Question about Cars & Trucks

Open Question

99 infiniti g20 tach trigger wire

Ignition wires

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 31 Answers

SOURCE: location of flasher for my 1993 infiniti g20

what is it that you have to change your flasher? have you check the fuses that may fix your problem. now your flasher location is under your sterring colum by the fuse box

Posted on Jun 20, 2008

Ad

SOURCE: 98 civic lx where is ignition coil?? ++

IT'S A BLUE WIRE ON THE BACK OF THE CONNECTOR THAT WOULD NORMALLY GO TO THE FACTORY TACHOMETER IN THE DASH. YOU HAVE TO REMOVE THE DASH GAUGE CLUSTER TO GET AT THE CONNECTOR. THE CONNECTOR WILL NOT BE PLUGGED INTO ANYTHING IF YOU DON'T HAVE A FACTORY TACHOMETER (DX, CX, HX ETC...YOU WILL HAVE TO SPLICE INTO OR CUT THE BLUE WIRE FROM THE PLUG. IT GOES TO TACH SIGNAL WIRE ON YOUR NEW TACH.

Posted on Jun 24, 2008

  • 173 Answers

SOURCE: Chevy G20 1985 wiring (charging problem)

http://wareznuke.com/apps/3872/all-1979-2007-vehicle-wiring-diagrams-v42-rapidshare-warez


Posted on Jul 08, 2009

ftw1952
  • 10319 Answers

SOURCE: how do i hook up a tach to a 1994 suzuki samurai -

I never worked on a Suzuki so if this has a distributor look for a connector that has the letter T on it
If it is a distributorless ignition the inginition module will have the same marking for the tachometer.
If you do not see any reference such as I mentioned do not connect any wires anywhere for this tach until you know from someone else that has a better idea

Posted on Jun 09, 2010

  • 834 Answers

SOURCE: im trying to instal my tach on my 99 hyundai

The "Green" wire from the after-market tachometer will connect to the (-) negative side of the ignition coil.

The "Red" wire from the tachometer will connect to an ignition source that has power only when the key is in the "Run" and "Start" position, usually at a "IGN" source on the fuse panel.

The "Yellow" or "White" wire from the tachometer will connect to the instrument panel lighting fuse in the fuse panel usually marked "LPS" or "IP" and there should be a source next to the instrument panel lighting fuse to connect the wire.

The "Black" wire should be connected to a good body ground, and if the tachometer is not properly grounded anyone sitting in the vehicle while the engine is running will receive a mild electric shock from the ignition coil primary voltage whenever anything metal inside of the vehicle is touched.

Posted on Nov 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace the idle air control valve on 99 infiniti g20


It's usually a clip you disconnect and Two screws you could clean it or replace it..

Apr 03, 2016 | Infiniti Cars & Trucks

Tip

ALARM, CRUISE CONTROL, and STEREO Wiring Color Codes for 1996 Honda Civic This...


ALARM, CRUISE CONTROL, and STEREO Wiring Color Codes for 1996 Honda Civic

This FixYa Tip is for the purpose of installing an Alarm, Remote Starter, Cruise Control, and / or Car Stereo into the vehicle listed in the subject line.

The wires listed are the ones you will need to successfully complete the task.

Some vehicles require additional relays and / or modules to bypass factory security. If they are required - it will be in the NOTES section below the wiring colors.

The following FixYa TIP is good for all Honda Civics for the following production years:

1996


STEREO WIRING COLOR CHART:
Constant 12V+: Blue/White
Switched 12V+: Yellow/Red
Ground: Black
Illumination: Red/Black
Dimmer: n/a
Antenna: Driver's Pillar

Front Speakers:
Left Front (+) Blue
Left Front (-) Gray/Black
Right Front (+) Red/Green
Right Front (-) Brown/Black

Rear Speakers:
Left Rear (+) Blue/Yellow
Left Rear (-) Gray/White
Right Rear (+) Red/Yellow
Right Rear (-) Brown/White

NOTES: Retain Keyless entry with secondary Harness Listed Below
Additional Accessories:
Metra Brand Dash Kit: 89-30-7891 - 99-7891 - 99-7898
Metra Brand Wiring Harness: 70-1720 W/Keyless Entry # 70-1720T
Metra Brand Antenna Adapter: n/a




ALARM / REMOTE START WIRING CHART:
Constant 12V+: White - Ignition Switch Harness
Starter: Black/White - Ignition Switch Harness
Ignition: Black/Yellow - Ignition Switch Harness
Ignition 2: Yellow - Ignition Switch Harness
Accessory: White/Black - Ignition Switch Harness
Tach: Blue - Coil
Brake Switch: Green/White - Brake Switch
Trunk Pin: Blue/Black - (-) Driver's Kick Panel
Parking Lights: Red/Black - (+) Driver's Kick Panel
Head Lamp: Red/White (L) Red/Blue (R) - Steering Column
Hood Pin: n/a
Door Trigger: Light Green/Red - (-) Above Fuse Panel
Door Lock: Green/White - (-) 2 pin connector taped to blue connector behind fuse box
Door Unlock: Green/Orange - (-) Module Behind Radio
Horn: Grey - Steering Column or GREEN connector behind radio

NOTES: - none -



CRUISE CONTROL:
Constant 12V+: White - Ignition Switch Harness or Use Hot Side of Brake
Switched 12V+: Black/Yellow - Ignition Switch Harness
Ground: Use Chassis Near Cruise Control Module
Hot Side of Brake: n/a - Brake Switch
Cold Side of Brake: Green/White - Brake Switch
Tach: Blue - Coil
VSS Wire : Blue/White - Driver's Side Dash Footwell, Grey connector.


NOTES: PPM - 4000PPM
ROSTRA Control Arm # 250-3421/250-1483
ROSTRA Throttle Adapter #250-4249

Vehicles with Manual Transmission require Clutch Switch.
Some vehicles may require a speed signal generator and/or other parts/adapters not listed above.
Rostra® Cruise Control module switch settings may differ if you use a speed signal generator or magnets and a pick up coil.

Thanks for using FixYa!! Please see my other tips on GPS, Car Audio, Large Appliances, and more.

on Apr 03, 2010 | Honda Civic Cars & Trucks

1 Answer

I have a 99 infiniti g20. Starts ruff but idles down in a few minutes ,but will cut off at stop lights


There are many possibilities as to why this is happening and that is why you may need to retrieve the codes.

Mar 24, 2016 | Infiniti Cars & Trucks

1 Answer

I am hooking up a remote start on a 99 Chevy Astro & can not find a tach wire.


Hey I'm not an expert at remote starts I've only hooked up one in my life I have two of them one in my Durango & one in my Dakota Dakota was installed by best buy & Durango was installed by pc richards I'm not positive but I think tach wires are the same color on all remote starts and mine are purple the tach wire on the Durango is hooked to the #3 fuel injector wires & the Dakota wire is hooked to the coil but the tach wire is purple look back at installation directions you might have a defective remote start unit remember I said I'm not an expert I'm just going. By what I have I really hope this helped you oh by the way the van has an automatic tranny right? Good luck

Nov 23, 2014 | 1999 Chevrolet Astro

1 Answer

2000 infinity g20...I replaced engine and it started up and ran for approx. 3 min then went dead. I replaced distributor but still will not start. There is fire going to distributor but nothing coming...


Good day
This will have an electronic ignition and you will have to replace that. Use the old engines distributor and make sure there are no loose wires and check the condenser as well.
Good luck.

Jan 19, 2014 | 2002 Kia Sedona

1 Answer

Wiring diagram for bose 28060


Infiniti QX56 Car Radio Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Yellow
Car Radio Accessory Switched 12v+ Wire: Purple
Car Radio Ground Wire: Chassis
Car Radio Illumination Wire: Red/Blue
Car Stereo Dimmer Wire: Brown
Car Stereo Antenna Trigger Wire: Green/White
Car Stereo Amp Trigger Wire: Green/White
Car Stereo Amplifier Location: To the right of the steering column behind the BCM.
Left Front Speaker Positive Wire (+): Blue/White
Left Front Speaker Negative Wire (-): Blue/Red
Right Front Speaker Positive Wire (+): White/Black
Right Front Speaker Negative Wire (-): Blue/Black
Left Rear Speaker Positive Wire (+): Gray
Left Rear Speaker Negative Wire (-): Black/Yellow
Right Rear Speaker Positive Wire (+): Orange/Blue
Right Rear Speaker Negative Wire (-): Red/Blue

Jul 08, 2012 | Cars & Trucks

1 Answer

Need full stereo wiring diagram


Hi there:

2004 Infiniti I35 Car Stereo Radio Wiring Diagram

Car Radio Constant 12v+ Wire: Yellow
Car Radio Switched 12v+ Wire: Violet
Car Radio Ground Wire: Chassis
Car Radio Illumination Wire: Red/White
Car Stereo Dimmer Wire: Red/Yellow
Car Stereo Antenna Trigger: Green/White
Car Stereo Amp Trigger Wire: Green/White
Car Stereo Amplifier Location: Under the rear deck.
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): White
Left Front Speaker Negative Wire (-): Black
Right Front Speaker Positive Wire (+): Green
Right Front Speaker Negative Wire (-): Red
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Black/Red
Right Rear Speaker Positive Wire (+): Blue
Right Rear Speaker Negative Wire (-): Black/White


Hope this helps.

Mar 06, 2012 | 2004 Infiniti I35

1 Answer

Have a 1992 chevy g20 van. the van has a tv/vcr


you'd have to find out what colored wire is behind the plugged in vcr wire theres gonna be a black n red , or black n yellow ( something like that) the black is ground ( frame/body Connected) the colored wire will usually be the powered side. , then follow that colored wire to the fuse box and relocate that powered side wire to connect to another wire , down at the fuse box that powers up with the key on. just connect it to the appropriate wire. stereo shops or car dealerships can fix that issue real quick. normally for a few dollars.

Jul 31, 2010 | 1992 Chevrolet G20

1 Answer

Tach. operates in reverse


I have heard of this happening when the tach is wired to the coil incorrectly. Most (if not all) tachs call for the signal wire to be connected to the NEGATIVE side of the coil. Trace your wiring to/from your tach and go from there...

I hope this helps! -Nick

Mar 27, 2009 | 1984 Chevrolet Corvette

1 Answer

99 cherokee radio problem


Hi,

Either the radio's output ICs are fried or speaker/wires needs to be checked.

Incidentally, there are some higher end versions that has an Infinity Amplifier (P/N: 56038407AD) powering the speakers and not the radio (alone). If so, this amp needs a trigger on from the head unit to work and therefore, the trigger wire/connection must be checked. Otherwise, it may likewise require an internal check.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Jul 12, 2008 | 1999 Jeep Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...