nov 20, 2014 | 1992 Toyota Corolla

1 Answer

Iac valve location 2006 suzuki forenza

bd52f9f9-ef51-43bd-8b5b-0a753314a8c7.jpghere is a picture of the iac valve, it is on the throttle body, there are a few connectors on the throttle body and the iac is one and the shape is diffrent from the others so if you locate the connectors you will find it, here is a pic of the iac valve hope this is helpful.

Jun 29, 2013 | Cars & Trucks

1 Answer

Location of idle air control valve 2006 toyota corolla


Feb 15, 2013 | 2006 Toyota Corolla

1 Answer

Where is my idle air control valve on a 2005 Lincoln navigator located ?

I cannot find the location of the IAC valve on a 2005 Lincoln navigator. Picture please.

Jan 31, 2013 | Cars & Trucks

1 Answer

Where is the IAC valve located 2005 chevy colorado

The IAC valve is normally located in the throttle body. Depending on which engine you have, most are directly below the air duct from the filter housing in lower center of Throttle Body.

Oct 12, 2011 | 2005 Chevrolet Colorado

1 Answer

I need to know where it's located and how to take off and put on idle control switch

Disconnect the negative cable from the battery terminal...Locate the IAC valve on the side of the engine, near the intake...Remove the electric cable on the back of the IAC valve. Remove the screws that attach to the IAC valve and set them aside...
Pull the IAC out of the Cadillac DeVille and replace with new valve...Connect the IAC valve to the wire and reconnect the screws. Turn the screws so that they are completely tightened...Reconnect the negative cable to the battery and start engine to test valve.

Good luck, i hope this helps.

Jun 30, 2011 | 1999 Cadillac DeVille

1 Answer

Pressure Control Solenoid "D" location on a 2005 Toyota Corolla?

this solenoid is part of the solenoid pack that is located on the valve body inside the transmission.

Mar 28, 2010 | 2006 Toyota Corolla

2 Answers

2004 toyota corolla idle jumps

If you dont have any trouble codes, this usually occurs when the idle air control valve (IAC) is going bad.

Mar 25, 2009 | 2004 Toyota Corolla

1 Answer

86 corolla 4dr just stalls while driving.

Check and clean the Idle Control Valve.(IAC) buy a can carburator cleaner or brake cleaner. remove the air duct work .In the fuel intake system side, you can see some holes to the side on the inside. One of those holes is the IAC valve. Turn on the car and run at 1200 rpms. Use something heavy to press the gas pedal. Spray the cleaner into the holes on the intake side going to the fuel system. Turn off the engne and let the cleaner soak a bit. Repeat the process a few more times or until the engine runs smooth.The valve can be easily removed from the outside . If you have to, remove the valve and clean it.If it still does not work, replace the IAC.

Jan 12, 2009 | 1986 Toyota Corolla 2 Door

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

283 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8737 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides