Question about Cars & Trucks
Which motor do you have? i typically go on Autozone.com to help with locating parts. Start a free account, then add a vehicle. i looked on there and with the 3.8l there are 5 different sensors. hope this helps you.
Posted on Jan 06, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2002 monte carlo ss
The fuel filter is located in the pressure line that runs from the fuel tank to the engine,
near to the fuel tank.
Keep the engine off for few hours before replacing the filter, to get rid of some pressure in the lines.
Posted on Feb 27, 2009
It's should be a simple remove and replace. Just make sure the engine is off. Also do not touch any of the filament wires on the sensor, just the plastic housing. Also after you install it drive the car for a little while (city speeds, cruising speeds and inbetween). That way the computer will be able to readjust its setting since it is a new sensor.
Posted on Apr 02, 2009
I believe, depending on the engine...you have 3 O2 sensors in the exhaust stream. Do NOT go to the Chevy Dealer for repair...instead find a good local mechanic and save approx $150
Posted on Jun 26, 2009
For the bank 0 (the engine one) Undo the dogbones holding the engine from rocking and push the car forward until it stops, then set the parking brake. With the car COLD, spray the sensor down with PB Blaster and tap it (TAP, not smack) and wait a bit, then use your O2 removal socket to pop it out. Put the new one in with a tiny bit of copper antisieze and be EXTREMELY careful not to get any on the head, just the threads - less is more here. Reconnect it, and then hld down the brake and take the parking brake off, then slowly release the brake to let the engine rock back. Reconnect the dogbones and you're all set.
For the Bank 1 (post cat), lift 1 side of the car and set it on stands, and chock the other wheels, slide under and look after the cat, before the resonator, on the ubend in the exhaust, unplug the sensor and PB blast it a bunch, then use the appropriate wrench. Install the new one with the above instructions.
Posted on Apr 26, 2010
it is on the right side of the engine (drivers side) under the thermostat it may have a silver foil tube that is slid over it as a heat shield to protect it from heat from the crossover exhaust tube.
Posted on Dec 15, 2010
Tips for a great answer:
Apr 30, 2014 | 2006 Saturn Vue
Feb 11, 2013 | 2001 Chevrolet Monte Carlo
Aug 08, 2012 | 2002 Chevrolet Monte Carlo
Feb 28, 2012 | 2003 Chevrolet Monte Carlo
Dec 15, 2010 | 2002 Chevrolet Monte Carlo
Nov 12, 2010 | 2002 Chevrolet Monte Carlo
Oct 16, 2009 | 2002 Chevrolet Monte Carlo
Jun 25, 2009 | 2002 Chevrolet Monte Carlo
Nov 21, 2008 | 2002 Chevrolet Monte Carlo
Sep 26, 2017 | Cars & Trucks
242 people viewed this question
Usually answered in minutes!