Question about Cars & Trucks

Open Question

2004 monte carlo pigtail wires went bad now my heat and a/c doesnt work is this a part i can replace myself

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 341 Answers

SOURCE: no heat on drivers side

look under seat for broken or unplugged wires

Posted on Oct 20, 2008

emissionwiz
  • 75817 Answers

SOURCE: 2004 monte carlo sunroof won't close

THERE IS NO MAN OVERIDE, REMOVE THE DRIVE MOTROR AND THE SUNROOF WILL CLOSE.

Posted on Dec 11, 2008

abauto
  • 353 Answers

SOURCE: need to replace high pressure power steering hose

Power Steering Line/Hose: Service and Repair
Pressure Hose
Power Steering Pressure Pipe/Hose Replacement (3.8L)
Removal Procedure
1. Place a drain pan under the vehicle.
2. Remove the accessory drive belt.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
4. Remove the tire and wheel assembly.
5. The power steering pressure hose is the lower hose at the power steering gear.
Remove the power steering pressure hose from the power steering gear.
6. Remove the power steering pressure hose from the power steering pump.
7. Remove the power steering pressure hose from the clamps on the power steering gear.
8. Remove the power steering pressure hose from the vehicle.
Installation Procedure
1. Install the power steering pressure hose to the vehicle.
2. Install the power steering pressure hose to the clamps on the power steering gear.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the power steering pressure hose to the power steering pump.
^ Tighten the fitting to 27 Nm (20 ft. lbs.).
4. Install the power steering pressure hose to the power steering gear.
^ Tighten the pressure hose fitting to 27 Nm (20 ft. lbs.).
5. Install the tire and wheel assembly.
6. Remove the drain pan from under the vehicle.
7. Lower the vehicle.
8. Install the accessory drive belt.
9. Fill the power steering system with power steering fluid.
10. Bleed the power steering system.
11. Inspect the power steering system for leaks.

00d203e.jpg

Posted on Sep 15, 2009

carfreakt
  • 68 Answers

SOURCE: need to replace water pump 2004 Chev Monte Carlo

ok take the belt off take the hose off the pump catch the antifreeze take the bolts off the pump clean off the old gasket off the engine and install new pump and gasket reinstall hoses and bolts anrefill with anti freeze and reinstall belt start it and make sure it does not leak
good luck

Posted on Oct 05, 2009

techbuster
  • 5081 Answers

SOURCE: replacing heater core on 2004 monte carlo

REMOVAL PROCEDURE 1. Remove the fuel injector sight shield. 2. Drain the cooling system. Refer to Draining and Filling Cooling System in Cooling System. 3. Use J 38185 in order to position aside the heater hose inlet and outlet clamps at the heater core. 4. Disconnect the inlet and outlet heater hose from the heater core. 5. Remove the RH Instrument Panel Closeout/Insulator panel. 6. Remove the LH Instrument Panel Closeout/Insulator panel 7. Remove the floor carpet. 8. Remove the rear floor air outlet duct from the holes in the floor reinforcement. 9. Disconnect the rear floor air outlet duct from the heater air outlet cover. 10. Remove the rear floor air outlet duct. 11. Remove the heater air outlet cover screws (2). 12. Remove the heater air outlet cover heat stakes (1) with a small chisel. 13. Remove the heater air outlet cover from the HVAC module assembly. 14. Remove the heater core cover screws (2). 15. Remove the heater core cover heat stakes (1) with a small chisel. 16. Remove the heater core cover from the HVAC module assembly. 17. Remove the heater core from the HVAC module assembly. 18. Remove the heater core foam seal (1) from the HVAC module assembly

Posted on Nov 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Door ajar light wont go off


I had the same thing happen on my 1995 Monte Carlo it turned out that my door hinges on the driver side were bad maybe your having the same issue once i replaced the hinges the light went out hope this helps good luck

Dec 26, 2013 | 2004 Chevrolet Monte Carlo

1 Answer

2004 Monte Carlo Heat/AC doesn't work properly.


THE SMALL RESISTOR MOUNTED ON THE SIDE OF THE BLOWER MOTOR UNDER THE DASH.IF THAT FAILS THEN YOU HAVE A BAD CONNECTION AT THE BLOWER MOTOR PLUG.

Jun 11, 2012 | 2004 Chevrolet Monte Carlo

1 Answer

I have a 2004 monte carlo and my driver side heat does not work it blows out cold air even when the control switch is on the heat my passenger side works fine


Hello and welcome. this is caused by a bad temp door actuator for the drivers temp door. you will need to replace the drivers temp door actuator. this is a electric motor that moves the temp door from cold to hot and hot to cold

Oct 23, 2010 | 2004 Chevrolet Monte Carlo

1 Answer

2002 monte carlo fuel gauge doesnt work,pump works ok.


It is likely the fuel level sending unit. I had a customer with an 03 Monte Carlo that the pump went out and the fuel gauge hadn't worked in about a year. We replaced the fuel pump module and it took care of both problems. I believe the sending unit is available separately from the complete module.

Jan 10, 2010 | 2002 Chevrolet Monte Carlo

1 Answer

Electrical, wiring ?


you better test these two switches to be sure they are bad, as well as the motor. if you have an old battery that is sufficient to operate the motor alone for testing. test each switch with a continuity tester --- if they are both bad you probably have a wiring problem --- make sure there is nothing binding the window mechanism.

Jun 20, 2009 | 2002 Chevrolet Monte Carlo

1 Answer

No heat on drivers side


look under seat for broken or unplugged wires

Oct 19, 2008 | 2004 Chevrolet Monte Carlo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...