Question about Nissan Xterra

Open Question

Does a 2001 nissan xterra have a fuse to run the windshield washer pump

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: repolacement fuse?

The fuse to your washer pump is shared with the wipers themselves. If your wipers work, then your pump should. I just had the same problem. You can replace the washer pump for $20. It's located behind the front passenger's side wheel well. Just remove the passenger wheel and wheel well covering to access the washer tank, and the motor. The pump pulls off, after removing the electrical plug and fluid line. When you pull the old pump out, the washer fluid will gush out. If you want to save any of this fluid, you may want to find a cloth or something to stop the flow. The new pumps snaps in quit easily.

Posted on Dec 21, 2008

BCAS1298
  • 3092 Answers

SOURCE: Does my 2001 3.3L V6 EFI Nissan Xterra have a non

It's has a timing belt, also it's an interference engine, if belt goes bad it will bent valve's .

Posted on Nov 24, 2009

ZJLimited
  • 17970 Answers

SOURCE: Diagram available for 01 Nissan Xterra Knock Sensor location?

V6 3.3L The sensor is located underneath the air intake manifold on top of the engine block. This should take an experienced mechanic about 3-4 hours to replace.

9bd8ec7.jpg

Fig. Engine compartment component locations

Hope this help (remember rated this free help) Good luck.

Posted on Feb 08, 2010

  • 10 Answers

SOURCE: 2000 nissan xterra...windshield washer fluid pump

On the drivers side of the vehicle just behind the front bumper is the washer fluid reservoir. The washer pumps (2 - one for the back and one for the front) are located ont the face of the reservoir.

1) Drain the resevoir. (You can reuse this fluid, so put it in a clean container)
2) Disconnect the wiring harness for the problem pump.
3) Remove the sprayer line.
4) Remove the pump. It is held in by being snapped into a channel on the resevoir and by the rubber grommet. This may take some elbow grease.
5) Remove the old grommet.(If your new pump came with a new grommet)

Installation is reverse. Usually new pumps come with new grommets. If not, it is ok to reuse the old one.

Posted on Mar 14, 2010

SOURCE: HOW TO REPLACE A FUEL PUMP FOR A NISSAN XTERRA


Removal & Installation

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Relieve the fuel system pressure.
  3. Drain the fuel tank.
  4. Remove or disconnect the following:

    Negative battery cable Fuel pump module harness connectors Filler hose shield Fuel pressure and return lines Filler hose Vent hose Evaporative Emissions (EVAP) hose Fuel tank skid plate Fuel tank Fuel level sender Fuel pump

To install:
  1. Install or connect the following:

    Fuel pump Fuel level sender. Tighten the screws to 17-23 inch lbs. (2.0-2.5 Nm). Fuel tank. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm). Fuel tank skid plate. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm). EVAP hose Vent hose Filler hose Fuel pressure and return lines Filler hose shield Fuel pump module harness connectors Negative battery cable
  2. Fill the fuel tank.
  3. Start the engine and check for leaks.

Posted on Mar 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there a fuse for the windshield washer on a 2006 Nissan Maxima?


Hi
The fuse for the windshield washer fluid pump is in the fuse box behind the passenger headlight and is a 10A fuse. The cover of the box should help to find which fuse it is.
Hope this helps Nick

Aug 19, 2017 | Nissan Cars & Trucks

1 Answer

Where is the windshield washer motor fuse located ?


images for 2009 Nissan Rogue SL Where is the

Windshield Wiper Pump - Not working - Nissan Forum ' Nissan Forums

forums.nicoclub.com/windshield-wiper-pump-not-working-t581434.html
Oct 22, 2013 - Year of vehicle -- 2011 Nissan Rogue SL Leather/Nav Package ... rather an engineer and found that my windshield washer pump was not ... sprocket: Posts: 150: Joined: Thu Jun 11, 2009 1:27 pm: Location: Metro Detroit, MI ... windshield washer fluid switch backwards ?
Apr 27, 2012
Windshield WASHFLUID ISSUE!
Dec 11, 2009
Front windshield sprayers not working..AHH!!!
Nov 10, 2009
More results from forums.nicoclub.com

Jan 11, 2016 | 2009 Nissan Rogue SL

1 Answer

Where is the fuse located that controls the windshield washer pump


Hi Merlin
I THINK this is your fuse panel and location for the washer pump fuse. (See link below)

Hope this helps you out.
-Steve




2003 nissan altima fuse diagram Google Search

Apr 02, 2015 | 2003 Nissan Altima

1 Answer

2009 nissan frontier windshield washer pump won't work


Check fuse in fuse box inside vehicle,if good,then go to windshield washer pump and disconnect wiring,get meter and check if power is going to pump,if so then pump is at fault,if no power,thenwiring could be short somewhere to fuse box.Also check your washer hoses,that they are not kinked or came loose.Pump could just be loose.

Jan 04, 2013 | 2009 Nissan Frontier

1 Answer

2000 nissan xterra, replaced washer pump, not pushing any fluid, is there a fuse for the washer if so i havent been able to find it.


have someone press washer switch and feel if pump is working if not the owners manual will have fuse location and breakdown of circuits it uses check that hope it helps you

Jan 15, 2011 | 2000 Nissan Xterra

1 Answer

Windshield washer is not working and the heater blower only works on high help please.


THE WINDSHIELD WASHER COULD BE A BLOWN FUSE OR A BAD WASHER MOTOR. THE HEATER BLOWER IS MOST LIKELY A BAD BLOWER MOTOR RESISTOR. THE RESISTOR IS PROBABLY UNDER THE DASH NEAR THE BLOWER MOTOR.

Nov 25, 2010 | 2002 Nissan Xterra

1 Answer

2000 nissan xterra...windshield washer fluid pump motor has failed. How do I get to and replace the motor?


On the drivers side of the vehicle just behind the front bumper is the washer fluid reservoir. The washer pumps (2 - one for the back and one for the front) are located ont the face of the reservoir.

1) Drain the resevoir. (You can reuse this fluid, so put it in a clean container)
2) Disconnect the wiring harness for the problem pump.
3) Remove the sprayer line.
4) Remove the pump. It is held in by being snapped into a channel on the resevoir and by the rubber grommet. This may take some elbow grease.
5) Remove the old grommet.(If your new pump came with a new grommet)

Installation is reverse. Usually new pumps come with new grommets. If not, it is ok to reuse the old one.

Jan 25, 2010 | 2000 Nissan Xterra

2 Answers

What fuse controls the windshield washer pump? on a 2001 Jeep Che


usually it's in the washer bottle which is usually in the fender well, ahrd to get to.
The fuse that controls it should be listed in your owners manual. Usually a 10 amp fuse in the fuse panel inside the car usually on the instrument panel somewhere.

Jan 09, 2009 | 2001 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

723 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...